Résumé du contenu de la page N° 1
Operating and Installation
Instructions
Ventilation System
DA 5000 D
To prevent accidents en - US, CA
and machine damage,
read these instructions
before
installation or use. M.-Nr. 07 197 930
Résumé du contenu de la page N° 2
2
Résumé du contenu de la page N° 3
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Functional description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Turning on the fan s......................
Résumé du contenu de la page N° 4
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent ~ This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is ~ appliance only for its intended properly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by imprope
Résumé du contenu de la page N° 5
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use ~ maritime use or for use in mobile Do not allow children to play with or ~ installations such as recreational operate the appliance or its controls. vehicles or aircraft. However, under Supervise use by the elderly or infirm. certain conditions it may be possible for an installation in these applications. Do not flambé or grill with an open ~ Please contact the nearest Miele dealer flame beneath the hood. or the Miele Technica
Résumé du contenu de la page N° 6
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS, IN THE EVENT OF A GREASE FIRE: COOKTOP GREASE FIRE, OBSERVE Never leave surface units ~ THE FOLLOWING: unattended at high settings. Boil-overs SMOTHER FLAMES with a close ~ cause smoking and greasy spillovers fitting lid, cookie sheet, or metal tray may ignite. Heat oils slowly on low or then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn th
Résumé du contenu de la page N° 7
IMPORTANT SAFETY INSTRUCTIONS Installation Never connect an exhaust hood to ~ an active chimney, dryer vent, vent flue, , WARNING ~ or room ventilating duct work. Seek To reduce the risk of fire only use professional advice before connecting metal duct work. an exhaust hood vent to an existing, Any fittings, sealant, or materials inactive chimney or vent flue. ~ used to install the duct work must be Ducted fans must always be vented ~ made of approved non-flammable outdoors. materials. Make sure
Résumé du contenu de la page N° 8
Guide to the appliance 8
Résumé du contenu de la page N° 9
Guide to the appliance a Covering frame Sensor buttons b Chimney h Indirect lighting c Canopy i Direct lighting The canopy opens as soon as the fan is Use this button to switch the direct turned on. lighting On/Off, and to adjust the brightness. d Indirect lighting The lighting can be used independently e Control panel from the fan. The symbols serve as sensor buttons. j Fan On/Off To select a function, touch the sensor button. A brief tone is heard as k Fan power selection confirmation. l Delay
Résumé du contenu de la page N° 10
Functional description The ventilation hood works by air extraction. The air is drawn in and cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. 10
Résumé du contenu de la page N° 11
Operation Turning on the fan s Automatically switching back the intensive setting ^ Touch the "s" sensor button. The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Turn off the fan and lights. ^ Press and hold the "5m15" sensor button for approx. 10 seconds, until the sensor button "1" lights up. ^ Press the following buttons one after The fan switches on to level "2". another, The sensor buttons "s" and "2" light. – the "n" sensor button, The
Résumé du contenu de la page N° 12
Operation Delayed shut down "5m15" Direct lighting n If odors or smoke remain in the kitchen The lighting can be used independently after cooking has been completed, the from the fan. Delayed Shut Down feature can be selected to allow the hood to continue Direct lighting on running for either 5 or 15 minutes. ^ To turn on, briefly touch the "n" ^ While the fan is still running, touch sensor button. the "5m15" sensor button: The lighting comes on at maximum Press once : the fan automatically brig
Résumé du contenu de la page N° 13
Operation Indirect lighting Checking the grease filter timer Touch the " " sensor button to turn the To check the percentage of time indirect lighting On/Off. already used: ^ Touch the "s" sensor button to turn on the fan. Safety cut-off ^ Hold down the "l" sensor button. If the exhaust hood is left unattended One or more of the sensor buttons for more than 10 hours, the fan "1" to "4" will flash. automatically turns off. The lighting The number of flashing sensor buttons remains on. indicates t
Résumé du contenu de la page N° 14
Operation Reprogramming the grease filter ^ To select a shorter time, touch the timer sensor button "1". To select a longer time, touch the The grease filter timer is preset to 30 sensor button "4". hours. This time can be lengthened or Hold the sensor button until the shortened to 20, 30, 40, or 50 hours desired time is set. depending on your cooking habits. ^ Confirm the process by touching the – A time of 20 hours should be "l" button. programmed in kitchens with frequent pan or deep frying.
Résumé du contenu de la page N° 15
Cleaning and care Avoid: Before cleaning or servicing the – cleaning agents containing soda, hood, disconnect it from the power acids or chlorides, supply by either removing the fuse, unplugging it from the outlet, or – abrasive cleaning agents, manually "tripping" the circuit e.g. powder or cream cleansers, breaker. – abrasive sponges, i.e. pot scourers or sponges which have been Cleaning the casing previously used with abrasive cleaning agents. Warning: Never use abrasive cleaners, scouring pa
Résumé du contenu de la page N° 16
Cleaning and care Grease filter Be sure to support the grease filter The reusable metal grease filters so that it does not fall onto the remove solid particles from the vented cooktop. kitchen air (grease, dust, etc) and help keep the exhaust hood clean. At the latest, clean the grease filter when the "l" sensor button lights up. The grease filters should be cleaned every3-4 weeks or when the grease filter indicator lights. A dirty filter is a fire hazard. To remove the grease filter, first open
Résumé du contenu de la page N° 17
Cleaning and care Re-setting the grease filter Depending on the detergent, timer cleaning the grease filters in a Each time you clean the grease filter dishwasher may cause permanent re-set the counter. discoloration of the filter surface. Performance of the filter is not ^ Touch the "s" sensor button to turn affected by this discoloration. on the fan. ^ Press and hold the "l" sensor button ^ After cleaning, the filters can be for approx. 3 seconds, until only the placed on a towel to air dry. s
Résumé du contenu de la page N° 18
Cleaning and care Changing the halogen light bulbs To change the halogen bulbs, first open the canopy. ^ Touch the "s" sensor button. The fan turns on to level "2". The canopy opens. ^ Press and hold the "2" sensor button for approx. 5 seconds, until the fan turns off. The canopy remains open. Disconnect the exhaust hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. ^ Through the opening above the light, ^ Remove the grease filter f
Résumé du contenu de la page N° 19
Cleaning and care Changing the fluorescent light bulb Disconnect the exhaust hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. To prevent damage to the glass cover and the cooking surface, be ^ Rotate the fluorescent tube sure to securely handle the glass approx. 180° and downward to cover. remove. Use the same type of tube as a replacement. ^ Replace the lighting in the reverse order. ^ Shift the glass cover toward the back slight
Résumé du contenu de la page N° 20
After Sales Service Repairs MieleCare In the event of a fault which you cannot (USA only) easily fix yourself, please contact the MieleCare, our Extended Service Miele Technical Service Department. Contract program, gives you the ^ When contacting Technical Service, assurance of knowing that your please quote the model and serial appliance investment is covered by number of your appliance. 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guara
