Résumé du contenu de la page N° 1
LOW PROFILE DVD/TV/SPEAKER PHONE
OWNER’S/INSTALLATION GUIDE
- DVD Player & 10.4” TFT LCD Monitor
- Multi-Function Remote Control
- Built-in Speaker Phone Mode
- Cable Ready 125 Channel Tuner
- Internal Stereo Speakers
- Under Cabinet Mounting
- A/V Input
- 1 -
128-6451
Résumé du contenu de la page N° 2
Introduction Record model number and serial number in the INFORMATION space provided below. Refer to these numbers This equipment generates and uses radio frequency energy and if not installed and used properly; that is, whenever you call upon your Audiovox dealer in strict acc ordance with the manufacturer’s regarding this product. instructions, may cause interference to radio and television reception. It has been type tested and Model No. Serial No. found to comply wit
Résumé du contenu de la page N° 3
Important Safety Instructions 1. Read Instructions - All the safety and operating 9. A product and cart instructions should be read before the product is combination should be operated. moved with care. Quick stops, excessive force, and 2. Retain Instructions - The safety and operating uneven surfaces may instructions should be retained for future cause the product and reference. cart combination to overturn. 3. Heed Warnings - All warnings on the product 10. Ventilation - Slots and openings in
Résumé du contenu de la page N° 4
Important Safety Instructions 13. Power-Card Protection - Power-supply cords 17. Power Lines - An outside antenna system should should be routed so that they are not likely to be not be located in the vicinity of overhead power walked on or pinched by items placed upon or lines or other electric light or power circuits, or against them paying particular attention to where it can fall into such power lines or cords at plugs, convenience receptacles, and the circuits. point where they exit from th
Résumé du contenu de la page N° 5
Important Safety Instructions D. If the product does not operate normally by 23. Safety Check - Upon completion of any service following the operating instructions. Adjust or repairs to this product, ask the service only those controls that are covered by the technician to perform safety checks to determine operating instructions, as an improper that the product is in proper operating adjustment of other controls may result in condition. damage and will often require extensive 24. Wall or Ceilin
Résumé du contenu de la page N° 6
Important Safety Instructions 1) Unplug the unit before cleaning. Do not use liquid Cable System Installation Marking cleaners or aerosol cleaners. Use a damp cloth NOTE TO CATV SYSTEM INSTALLER : for cleaning. NOTE TO CATV SYSTEM INSTALLER : This reminder This reminder is provided to call The CATV is provided to call The CATV (CABLE-TV) System (CABLE-TV) System Installer’s Attention to Article 2) Use only Audiovox approved accessories. Installer’s Attention to Article 820-40 of The NEC, 820-40
Résumé du contenu de la page N° 7
Table Of Contents Introduction..................................................................................... 2 Before You Begin Important Safety Instructions............................................................ 3 Table of Contents ............................................................................ 7 Included in this Kit .......................................................................... 8 Under Cabinet Installation....................................................
Résumé du contenu de la page N° 8
Included in this kit 1. VE1040 DVD/TVPhone 4. AM Antenna 2. Mounting Template 5. Manual 3. Hardware Bag 6. Telephone Jack A. 3/4” Mounting screws (4) 7. FM Dipole Antenna B. 1-1/4” Mounting screws (4) 8. Remote Control Unit C. 1-1/2” Mounting screws (4) 9. Battery, size AAA(2) D. 3/4” Spacer (4) 10. Right angle coaxial adapter (for the TV input) E. 1/2” Spacer (4) - Adhesive Tape F. 1/4” Spacer (4) Tools Required - Philips Head Screwdriver - Centerpunch - 1/8” Drill Bit - Electric Drill - 8 -
Résumé du contenu de la page N° 9
Under Cabinet Installation FRONT VIEW SIDE VIEW 1) Choose an appropriate mounting location 5 ) Carefully drill four 1/8” holes at the locations underneath a cabinet or shelf. Close proximity to marked above. Place the screws selected through an electrical outlet and a TV antenna or cable the VE1040 and then through the spacers(if connection will facilitate a neat, easy installation. required from the bottom-up). Do not mount the VE1040 above a range or oven. Be sure that the location chosen wil
Résumé du contenu de la page N° 10
Front Panel Controls 1. O N / O F F : Power ON /OFF and Standby 10. 4 : Pause button in DVD play mode or Condition (Time Display). User - Selected Preset Channel “4” in the Radio (TV or RADIO) Mode. 2. E N T E R : Enters the desired function during the DVD Mode. 11. 5 : Play button in DVD play mode or User - Selected Preset Channel “5” in the 3. S E T : Confirms selection of TIME, ALARM, Radio (TV or RADIO) Mode. ALARM-Tone, TV-Mode or Menu item. Navigation ON/OFF button in DVD play mode.
Résumé du contenu de la page N° 11
Rear Panel Controls 1) 75 OHM ANTENNA CONNECTOR - Allows the VE1040 to be connected to 75 ohm external coaxial antenna. 2) FM ANTENNA - Allows the VE1040 to be connected to a 75 ohm external coaxial antenna for the reception of FM broadcast signals. 3) AM ANTENNA - Allows the VE1040 to be connected to an external antenna for the reception of AM broadcast signals. 4) AUDIO LINE OUT - External 8 ohm Speaker (Earphone) Connect stereo output jack. (Adapted to 8 ohm Only). 5) POWER Input Connecto
Résumé du contenu de la page N° 12
LCD Control Functions 1 MENU Button - When pressed, the LCD control MENU is displayed. 2 SEL Button - Highlights the menu item to be changed using the UP ( ) / DOWN ( ) buttons. 3 UP ( ) Button - Scrolls upward through menu items, also adjusts selected item in upward (increase) direction. 4 DOWN ( ) Button - Scrolls downward through menu items; also adjusts selected item ; in downward (decrease) direction. - 12 -
Résumé du contenu de la page N° 13
Operation CHANNEL TUNING SET UP In addition to normal broadcast reception of VHF and UHF channels, if you are a Cable TV subscriber, your new TV is capable of receiving many unscrambled Cable channels without the use of a converter box. When set to broadcast TV, it receives CH2-CH69. When set to one of the CATV modes (STD, HRC, or IRC) it receives CH1-CH125. NOTE: Most cable companies broadcast in STD Mode. POSITIONING THE SCREEN Pivot the screen forward until a comfortable viewing angle is r
Résumé du contenu de la page N° 14
Operation DEACTIVATING THE ALARM 1) Press the SET button twice to enter the alarm mode. 2) Press the T/F button once. The time indication disappears from the Vacuum Flourescent Display(VFD) and a series of dashes will appear ( : — : - indicating the alarm Deactivated mode. 3) Press the POWER button. The alarm is now deactivated. NOTE : The set times will be stored in memory and can be reactivated whenever desired by performing steps 1) - 3) of the DEACTIVATING THE ALARM procedure. SETTING
Résumé du contenu de la page N° 15
Remote Control Functions (1) OPEN/CLOSE (2) POWER (3) DVD (4) TV (5) AM/FM (6) A/V (7) Digit 0 -9 Select (8) ENTER (9) CLR (10) TEL (11) MUTE (12) VOL+/- (13) STOP (14) PLAY (15) FUNCTION UP/DOWN Select (16) PREV., NEXT (17) SR (18) SF (19) PAUSE/STEP (20) FR (21) FF (22) ZOOM (23) A-B (24) AUDIO (25) SUBTITLE (26) SEARCH (27) DISPLAY (28) MENU(ADD) (29) TITLE(ERASE) (30) REPEAT (31) SETUP(AP) (32) Channel UP/DOWN Select -15 -
Résumé du contenu de la page N° 16
Remote Control Functions DVD MENU (26) SEARCH : Permits a search to a desired Chapter/Title/Song/etc. (1) O P E N / C L O S E : Press this button to Open and (27) DISPLAY : For checking the current disc status. Close the disc tray. Use these buttons to advance to the next higher (2) POWER : Press this button to turn power On and or lower chapter in the menu contained in the Off. disc. (3) DVD : Press this button to select DVD mode of (28) MENU : For displaying the menu contained in operation.
Résumé du contenu de la page N° 17
Modes Of Operation SETTING THE CABLE TV MODE 1) With power off, press the SET button three times to enter the cable configuration mode. AIR appears on the display . Then press the 1 preset to button switch from broadcast TV(VHF or UHF) to cable TV.(CAbl will appear on the VFD.) 2) Press the SET button again to display the cable system mode (Standard, Irc, Hrc). 3) Press the 1 preset button to select the cable mode(Std/Irc/Hrc) 4) When the desired mode is reached, press the ON/OFF button. SETTING
Résumé du contenu de la page N° 18
Using the Remote Control Functions Inserting and Ejecting the Disc 1. When the tray opens, insert the disc properly with the label facing up. 2. As the tray closes, playback is automatically executed. * Discs playable through DVD player - DVD, CD, CD-R, CD-RW with MP3. Playback and Stop 1. To temporarily stop playback, press the STOP button once. The Player memorizes the exact position where it was stopped, and it will resume playback again from that position. When it is desired to playback from
Résumé du contenu de la page N° 19
Using the Remote Control Functions Repetitive Playback—To Repeat a Specific Section. 1. Pressing the REPEAT button once, the current chapter or track will be replayed repetitively (CHPTER REPEAT ON). 2. Pressing the button twice, he currently playing title or CD will be played repetitively (TITLE REPEAT ON). 3. Pressing the button three times, the repeat function will be turned off (REPEAT OFF). * In case of the MP3 disc, Press the REPEAT button to change the PLAY MODE. Repetitive Playback—To Re
Résumé du contenu de la page N° 20
Using the Remote Control FunctionS Viewing the Setup Menu 1. Pressing the SETUP button will display the setup menu. This allows the user to select DVD options (Languages, Display, Audio and Parental). 2. To return to a previous screen, press the SETUP button. Viewing the Playback Time, Title and Chapter Status 1. Pressing the DISPLAY button will allow the user to see the title and chapter number, and the elapsed time of the currently playing disc on the upper part of the screen. 2. Pressing th
