Instruction d'utilisation TP-Link TL-ANT5830B

Résumé du contenu de la page N° 1

Quick Installation Guide
5GHz 30dBi Outdoor Grid Parabolic Antenna
TL-ANT5830B

7106503929
Rev. 1.0.0

Résumé du contenu de la page N° 2

I. Introduction TL-ANT5830B, the TP-Link 5GHz 30dBi Outdoor Grid Parabolic Antenna, is applicable for outdoor point-to-point or point-to-multi-point directional signal transmission. It is usually mounted on such high-level outdoor locations as towers, roofs, etc. The easy way to mount TL-ANT5830B is to bind it to a mast, as illustrated above. * TL-ANT5830B is only compatible with 5GHz Access Points. Please do not connect it with 2.4GHz AP. 1

Résumé du contenu de la page N° 3

II. Specifications Electrical Specifications Model TL-ANT5830B Frequency Rang-MHz 5150-5850 Gain-dBi 30 VSWR ≤1.8 Horizontal Beamwidth-° 6 Vertical Beamwidth-° 4 Polarization Vertical or Horizontal F/B Ratio-dB ＞30 Impedance- Ω 50 Maximum Input Power-W 100 Connector N Female Mechanical Specifications Antenna Dimension-mm 600×900 Weight-Kg 3, 5 Mounting Mast Diameter-mm Ø30 ～Ø50 Radome Material Aluminium Die Cast Rated Wind Velocity-Km/h 241 2

Résumé du contenu de la page N° 4

III. Radiation Patterns Vertical Pattern Horizontal Pattern 3

Résumé du contenu de la page N° 5

IV. Installation Please find the necessary accessories in the attachment, and take the following steps to install your antenna TL-ANT5830B. 1. Mount the antenna on the “L” type brackets according to the mounting diagram. Make sure the antenna polarization is parallel to the direction you need. When the antenna polarization is vertical to the 4

Résumé du contenu de la page N° 6

ground, the antenna is vertically polarized. When the antenna polarization is horizontal to the ground, the antenna is horizontally polarized. 2. Mount the antenna on the pipe mast according to the mounting diagram. 3. Test the antenna with equipment to make sure the antenna receive the best signal by turning the azimuth and pitching angle, then lock all the screws and seal the connector between antenna and cable. 5

Résumé du contenu de la page N° 7

4. Connect TL-ANT5830B to 5GHz AP (Access Point) interface with cables. It’s recommended to use radio frequency cables with high quality and low loss. Besides, the shorter the cable is, the better it will be to avoid unnecessary loss. Warning:  Mount the antenna at a safe location, far away from power lines, lamps, and other cables.  Do not mount the antenna in the rain or thunder storm.  Do not mount the antenna alone. 6

Résumé du contenu de la page N° 8

Technical Support  For more troubleshooting help, go to: http://www.tp-link.com/en/support/faq  To download the latest Firmware, Driver, Utility and User Guide, go to: http://www.tp-link.com/en/support/download  For all other technical support, please contact us by using the following details: Global Australia & New Zealand Tel: +86 755 26504400 Tel: AU 1300 87 5465 E-mail: support@tp-link.com NZ 0800 87 5465 Service time: 24hrs, 7 days a week E-mail: support@tp-link.com.au S