Résumé du contenu de la page N° 1
TABLE OF CONTENTS
INTRODUCTION 3
PRODUCT OVERVIEW 4
BEFORE YOU BEGIN 8
BATTERY INSTALLATION 9
LOW BATTERY WARNING 9
GETTING STARTED 10
PLACEMENT OF THE UNITS 10
REMOTE AND INDOOR TEMPERATURE 10
MAXIMUM AND MINIMUM READINGS 11
LOST COMMUNICATION 11
TRANSMISSION COLLISION 12
CALENDAR AND CLOCK DISPLAY MODES 12
MANUAL SETTINGS 12
CLOCK ALARMS 13
Honeywell
SNOOZE 14
Wireless In/Out Thermometer
PRECAUTIONS 15
TROUBLESHOOTING 15
SPECIFICATIONS 16
FCC ST
Résumé du contenu de la page N° 2
INTRODUCTION PRODUCT OVERVIEW Thank you for selecting the Honeywell Wireless In/Out Thermometer. This MAIN UNIT device combines precise time keeping with temperature monitoring features. FEATURES In this package you will find: • Precise Quartz Clock • One main unit (receiver) • 12 or 24 hours Time Format • One remote sensor (transmitter) TS03 • Dual crescendo Time Alarm with Snooze • One User Manual • Day of the week displayed in English, Spanish, French, German and Please keep this
Résumé du contenu de la page N° 3
FRONT/REAR VIEW B. SNOOZE button • Stops the clock’s alarm temporarily H B C. UP ( ▲) button • Increases the parameters • Enables time alarms (W) and (S) and Ice Warning Alarm D. MODE button A • Toggles between time modes - time with seconds and time with the day of the week • Activates clock’s programming mode E. DOWN ( ▼) button G • Decreases the parameters D • Activates manual remote channel search • Disables time alarms (W) and (S) and Ice Warning Alarm F. ALARM ON/OFF but
Résumé du contenu de la page N° 4
REMOTE SENSOR BEFORE YOU BEGIN FEATURES • We recommend using alkaline batteries for the remote sensor and main unit when temperatures are above 32°F (0°C). We recommend • Remote temperature transmission to the main unit via 433 MHz frequency using lithium batteries for the remote sensor when temperatures are below 32°F (0°C). • Case can be wall mounted using built-in hanger • Selection of the temperature display in Celsius or Fahrenheit • Avoid using rechargeable batteries. (Rechargeable
Résumé du contenu de la page N° 5
away from direct sunlight, rain or snow. The best suggested location for the GETTING STARTED remote sensor for outdoors is under the eave on the north side of the building. WEATHER DISPLAY NOTE: When the temperature falls below freezing, the batteries in the After batteries are installed; remote sensor will transmit temperature data at 45 outdoor remote sensor may have reduced voltage supply and a shorter second intervals. The main unit may take up to two minutes to receive the initial eff
Résumé du contenu de la page N° 6
The indoor temperature with the icon IN is located below the remote • Remove four (4) small screws from the back of the remote sensor with temperature information line. small Phillips screwdriver, and open the battery compartment. NOTE: If the indoor or remote temperature goes above or below operating • Remove the batteries from the battery compartment and reinstall them range stated in specifications, the main unit’s display will show dashes “- - -” on in the same manner. Remote sensor LE
Résumé du contenu de la page N° 7
time will be set • Press MODE for the last time to return to the default mode (time of day with seconds) after the last parameter is set. • Set Single (S) day alarm if desired in the same manner SETTING THE ICE WARNING ALARM (PRE-AL) CLOCK ALARMS The Personal Weather Station has two time alarms – Weekday alarm (W) and If Weekday (W) or Single day (S) alarm is set, the Ice Warning Alarm (Pre-AL) Single day alarm(S) - and one Ice Warning Alarm (PRE-AL). can be programmed. • If Weekday
Résumé du contenu de la page N° 8
PRECAUTIONS SPECIFICATIONS This product is engineered to give you years of satisfactory service if handled Main Unit Indoor Temperature carefully. Here are a few precautions: Proposed operating range: 23.0°F to 122.0°F (-5°C to +50°C) • Do not immerse the units in water. Temperature resolution: 0.2°F (0.1°C) User-selectable (°F or °C) temperature display • Do not clean the units with abrasive or corrosive materials. They may Maximum number of remote sensors: 1 (one included) scratch th
Résumé du contenu de la page N° 9
FCC STATEMENT DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is subject to the We following two conditions: (1) This device may not cause harmful interference, Name: Hideki Electronics, Inc. and (2) This device must accept any interference received, including Address: 7865 SW Mohawk interference that may cause undesired operation. Tualatin, OR 97062 Warning: Changes or modification to this unit not expressly approved by the declare that the
Résumé du contenu de la page N° 10
STANDARD WARRANTY INFORMATION This product is warranted from manufacturing defects for one year from date of retail purchase. It does not cover damages or wear resulting from accident, misuse, abuse, commercial use, or unauthorized adjustment and repair. Note that online product registration is required to ensure valid warranty protection. To register your product, go to our Company website at: www.honeywellweatherstations.com. Click Online Product Registration under the Customer Service
