Résumé du contenu de la page N° 1
SHIFT_performance
QUICKREFERENCEGUIDE
2009ROGUE
Résumé du contenu de la page N° 2
TRIPCOMPUTER HEADLIGHTANDTURNSIGNAL CRUISECONTROL HOODRELEASE* CONTROL LOWTIREPRESSUREWARNING PADDLESHIFTERS HEADLIGHTAIMINGCONTROL AUDIOSYSTEM LIGHT INSTRUMENTBRIGHTNESS WINDSHIELDWIPER/WASHER AWDLOCKSWITCH AUXILIARYINPUTJACK* CONTROL* SWITCH TRIPCHANGEBUTTON STEERINGWHEELSWITCHESFOR VEHICLEDYNAMICCONTROL(VDC) MANUALCLIMATECONTROL AUDIOCONTROL/BLUETOOTH OFFSWITCH STEERINGWHEELTILT FRONTPASSENGERAIRBAG ADJUSTMENT* STATUSLIGHT *SeeyourOwner’sManualformoreinformation.
Résumé du contenu de la page N° 3
Remote Keyless Entry System (if so equipped)................2 TM NISSAN Intelligent Key (if so equipped) ..................2 Automatic Door Locks..............................3 Windshield Wiper/Washer Switch.......................4 Headlight and Turn Signal Control.......................4 Headlight Aiming Control Switch (if so equipped)..............5 Steering Wheel Switches for Audio Control/Bluetooth (if so equipped)..................................5 Cruise Control...........................
Résumé du contenu de la page N° 4
REMOTE KEYLESS ENTRY SYSTEM (if so equipped) LOCK DOORS Press the button to lock all doors. UNLOCK DOORS Press the button once to unlock the driver’s door only.Pressthebuttonagainwithin5secondstounlock all doors. USING THE PANIC ALARM Press and hold the button for longer than 0.5 sec- onds.Thepanicalarmwillsoundandtheheadlightswill stay on for 25 seconds. The panic alarm stops when it has run for 25 seconds or when any button is pressed on the keyfob. SILENCING THE HORN BEEP FEATURE To deactiv
Résumé du contenu de la page N° 5
STARTING THE ENGINE Push the ignition knob in. ConfirmtheIntelligentKeysystemwarninglightisilluminated green. Turn the ignition knob to the START position to start the engine. TURNING THE ENGINE OFF Shift the transmission into P (Park). Turn the ignition knob to the LOCK position. Anaudiblewarningchimewillsoundwhenexitingthevehicleiftheignitionknobisnot completely turned to the OFF position. AUTOMATIC DOOR LOCKS All doors lock automatically when the vehicle speed reaches 15 MPH (24
Résumé du contenu de la page N° 6
WINDSHIELD WIPER/WASHER SWITCH The ignition switch must be in the ON position to activate the windshield wipers. Move the lever to the following positions to oper- ate the windshield wipers: Intermittent (INT) – Front wipers operate intermittentlyandcanbefurtheradjustedby twisting the time control ring . Low Speed (LO) – Continuous low-speed operation of front wipers. High Speed (HI) – Continuous high-speed operation of front wipers. Mist(MIST) – Lift the lever up for one sweep of the front
Résumé du contenu de la page N° 7
HIGH BEAM Push the headlight control switch forward to select the high beam function. The blue indi- cator light illuminates. Pull the headlight switch backtotheoriginalpositiontoselectthelowbeam. The blue indicator light goes off. Pull and release the headlight control switch to flash the headlight high beams on and off. HEADLIGHT AIMING CONTROL SWITCH (if so equipped) Depending on the number of occupants in the vehicle and the load it is carrying,theheadlightsmaybeaimedhigherthandesired.If
Résumé du contenu de la page N° 8
CRUISE CONTROL To activate the cruise control, push theON·OFF switch.Theindicatorlightintheinstrumentpanel will illuminate. To set cruising speed, accelerate the vehicle to thedesiredspeed,pushtheCOAST/SETswitch and release it. The SET indicator light in the instrument panel will illuminate. Toresetatafastercruisingspeed,pushandhold the ACCEL/RES switch. When the vehicle at- tains the speed you desire, release the switch. To reset at a slower cruising speed, push and hold the COAST/SET s
Résumé du contenu de la page N° 9
AIR FLOW CONTROL DIAL Turn the dial to select the following air flow outlets: Air flows from center and side vents with maximum cooling (air conditioning). Air flows from the center and side vents. Air flows from the center, side, and foot vents. Air flows mainly from the foot vent. Air flows from the defroster and foot vents. Air flows mainly from the defroster vents. DEFROSTING/DEFOGGING FRONT AND SIDE WINDOWS Turn the air flow control dial to the front window defroster mode . The A/C automa
Résumé du contenu de la page N° 10
FM/AM/XM* RADIO WITH CD CHANGER (if so equipped) SEEK/TRACK BUTTON Toscanquicklythrougheachbroadcastingstation,presstheSEEK/TRACKbutton. To skip from one track to another on a CD, press theSEEK/TRACK button. TUNE/FF·REW BUTTON To manually tune the radio, press theTUNE/FF·REW button. WhentheTUNE/FF·REWbuttonispressedwhileaCDisplaying,itwillfastforward or rewind. When the button is released, the CD will play at normal speed. EJECT BUTTON EJECTASINGLEDISC-Pressthe buttonforlessthan1.5sec
Résumé du contenu de la page N° 11
AUX BUTTON Press the AUX button to play a compatible device such as an MP3 player when it is plugged into the auxiliary jack (cable not included). NOTE: You may need to adjust the volume on any compatible device plugged into the auxiliary jack to find the most desired sound level of the audio system. RADIO BUTTON Pressing the RADIO button will change the band to either FM, AM, or XM radio stations. CD BUTTON Press theCD button to play a CD loaded into the CD changer. PRESET A·B·C BUTTON Press t
Résumé du contenu de la page N° 12
CLOCK SET/ADJUSTMENT Press and hold theCLOCK button for approximately 2 seconds. The display will show “H-Seek M-Tune.” Press theSEEK/TRACK button to adjust the hours. Press theTUNE/FF·REW button to adjust the minutes. Press theCLOCK button again to exit the clock set mode. VEHICLE INFORMATION DISPLAY WhentheignitionswitchisturnedtotheONposition,thevehicle information display shows the following information. Outside air temperature (if so equipped) Shift range position indicator
Résumé du contenu de la page N° 13
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) TheCVTdoesnotproduceagearchangesensation like traditional automatic transmissions. The transmission in your vehicle requires a special fluid available only at your NISSAN dealer. No other fluid will meet the exact requirements of the CVT. OVERDRIVE (O/D) OFF SWITCH (if so equipped) Eachtimeyourvehicleisstarted,thetransmissionis automatically “reset”to Overdrive on. To turn Overdrive mode off, push the O/D OFF switch . The O/D OFF light in the inst
Résumé du contenu de la page N° 14
AWD LOCK SWITCH (if so equipped) Each time you push the lower part of the AWD LOCK switch, the AWD mode will switch as follows: AUTO→ LOCK→ AUTO. SelectAUTOorLOCKmode,dependingonthedrivingconditions. LOCK MODE: ● For driving on rough roads. ● PushthelowerpartoftheAWDLOCKswitchwhenthevehicleisstoppedordriving less than 6 MPH (10 km/h). The AWD LOCK indicator light in the instrument panel will illuminate. ● LOCKmodewillchangetoAUTOmodeautomaticallywhenthevehiclespeedisover approximately 6 MP
Résumé du contenu de la page N° 15
When the front passenger’s seat is occupied and the passenger meets the conditions outlined in the Owner’s Manual, the will not illuminate to indicate that the front passenger air bag is operational. *When the system detects that the front passenger’s seat is unoccupied, the passengerairbagstatuslightwillnotilluminateeventhoughthefrontpassenger air bag is OFF. TIRE PRESSURE MONITORING SYSTEM (TPMS) This system monitors tire pressure. If the low tire pressure warning light illuminates, check th
Résumé du contenu de la page N° 16
MOONROOF CONTROLS (if so equipped) The ignition switch must be in the ON position to operate the moonroof controls. TILTING THE MOONROOF To tilt the moonroof up, first close the moonroof by pushingtheswitchtowardUP/CLOSE .Release theswitch,thenpushtheUP/CLOSEswitchagainto tilt the moonroof up. To tilt the moonroof down, push the switch towardDOWN/OPEN . SLIDING THE MOONROOF To fully open the moonroof, push the switch towardDOWN/OPEN . To open the moonroofpartway,pushtheswitchinanydirection
Résumé du contenu de la page N° 17
Pull up or press down on the rear of the control lever to raise or lower the rear portion of the driver’s seat cushion. RECLINING Push the switch forward to move the seatback forward; pull it back to move the seatback backward. LUMBAR SUPPORT (driver’s seat, if so equipped) Push the adjusting lever/switch repeatedly to adjust the lumbar support. FOLDING THE FRONT PASSENGER SEAT DOWN (if so equipped) To fold the front passenger’s seatback down for extrastoragelengthwhentransportinglongitems
Résumé du contenu de la page N° 18
NOTE: Garage door openers (manufactured after 1996) have “rolling code pro- tection”. To program a garage door opener equipped with “rolling code protec- tion”,youwillneedtousealaddertogetuptothegaragedooropenermotorto be able to access the “smart”or “learn”program button. PROGRAMMING YOUR HOMELINK UNIVERSAL TRANSCEIVER (Mirror, Sun Visor or Overhead Console) 1. To begin, press and hold the two outer HomeLink buttons (to clear thememory)untiltheindicatorlight blinks slowly (after 20 seconds).
Résumé du contenu de la page N° 19
BLUETOOTH HANDS-FREE PHONE SYSTEM (if so equipped) With an overhead microphone and sound transmitted through the audio system speaker, the Bluetooth Hands-Free Phone SystemutilizesBluetoothwirelesstechnol- ogyandvoicerecognitiontoprovidehands- free cellular phone communication. SYSTEM OPERATING TIPS Close all windows. Surrounding noises mayinterferewithsystemoperationand performance. Press the button on the steering wheel to activate voice recognition. Wait for the tone before speaking.
Résumé du contenu de la page N° 20
PAIRING PROCEDURE NOTE: The vehicle must be stationary when pairing the phone. 1. Press the button on the steering wheel and wait for the tone. 2. Say “Setup”. 3. Wait for the tone, then say “Pair phone”. 4. Wait for the tone, then say “New phone”. 5. Initiate pairing from the phone. The pairing procedure varies according to each cellular phone model. For detailed pairing instructions and a list of compatible phones, please visit www.nissanusa.com/bluetooth . WhenpromptedforaPASSKEYcode,ente
