Résumé du contenu de la page N° 1
BAND
AS/PS LOUD
VOL+ MUTE
1 2
CD SEL MONO STEREO REL
CH CH
3 4
VOL- FM1 FM1 BAS BAS
DISP
SCAN 5 6 ® CR560X
®
Installation
How to Install the CR560X AM/FM
Contents
Stereo Radio/Cassette Tape Player
Installation................................... 2
Before You Begin Installation ........ 2
Install
1
half-sleeve
Tools and Supplies Needed ........... 2
(page 5)
Speaker Requirements .................. 2
Adapters for Easier
Installation ..................................... 2
4 Final
Installation
• Con
Résumé du contenu de la page N° 2
® CR560X Installation Before You Begin Installation Before you begin, you will need tools, supplies and adapters. It is best to make sure you have everything you need before you take your dashboard apart. Tools and Supplies Needed Adapters for Easier Installation Basic Installation: Electrical and dashboard adapters make installation easier. Purchase adapters from • Flat and Phillips screwdrivers your local Jensen retailer, electronics store or • Wire cutter car stereo specialty store. • Wire s
Résumé du contenu de la page N° 3
® CR560X Professional Tip Professional Tip Connections Crimp Connections Good wire connections are very important for Purchase crimp connectors and crimping tool. Connectors are color coded. This best sound and long-term reliability. Here are Jensen radio uses RED connectors (18-20 two methods: gauge wire). Splice 1. Strip 1/4 inch (6mm) of insulation from 1. Strip 1/2 inch (12 mm) of insulation from both wires. both wires. 2. Insert into connector. 2. Wrap wires together 3. Crimp tightly. 3. Fo
Résumé du contenu de la page N° 4
CD COMPACT EJECT RGCD400 8 X OVERSAMPLING . . . 4 X 15 WATTS DIGITAL AUDIO VOL BAND CD SEL VOL PWR BASS MO/ST DISP LO/DX INT RPT RDM M APM MUTE BBE LD AP M M CH MUTE BBE LD EJ LOC SEEK A•PS EJ LOC SEEK A•PS ® 4x25W Auto Reverse Jensen Plus Tuner ® 4x25W Auto Reverse Jensen Plus Tuner ® CR560X Disconnect Battery Before you begin, always disconnect the battery negative terminal. Remove Old Radio Your original car radio is installed in one of four ways, depending on the car. Removal Tool Br
Résumé du contenu de la page N° 5
® CR560X Install Half-sleeve Not needed for ISO-DIN (Japanese vehicle) installation. 3 Support Strap (supplied) Half-sleeve (supplied) 1 Adapter (optional) 2 1. Install adapter if necessary. Install half- 2. Bend over tabs where possible to secure sleeve into adapter from front of dash. It half-sleeve to adapter or inside of dash. will be a tight fit. 3. Install strap to strut under dash. Secure strap to an existing screw. Wiring Professional Tip Important If wiring connections are made wrong,
Résumé du contenu de la page N° 6
® CR560X Wiring with a Wiring Adapter This is the easiest wiring method, because it replaces your existing radio. You will have to buy a wire harness adapter from your dealer, a car stereo installation shop or electronics store. If you use a wiring adapter, you can connect all wires to the radio before you even start to take your old radio out. Connect Wires Install Wiring Inside the Car 1. Connect wiring adapter to the car's Splice, crimp or solder the wires from the existing wiring harness. Je
Résumé du contenu de la page N° 7
® CR560X Wiring Diagram–Advanced Installation If you are installing new speakers or amplifiers or replacing an aftermarket installation, use this diagram. Back of Radio Antenna Jack RCA-to-RCA cables Amplifier wiring (not supplied) (See amplifier instructions) Red AMP White Power Antenna Connect to power antenna or ampli- fier. If not used, tape bare end of Dark Blue wire. AMP Turn on for amps Filter Box Ground Connect to ground terminal or clean, Black unpainted metal part of chassis. Memory Co
Résumé du contenu de la page N° 8
® CR560X Testing Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly. Reconnect Battery Test Memory Wiring When wiring is complete, 1. With the radio playing, hold 1 1 reconnect the battery button 1 for two seconds. negative terminal. CH 1 will appear on the display. You just stored the current station in memory. 2. Turn the key off, then turn the key on again. 2 3. The radio should resume playing at the
Résumé du contenu de la page N° 9
® CR560X Test Speaker Connections These tests make sure the speakers are connected right. If speakers don’t play at all, both wires may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear speakers) make sure you connected the wires right. Balance Fader 1. Press SEL four times. 5. Press SEL five times. 5 SEL 1 SEL SEL SEL 2. Hold the + button until SEL 6. Hold the + button until SEL SEL SEL SEL the display shows the display shows BA.r 10. FA.F 10. Only t
Résumé du contenu de la page N° 10
BAND AS/PS LOUD VOL+ MUTE CD 1 2 STEREO REL SEL MONO C CH H 3 4 VOL- DISP FM1 FM1 B BAS AS 5 6 ® SCAN CR560X BAND AS/PS LOUD VOL+ MUTE CD SEL 1 2 STEREO REL MONO C CH H 3 4 FM1 FM1 VOL- DISP BAS BAS 5 6 ® SCAN CR560X ® CR560X Final Installation 1. Slide radio chassis into half-sleeve 2. Secure to strap using nut 3. Install faceplate by fitting left edge into position then pushing right edge closed. 4. Reinstall any items you removed from the dashboard. Nut (supplied) 2 1 3 Final Installation–ISO
Résumé du contenu de la page N° 11
BAND PWR AMS LOUD MUTE VOL+ CD 1 2 STEREO REL SEL MONO CH CH 3 4 VOL- F FM1 M1 B BAS AS DISP 5 6 ® SCAN CR560X ® CR560X Troubleshooting Problem Cause Corrective Action Does not operate (radio No power to red wire (12V with Check connection does not light) key on) Check vehicle fuse Inline fuse blown Replace fuse No speakers operate Speaker wires not connected Connect speaker wires (radio lights normally) Not all speakers operate Incorrect splices or connections Check all splices and connections
Résumé du contenu de la page N° 12
Specifications FM Tuner Tuning range ............................................................................................................................ 87.5 MHz-107.9 MHz FM mono sensitivity ......................................................................................................................................... 12 dBf 50 dB quieting sensitivity (stereo).................................................................................................................... 16
