Résumé du contenu de la page N° 1
R
PLCD41MP
CD/MP3
PLAYER......
WNER'S MANUAL
Car Audio Hifi System
AM/FM RECEIVER
Résumé du contenu de la page N° 2
Play/pause Scan Radio wiring Repeat Speaker wiring Shf Install the unit Band Removing the unit Band tuner Direct access tuning Power Volume Loading and Replacing the battery Eject Basic operation Mode Loud Dsp Clock Release Volume setting Bass setting Treble settting Balance setting Fader setting 1
Résumé du contenu de la page N° 3
To prevent injury or fire,take the To prevent damage to the machine, Attaching panel following precautions: take the following precautions: Attach the front panel by fixing the left side of it into this unit as1 Insert the unit until it is firmly locked to the Be sure the unit is connected to a 12V showing.Then push the right side main unit, otherwise it may DC power with a Negative Ground of panel towards into connecting fall out of place when jolted The unit is only designed for use with 4 plu
Résumé du contenu de la page N° 4
Follow this easy wiring diagram in order to enable you to install SPEAKER WIRING the new or existing RADIO and SPEAKER wring system. Theunitisonlydesignedforthe usewith4speakerssystem,itcan Be sure the unit is connected to a 12 volts battery with negative ground. only be connected with speakers rated in the load impedance range Good ground connections eliminate most electrical noise problem and from 4 to 8 ohms. Load impedance less than 4 ohms could damage require tight with the metal vehicle ch
Résumé du contenu de la page N° 5
Before installing the receiver permanently, fit it in the approximate place in your car Connect the equipment according to the speakers and electrical connections. When your system is operated properly,(preferably with the car engine running), follow the instructions 3)Support strap (supplied) for permanent installation of your system. INSTALL THE UNIT 1)Install half sleeve, can be with or without adapter. It will fit better with adapter. 2)Bend over some tabs where possible 2)Bend over tabs tos
Résumé du contenu de la page N° 6
VOL+ Volume POWER ON EJECT /OFF Increasing volume VOLUME Rotate the [VOL+]button PWR VOL Decreasing VOL SEL Rotate the [VOL-]button SEL SEEK SCN RPT SHF BAND CLOCK MODE DSP 1 23 4 5 6 SELECT RELEASE DSP CLOCK MODE Eject ST LOC LOUD Out CH Press the [ ]button to eject the disc out of the unit . LCD display In Power Press the [ ]button again, to load the disc in. Turning ON the power Press the [PWR]button. EJECT Press to turn on the unit power,Press the button to turn off the unit. 5 VOL-
Résumé du contenu de la page N° 7
Hour MODE Press [ ] button to set the hour. Selecting radio and play Minute Press the [MODE]key. Press [ ] button to set the minute. Each time you press the key, it`ll switch between radio Quit clock set mode and CD position. It will quit clock set mode If there is no operation (If mode with AUX IN,the function is below: in 5 seconds. press MD(MODE)to select: 1 If with DISC,press MD that is: AUX IN RADIO DISC AUX IN Dsp 2 If without DISC,press MD that is: Short press this button to DSP AUX IN RA
Résumé du contenu de la page N° 8
VOL+ PRESS SELECT Speaker mode PWR VOLUME TREBLE BASS VOL SEL SEEK SCN RPT SHF BAND CLOCK MODE DSP 1 23 4 5 6 FADER BALANCE SHF DSP SCAN VOLUME PLAY/PAUSE REPEAT In press mode, VOL is sel function Treble set mode Volume set mode Press SEL button third, TRE TRE 5 5 Press SEL button once,display shows VOL , display shows TRE ,then then rotate the volume + button rotate the volume + button to adjust treble to adjust volume level up.rotate level up. Rotate the volume - button to adjust the volume -
Résumé du contenu de la page N° 9
Play/pause Shf Pause Press [SHF]button If with DISC in unit,Press the [ ]to pause music. Press[SHUF] buttontoplay allthe trackinrandomorder. SHF and playing song number will appear on the LCD. Play Press [SHUF]again will stop random playing. Press the [ ]button again ,then come back to DISC playing. Scan Press [SCN]button Press this button once for TRACK INTRODUCTION. The first 10 seconds of each track on the disc will play. And the track number shows on LCD. To select a desired song, press [SCN
Résumé du contenu de la page N° 10
Tuner In radio mode: PWR manual tuning: VOL SEEK- SEL short press button it can select higher frequency station. SEEK Short press can select lower frequency station. SEEK+ SCN RPT SHF BAND CLOCK MODE DSP 1 23 4 5 6 Auto loading tuning: the long press button it can automatically select higher PRESET MEMORY 1-6 BAND frequency station. And the long press it can automatically select lower frequency station. Band Selecting band Preset memory Press BAND button to select among three FM or two AM bands.
Résumé du contenu de la page N° 11
Loading and replacing the battery MUTE MODE Use one lithium battery(CR2025) PWR MODE BAND insert the batteries with the +and - poles aligned properly. POWER MUTE BAND/LOUD -,_,+,0 STU7 ENTER SCAN LOUD REPEAT Following the illustration inside the case. 1 2 3 AS/PS PAUSE AS/PS ABC DEF GHI ID3 PAUSE SCAN RPT 4 5 6 LOC LOCAL SHUF JKL MNO PQR SHF DISC DN DISC UP DSP + MONO DSP RO/SN MONO CHAR.SEL VOL+/CHAR.SEL SEL VWX8 SHIFT YZ9 SPACE Pull out SELECT - CLK CHAR.SEL Store unused batteries out of the r
Résumé du contenu de la page N° 12
External view External view ID3 ........ Number of items ........ Number of items MUTE MODE BAND LOUD Press ID3 on remote or Panel enter ID3 selection. AS/PS PAUSE SCAN RPT LOC SHF DISC DN DISC UP DSP RO/SN MONO 1 ............1 ............1 one press ID3 enter ID3 file selection mode, F will be indicated on 5 SEL CLK LCD. To read in your desired song name by pressing remote ABC - buttons, YZ9 BAND ENTER then press confirmed the song playing. EXAMPLE:toreadin"ILOVEYOU" ............1 ............
Résumé du contenu de la page N° 13
Specifications subject to change without notice. CD PLAYER GENERAL Signal/Noise radio......................................................70dB Operating power.....................................12 Volts DC,negative Frequency response..............................20Hz-20KHz(+3dB) ground Channel separation..................................................>45dB %10THD output wiring.........................Designed for using four Dual D/A converter..................................................
Résumé du contenu de la page N° 14
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. ?No/Poor sound on one or more speakers Before calling service, first check the following table Speakers or speaker wiring or volume, Balance and for possible problems. Fader setting Check the speaker wiring and test the speakers all in good condition check the setting of volume, Balance and Fader controls. ?The power does not turn ON. The fuse has blown. Install half sleeve, can be with o
Résumé du contenu de la page N° 15
CD/MP3 PLAYER AM/FM RECEIVER WITH ESP FOR CD 40S,MP3 70-120S Car Audio Hifi System
