Résumé du contenu de la page N° 1
ELECTRONIC CASH REGISTER
SE-S6000
SE-C6000
DI CI Canada
USER'S MANUAL
CASIO COMPUTER CO., LTD.
6-2, Hon-machi 1-chome
Shibuya-ku, Tokyo 151-8543, Japan
THANK YOU
YOUR RECEIPT
CALL AGAIN !
GROCERY
DAIRY
H.B.A.
FROZEN
FOOD
DELICATESSEN
Résumé du contenu de la page N° 2
CASIO COMPUTER CO., LTD. 6-2, Hon-machi 1-chome Shibuya-ku, Tokyo 151-8543, Japan
Résumé du contenu de la page N° 3
Introduction & Contents Important! Your new cash register has been carefully tested before shipment to ensure proper operation. Safety devices eliminate worries about breakdowns resulting from operator errors or improper handling. In order to ensure years of trouble-free operation, however, the following points should be noted when handling the cash register. Do not locate the cash register where it will be subjected to direct sunlight, high humidity, splashing with water or other liquids
Résumé du contenu de la page N° 4
Introduction Congratulations on your selection of a CASIO SE-S6000/SE-C6000 electronic cash register. This ECR is the product of the world's most advanced electronic technology, for outstanding versatility and reliability. Simplifi ed operation is made possible by a specially designed keyboard layout and a wide selection of automated, programmable functions. A specially designed keyboard layout and a bright, easy-to-read display help to take the fatigue out of long hours operation. Everythin
Résumé du contenu de la page N° 5
Safety Precautions • To use this product safely and correctly, read this manual thoroughly and operate as instructed. After reading this guide, keep it close at hand for easy reference. Please keep all informations for future reference. • Always observe the warnings and cautions indicated on the product. About the icons In this guide various icons are used to highlight safe operation of this product and to prevent injury to the operator and other personnel and also to prevent damage to pro
Résumé du contenu de la page N° 6
Warning! Make sure the power plug is inserted as far as it will go. Loose plugs create the danger of electric shock, overheating, and fi re. • Do not use the register if the plug is damaged. Never connect to a power outlet that is loose. Use a dry cloth to periodically wipe off any dust built up on the prongs of the plug. Humidity can cause poor insulation and create the danger of electric shock and fi re if dust stays on the prongs. Do not allow the power cord or plug to become damaged, and
Résumé du contenu de la page N° 7
Introduction & Contents Introduction & Contents ........................................................................................... 2 Getting Started .........................................................................................................10 1. Install receipt / journal paper. ...................................................................................................10 2. Plug the cash register into a wall outlet. ..................................................
Résumé du contenu de la page N° 8
Programming department / fl at-PLU keys ..................................................................................... 39 To program a unit price for each department/fl at-PLU ............................................................................ 39 To program the tax calculation status for each department / fl at-PLU .................................................... 39 To program high amount limit for each department / fl at-PLU ....................................................
Résumé du contenu de la page N° 9
Introduction & Contents Coupon transaction .....................................................................................................................65 Coupon registration using (coupon key) .................................................................. 65 Coupon registration using (coupon 2 key) ............................................................. 65 Preset tender amount ..................................................................................
Résumé du contenu de la page N° 10
Mixed food stamp / cash change .................................................................................................. 95 Electronic benefi ts transfer ............................................................................................................97 About mixed EBT card tenders ................................................................................................................ 97 No change due ..................................................................
Résumé du contenu de la page N° 11
Getting Started 1. Install receipt / journal paper. Platen arm Platen Printer Important! Take away the head protection sheet from the printer and close the platen arm. Caution! (In handling the thermal paper) � Never touch the printer head and the platen. � Unpack the thermal paper just before your use. � Avoid heat / direct sunlight. � Avoid dusty and humid places for storage. � Do not scratch the paper. � Do not keep the printed paper under the following circumstances: High humidity
Résumé du contenu de la page N° 12
To install journal paper Step 1 Remove the printer cover. Step 7 Step 2 Slide the leading end of the Open the platen arm. paper into the groove on the spindle of the take-up reel and wind it onto the reel two or three turns. Step 3 Step 8 Ensuring the paper is being Replace the paper guide of fed from the bottom of the the take-up reel. roll, lower the roll into the space behind the printer. Step 9 Step 4 Place the take-up reel into Put the leading end of the place behind the printe
Résumé du contenu de la page N° 13
Getting Started 2. Plug the cash register into a wall outlet. Be sure to check the sticker (rating plate) on the side of the cash register to make sure that its voltage matches that of the power sup- ply in your area. 3. Insert the mode key marked “PGM” into the mode switch. X REG OFF RF PGM 4. Turn the mode switch to the “PGM” position. X Z P01 REG X2/Z2 OFF RF ~00 PGM RPT R-OFF T1 T2 T3 T4 TOTAL CHANGE AMOUNT 5. Sign on clerk. 1. Signing clerk 1 on as a temporary clerk. 1o 6. Set
Résumé du contenu de la page N° 14
PGM 7. Set the time. 1. Enter current time in 24 hour system, and press the Example: 08:30 a.m. 2 (09:45 p.m. 2 ) 0830X 2145X 2. Press key. Example: C 8. Tax table programming This cash register is capable of automatically calculating up to ten different sales taxes. The sales tax calcula- tions are based on rates, so you must tell the cash register the rates, the type of tax (add-in or add-on). Note that special rounding methods (next page) are also available to meet
Résumé du contenu de la page N° 15
Getting Started 8. Tax table programming (continued) 8-2. Programming special rounding for Asian, Oceania and other countries Besides cut off, round off and round up, you can also specify “special rounding” for subtotals and totals or changes. Special rounding converts the right-most digit (s) of an amount to “0” or “5” to comply with the requirements of certain areas. Programming special rounding See the list below and select the rounding which you require. Programming procedure 63s6422s 6s
Résumé du contenu de la page N° 16
PGM 8. Tax table programming (continued) 8-3. Programming Australian GST (for Australia only) 1. Turn mode switch to X mode. 2. Enter 01012001, press . 3. Press . (If you want to cancel this procedure, press instead of .) After completion of this procedure, the “GST system was changed” message was printed on receipt X Z REG X2/Z2 OFF RF 601012001s6a PGM Mode Switch and; Tax symbol (*) is printed. 1 2 Taxable amount is skipped. 3 “GST INCLUDED” is set to the TX1 descripto
Résumé du contenu de la page N° 17
PGM Getting Started 8. Tax table programming (continued) 8-4. Programming U.S.tax tables Before you can program a U.S. tax table, you must fi rst calculate the program data. The partial tax table shown below is for a tax rate of 6%. A tax amount is applied for each price range, which is defi ned by a low end minimum break point. If you subtract each maximum break point from the next lower maximum break point, you should soon be able to see certain patterns. In a cyclic pattern, the differences i
Résumé du contenu de la page N° 18
PGM 8. Tax table programming (continued) 8-5. Programming Canadian tax table X Z REG X2/Z2 Tax rate Tax table No. 6.25%: 6^25 OFF Tax table 1: 1 Tax table 2: 2 7%: 7 RF Tax table 3: 3 PGM Tax table 4: 4 Mode Switch Skip to set “Round off / Add-in”. D4 D3 0 D1 Rounding Tax system Round off: 50 Add-on: 2 Cut off: 00 Add-in: 3 Round up: 90 Tax on tax: 4 Alberta, North West Territory, Yukon Territory Prince Edward Island Tax table 1 6% 5002 Tax table 1 6% 5002 Tax table 2 Non T
Résumé du contenu de la page N° 19
Getting Started 9. Department unit price programming Maximum 6-digit unit price can be set to the department. Refer to page 39. Tax calculation status can be set to the department. Refer to page 40. 10. PLU unit price programming Maximum 6-digit unit price can be set to the PLU. Refer to page 43. Tax calculation status can be set to the PLU. Refer to page 43. 11. Discount rate programming 0.01 - 100.00% rate can be set to the Discount key. Refer to page 47. 12. Issuing daily reset report After
Résumé du contenu de la page N° 20
13. Advanced operations and Setups Single item cash sales .........................................61 Premium .............................................................63 Coupon ...............................................................65 Currency exchange function...............................70 Check tracking functions ....................................76 VAT breakdown printing ....................................84 Entering characters ...........................................10
