Instruction d'utilisation Zephyr ARC Z1C-00SL

Résumé du contenu de la page N° 1

customer service
1.888.880.8368
Duct Cover Extension
Z1C-00SL
For use with Surface Is. range hood
Mounting the duct cover Pag. 4
Fixation des cheminees Pag. 6
Fijación de las chimeneas Pag. 8
Fissaggio dei camini Pag. 10

Résumé du contenu de la page N° 2

www.zephyronline.com DUCT COVER EXTENSION SPECIFICATION - 2 -    

Résumé du contenu de la page N° 3

MOUNTING THE DUCT COVER 1. Before installing the duct cover extension kit, take out the duct cover ceiling bra- cket fom the range hood packaging and remove the bracket by unscrewing the (4) screws. 2. Remove the duct cover from the hood assembly, according to the following steps: A - Take out the lower mantle by removing the (7) screws. Fig. 1 B - Take out the spacer, by removing the (6) plus (4) metric screws and the bushes. Fig. 2 C - Take out the two additional bushes that secure the gl

Résumé du contenu de la page N° 4

www.zephyronline.com 4. Remove the (2) screws to unlock the top support frame from the bottom support frame. Fig.4. 5. Secure the top support frame to the duct cover ceiling bracket by using the (4) screws. Fig. 5 6. Position hole template on the ceiling paying attention that the arrow is positioned on the same side as the range hood controls. - Make 4 holes in the ceiling and drive in (3) screws without completely tightening them. Pay attention not to insert the screw into the hole mar

Résumé du contenu de la page N° 5

Adjust height by referring to the diagram in fi g.8. Secure the support frames together using (2) screws per extension arm (8 total). Fig.9 9. Insert the motor housing into the support frame assembly and secure it using (8) screws. Fig.10 10. Connect the equipment to the power supply. 11. Secure the correct size ducting for your instal- lation (not supplied) to the collar on top of the housing. Fig.11 12. Extend upper duct cover to the ceiling and secure it to the duct cover ceiling brack

Résumé du contenu de la page N° 6

3FA0174