Instruction d'utilisation Hotpoint HS73X

Résumé du contenu de la page N° 1

HOTpoint Oven 14-04-2005 8:48 Pagina 1
Instructions
Hood
Morley
Way,
Peterborough,
PE2
9JB,
England
www.hotpoint.co.uk

Résumé du contenu de la page N° 2

Instructions for use HOOD Contents GB GB Installation, 2-3 English Assembly Technical information, 4 Electrical connection Power cable Technical data Description, 5 Filtering version Ducting version Operation, 6 Controls HS 63 X HS 73 X Maintenance,7 HS 93 X Cleaning the hood HSD 93I Cleaning the grease filters Replacing the charcoal filter Replacing the lamps Precautions and tips, 8 General safety Air vent Disposal

Résumé du contenu de la page N° 3

Installation Assembly 6) For the hoods in filtering version, fit the reducer (E). GB Before proceeding with the assembly operations, remove the grease filters so that the hood is easier to handle (for the instructions see the paragraph “Cleaning the grease filters” in the chapter on “Maintenance”). Fixing to the wall 1) Draw a line on the wall along the vertical axis of the hob. Mark the 2 holes (A) to be made in the wall respecting the measurements indicated in the figure below. 2) Drill the ho

Résumé du contenu de la page N° 4

3) Ducting version: d) Make the electrical connection of the hood by GB means of the power cable (refer to the paragraph a) Connect the air vent of the hood to the air vent “Electrical connection”). hole using a flexible hose of 15 cm diameter. e) Lower the lower flue resting it on the hood. Lock the flexible hose with hose clamps (hose f) Check if the charcoal filter (P) has been and clamps not provided). installed. If not yet installed, proceed by sliding b) Make the electrical connection of t

Résumé du contenu de la page N° 5

Technical information Electrical connection GB ! Arrange the electrical power supply within the letter L or coloured red. For hoods in insulation decorative flue dimensions. class 1 (mod.HS63X): – terminal of a three-pin ! When making the electrical connections, check that plug. For hoods in insulation class 1 (Mod. HS73X- the voltage values correspond to those indicated on HS93X-HSD93I): – the wire which is coloured the data plate inside the appliance itself. green and yellow must be connected

Résumé du contenu de la page N° 6

Description The hood may be in the filtering or ducting version. Ducting version GB Decide from the outset which type is to be installed. For better efficiency, we recommend installing the The hood aspirates air from the kitchen impregnated hood in the ducting version (if possible). with fumes and smells, passes it through the grease filters and then expels it to the outside through an exhaust duct. Filtering version For this version the charcoal filter does not need to be used. The hood aspirat

Résumé du contenu de la page N° 7

Operation Controls GB LIGHTING MOTOR DECREASE INCREASE BOOST SPEED Light button Speed increase button Turns the lights on/off. Repeatedly pressing the button will increase the motor speed until reaching the maximum speed (12th speed). Motor button Activates/deactivates the motor. The motor is activated at the last speed set. Boost speed button Activates the motor at boost speed (13th speed) for 10 Speed decrease button minutes, after which the motor goes back to running at Repeatedly pressing t

Résumé du contenu de la page N° 8

Maintenance ! Always switch off the electricity supply before Replacing the charcoal filter GB carrying out any cleaning or servicing operations on the appliance. If using the hood in the filtering version, the charcoal ! To avoid possible risks of fire always comply with filter (P) will periodically have to be replaced. the indicated instructions when cleaning grease First of all, remove the metal grease filters. Push the filters and when removing grease deposits from the catch towards the insi

Résumé du contenu de la page N° 9

Precautions and tips 04307518 General safety Disposal GB ! The distance between the supporting surface for The European Directive 2002/96/EC on Waste the cooking vessels on the hob and the lower part Electrical and Electronic Equipment (WEEE), requires of the hood must be at least 65 cm. that old household electrical appliances must If the instructions for installation for the hob specify not be disposed of in the normal unsorted municipal a greater distance, this has to be taken into account. w