Résumé du contenu de la page N° 1
Backup Sensors Owner’s Manual
© 2002 American Honda Motor Co., Inc. - All Rights Reserved. 1
MDX
Résumé du contenu de la page N° 2
Contents Introduction........................................................................................................... 3 Important Information........................................................................................... 4 How the Backup Sensors Work ............................................................................ 5 Limitations ............................................................................................................ 7 Operation...............
Résumé du contenu de la page N° 3
Introduction Thank you for purchasing this Acura accessory. Please read this Owner’s Manual carefully before using the backup sensors, and keep this manual in the glove box for future reference. This product is designed to be used exclusively on a Acura MDX. Acura is not responsible if the unit is used for any other intended purpose. This Owner’s Manual should be considered a permanent part of the the vehicle. It should remain with the vehicle at all times and stay with the vehicle when sold. Th
Résumé du contenu de la page N° 4
Important Information Before using the backup sensors, make sure you read and understand the operation and limitations of the system as discussed below and elsewhere in this manual. The backup sensors are designed to provide and audible sound when the y detect large stationary objects while the vehicle is moving in reverse at low speed. However, the system may not detect all possible objects depending on their size, shape, or location. Even with the backup sensors, the driver is still respon
Résumé du contenu de la page N° 5
How the Backup Sensors Work Backup Sensors The sensors are designed to give you an audible signal when the rear bumper of your vehicle is The sensors are ready for operation when the shift approaching an obstacle. lever is moved to the reverse position with the The audible signal has three sounds: backup sensor switch turned ON. Sound Corner Sensors Center Sensors (Tone Quality) (High) (Low) Operation of the sensors is dependent upon the Slow intermittent ultrasonic waves they emit. They calcu
Résumé du contenu de la page N° 6
How the Backup Sensors Work Corner Sensors: The sensors detect the closest The sensors may not detect the rear obstacle. rear bumper of tall vehicles. In this example, the corner sensor detects the side wall. Center Sensors: When towing a trailer, the audible signal may keep sounding if the shift lever is moved to the reverse position. When this occurs, turn the backup sensor switch OFF. 6 © 2002 American Honda Motor Co., Inc. - All Rights Reserved.
Résumé du contenu de la page N° 7
Limitations The sensors detect only the closest obstacle. The The sensors may not work if the obstacle is an odd sensors may detect other obstacles as the vehicle shape or made of material that does not reflect moves. ultrasonic waves. Examples: POLE SMALL or SLENDER TREE CARDBOARD TIRE of CARTON BICYCLE RECTANGULAR The sensors may not work if the ambient air LUMBER temperature is below -4°F (-20°C) or above 122°F (50°C). CURBSTONE © 2002 American Honda Motor Co., Inc. - All Rights Reserved. 7
Résumé du contenu de la page N° 8
Limitations The sensors may not sound for the following Objects that absorb ultrasonic waves, such as obstacles or under the following conditions: soft snow, cotton and sponges Piece of wire, rope, and net fence The audible signal may sound warning even if there is no obstacle behind the vehicle: Droplets of water frozen on the sensor Objects low in height such as curbstone, etc. 8 © 2002 American Honda Motor Co., Inc. - All Rights Reserved.
Résumé du contenu de la page N° 9
Limitations The audible signal may sound warning even if When the vehicle is equipped with a high- there is no obstacle behind the vehicle: power radio and antenna Sensors clogged with snow, dirt or mud When detecting loud noises such as a vehicle horn, a motorcycle’s engine, or air brakes The sensors may sound continuously under the following conditions: When driving on rough surfaces or gravel roads or in grass, or when stopped on a hill When driving in rain or melted snow © 2002 Ame
Résumé du contenu de la page N° 10
Operation Before using the backup sensors, become familiar 3. Turn the backup sensor switch ON. with the types of sounds in relation to the distances between the sensors and the obstacle by actually backing your vehicle into a garage or parking space. Also confirm the obstacle detecting range of each ON backup sensor. RIGHT QUARTER 1. Check that the parking brake is applied. PILLAR TRIM 2. Turn the ignition switch ON (II). Do not start the engine yet. ON 4. Move the shift lever to reverse. 10 ©
Résumé du contenu de la page N° 11
Operation 5. From behind the vehicle, check that the 6. Check that the intermittent warning beeps audible signal sounds by slowly bringing the become quicker as you bring the palm of palm of your hand close to each sensor as your hand closer to the sensor. described: For the corner sensors: About 1.5 feet For the corner sensors: From 2 feet For the center sensors: About 4 feet For the center sensors: From 6 feet 7. Check that the intermittent warning beeps Confirm that the sound of the corner ar
Résumé du contenu de la page N° 12
Daily Inspection 1. Start the engine. 2. Apply the parking brake, and depress the brake pedal. Move the shift lever to the reverse position. Check that the audible signal sounds for about one second. The sensors are normal if the audible signal sounds for about one second. If the audible signal keeps sounding, this is an indication that the sensors are frozen or clogged with mud, dirt, etc. The sensors will also keep sounding when there is an abnormality in the circuit. 12 © 2002 American
Résumé du contenu de la page N° 13
Care of the Backup Sensors Wipe the sensors clean with a clean cloth, or flush Do not direct high-pressure water against the with low-pressure water when the sensors are sensors. clogged with mud and dirt. LOW-PRESSURE WATER HIGH- PRESSURE WATER (Do not use.) © 2002 American Honda Motor Co., Inc. - All Rights Reserved. 13
Résumé du contenu de la page N° 14
Troubleshooting Perform the following checks if the audible signal Take your vehicle to your Acura dealer if you does not sound when the vehicle is approaching an encounter either of these problems: obstacle. The audible signal sounds continuously when the shift lever is in the reverse position, and Symptom Remedy the sensors are not frozen or clogged with Clogged sensor Wipe with clean cloth or flush snow or mud. with snow or mud with low-pressure water. Frozen sensor Melt with
Résumé du contenu de la page N° 15
Troubleshooting Troubleshooting With Beeps Corner Sensors Series of two intermittent beeps: right sensor is faulty. Series of three intermittent beeps: left sensor is faulty. Series of four intermittent beeps: right and left sensors are faulty. Center Sensors Series of three beeps: either or both sensors are faulty. Be careful not to confuse the sound of the sensors with those of other components or systems. © 2002 American Honda Motor Co., Inc. - All Rights Reserved. 15
Résumé du contenu de la page N° 16
16 08V67-S3V-2000-81 © 2002 American Honda Motor Co., Inc - All Rights Reserved. © 2002 American Honda Motor Co., Inc. - All Rights Reser Printed in Japan ved.
