Instruction d'utilisation Xantech 29110D

Résumé du contenu de la page N° 1

INSTALLATION

QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply
MODEL
all connected to a connecting block.

29110D 1. Connect the IR receiver to the “IR RCVR” port on the connecting
block. The ‘red’ connector is installed to the ‘red’ plug.
Hidden Link™ Shelf Top
Note: In some extended distances, additional 3-conductor may be required and can
be connected to the terminals on the connecting block.
Standard IR Receiver
2. Connect the Emitter

Résumé du contenu de la page N° 2

CABLE CONNECTIONS • Make connections as shown in the figure below. Run a 3-conductor 291’s may also be used where the 7-foot cable is not long enough. Simply cable (24 to 18 gauge wire, stranded or solid) from each remote cut off the mini plug, strip the leads and splice them to a 3-conductor room to the VGS terminals of the CB12. extension cable with a terminal block or other means. Then connect the • When you use a Hidden Link IR Receiver in a remote room, do not extension cable to the

Résumé du contenu de la page N° 3

Then check to see if the Hidden Link IR Receiver operates the component. • Sometimes interference will cause the red Talk-Back LED on the front of the Hidden Link IR Receiver to blink dimly, intermittently, or continuously. • The Talk-Back Led should only blink when you are sending infrared commands to the Hidden Link IR receiver from a remote control. • It may be necessary to move either the interfering source of the Hidden Link IR Receiver to achieve proper operation.

Résumé du contenu de la page N° 4

[BLANK PAGE] [BLANK PAGE]