Instruction d'utilisation Sony XP-SR320

Résumé du contenu de la page N° 1

Highlighted letters in the text of this manual correspond to the illustrations.
PRECAUTIONS
To maintain good performance
• Do not use the unit in places which are extremely hot, cold, dusty or humid. In
particular, do not use or keep the unit in following places.
• in a high humidity area such as a bathroom
XP-SR321/XP-SR320
• near a heater
• in an area exposed to direct sunlight (e.g., inside a parked car, where it can
COMPACT DISC PLAYER
become extremely hot)
• near sources of strong magnetism

Résumé du contenu de la page N° 2

Stereo headphones (1) C 1 Carrying case (XP-SR321 only) (1) AC adaptor AC-D603U Rated input: AC 120 V, 60 Hz The specifications and external appearance of this unit are subject to change without notice. USING ON DRY CELL BATTERIES → C 1 Set the dial to the OPEN position to open the disc compartment, then open the battery compartment. 2 Insert two size AA (LR6) alkaline batteries with the 0 and 9 marks correctly aligned. After batteries insertion, close the battery compartment firmly. 23 3 Close

Résumé du contenu de la page N° 3

USING ON RECHARGEABLE BATTERIES → E E12 • Be sure to use size AA Ni-Cd 1.2 V 700 mAh rechargeable batteries, which are commercially available. • Be sure to read the instructions of the purchased rechargeable batteries before use. • When using on rechargeable batteries for the first time, charge them until the battery indicator goes out. • Before charging the batteries, close the disc compartment. You cannot charge the batteries while it is opened. 1 Insert the rechargeable batteries with the 0

Résumé du contenu de la page N° 4

Press to decrease the volume. DSL Press DSL repeatedly for more powerful sound and deeper bass. : Deep bass is emphasized. : Deep bass is strongly emphasized. : Normal sound I Signal sound function You can check the operation by beep sound when you press an operation button. The signal sound function is activated when you purchase this unit. To cancel the signal sound function, press ePLAY/PAUSE while pressing PLAY MODE to display “ ” while the power is off. To resume the beep sound, repeat thi

Résumé du contenu de la page N° 5

PLAYBACK → J STOP/OFF J Pull out the rubber cap and connect the supplied headphones to the PHONES/ CHARGE LINE OUT jack. The amplified speaker system can be connected instead to enjoy the CD sound. 3 1 1 Release HOLD. 2 Place a disc. 3 Press ePLAY/PAUSE. Playback starts from the first track. 2 a track number b elapsed playing time c volume indicator PHONES/ LINE OUT Basic operation To stop Press sSTOP/OFF/CHARGE. To pause Press ePLAY/PAUSE. 12 To resume, press it again. To search for the beginni

Résumé du contenu de la page N° 6

Repeat play → M PLAY MODE Press PLAY MODE during playback to select repeat play as follows. : one-track repeatB V : all-track repeat V no repeat play (normal play) Note N STOP/OFF When the unit is set to E•A•S•S-12 or -48 second mode, if PLAY MODE is pressed 1,3 CHARGE at the end of the track to select the other play mode, the unit may not change to the other mode properly. 5 2 PROGRAM PLAY → N Up to 24 tracks can be chosen for program play. 1 Press ENTER/DISP while in standby mode to display “P

Résumé du contenu de la page N° 7

RADIO RECEPTION O MONO/ST STOP/OFF Tuning in to a station → O CHARGE 1 Press BAND TUNER ON repeatedly to select AM or FM. 2 Press TUNING + (t) or - (r) to tune in to a station. 1 After listening, press sSTOP/OFF/CHARGE to turn off the radio. 2 For quick tuning Keep either TUNING + (t) or - (r) pressed for about 1 second. When a station is tuned in to, the frequency stops automatically. However, it does not stop if the broadcast signal is weak. For better reception → P BAND/ 1 FM: The headphone

Résumé du contenu de la page N° 8

to tune in to a station. 4 Press ENTER/DISP to preset the station on the selected preset number. If the flashing stops, repeat the procedure from step 2. BAND/ 12 TUNER ON Erasing the presettings one by one Press sSTOP/OFF/CHARGE after step 2 in “Changing the presetting” above. Each preset station is erased. All the settings move up by ones and the preset numbers are refreshed. Erasing all of the presetting 3 ENTER/DISP Keep ENTER/DISP pressed, then press BAND TUNER ON when the frequency and pre