Instruction d'utilisation Pioneer V7300D

Résumé du contenu de la page N° 1

NextWindow
Pioneer DVD-V7300D

Touch Installation Guide

Résumé du contenu de la page N° 2

Table of Contents Introduction ..........................................................................................................................................2 Configuring the Touch Screen............................................................................................................3 Connecting the Touch Screen to the DVD Player .............................................................................4 Calibrating the Touch Screen ..........................

Résumé du contenu de la page N° 3

Introduction Congratulations on your purchase of a NextWindow 2403 Touch Panel Overlay. This Guide explains a few simple steps to set up the touch screen to work with the following Pioneer DVD players: Pioneer DVD-V7300D Pioneer DVD-V7400D (Note: For the Pioneer DVD-V5000, email support@nextwindow.com for further information.) To install the touch overlay onto a display screen, see the NextWindow Touch Panel Overlay 2403 Installation Guide supplied with the product. In addition to the

Résumé du contenu de la page N° 4

Configuring the Touch Screen To configure the touch screen, you need to run NextWindow’s configuration program, USB Config, on a computer that is connected to the touch screen via a USB cable. USB Config is part of the Touch+ software suite, which can be downloaded from NextWindow’s website: http://nextwindow.com/support/software/index.html. 1. Connect the 12 VDC power to the touch screen. 2. Connect the USB cable from the PC to the touch screen. The Windows operating system will autom

Résumé du contenu de la page N° 5

Connecting the Touch Screen to the DVD Player Pioneer DVD players require a special serial cable with a 15-pin plug. This cable can be supplied by NextWindow or a third party. The following table and diagram show the pin number connections (male connector). DVD Players Pins Touch Screen Pins 1 connects to 5 3 connects to 2 Shield connects to Shield 5 1 Shield 6 9 9 15 NextWindow Touch Screen Pioneer DVD Player Connections Before calibrating the touch screen, make sure the f

Résumé du contenu de la page N° 6

Calibrating the Touch Screen 1. With all the components connected and switched on (as listed in previous section), press the calibration button on the back of the touch screen. The program moves the pointer to a position at the top left of the screen 2. Touch and hold your finger at position indicated by the pointer until until you hear a long beep. 3. The pointer moves to three further positions in a sequence—touch each point in turn until you hear the beep. This completes the