Résumé du contenu de la page N° 1
PLCDCS 200
OWNER’S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Cassette Player
• Automatically Memory Storing
•Preset Equalization
• Auxiliary Input Function
• Remote Control
• Undetachable Panel
Résumé du contenu de la page N° 2
CONTENTS Installation .....................................................................................................3 Wiring Connection ........................................................................................4 4 x 50W System......................................................................................................4 Operation.......................................................................................................5 General Operation .................
Résumé du contenu de la page N° 3
INSTALLATION Method A SUB PANEL FLANGE NUT QUICKIE BOLT REAR BUSHING FACTORY BRACKET MOUNTING SCREW QUICKIE BOLT DASH PANEL Method B SUB PANEL QUICKIE BOLT FLANGE NUT MOUNTING SCREW 2#BRACKET DASH PANEL MOUNTING SCREW 2#BRACKET 2#BRACKET 3#BRACKET 1#BRACKET 2#BRACKET 2#BRACKET STANDARD MOUNTING CONFIGURATION “JA” MOUNTING CONFIGURATION “JZ” MOUNTING CONFIGURATION 3
Résumé du contenu de la page N° 4
WIRING CONNECTION For 4 x 50W System MAIN UNIT ANTENNA SOCKET FUSE IGNITION RED SWITCH (B+) (BLACK) Rch RED TV AUDIO IN YELLOW MEMORY Lch WHITE BACK-UP (GREY) BLACK GROUND (B–) Rch RED RCA CABLE Lch WHITE BLUE POWER ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK 4
Résumé du contenu de la page N° 5
OPERATION 12 9 10 27 8 3 15 7 1 6 2 16 13 17 19 20 21 18 22 23 11 14 4 5 28 24 26 25 5
Résumé du contenu de la page N° 6
OPERATION • SELECT MODE GENERAL OPERATION Press the MODE button (6) to choose desired listening mode. (e.g. radio, Note: In this product design, there has CDP, CDC, tape, TV or AUX mode) different sound accompanying with every button pressed and the sound is • MUTE designed differently according to the Press the MUTE button (2) to silence customers. the receiver. Press it again to release the mode. • ON/OFF Switch on the unit by pressing POWER • LIQUID CRYSTAL DISPLAY button (9). When sy
Résumé du contenu de la page N° 7
OPERATION memorized, the seconds Auto Store RADIO OPERATION search continued by Distant state. At the end of Auto Store operation, • BAND SELECTION mode is change to Preset Scan. At radio mode, press BAND button (13) to select the desired band. -Preset Scan The reception band will change in the Press AS/PS button (14) shortly in following order: radio mode, Preset Scan is started. FM1 FM2 FM3 AM1 AM2 This operation starts from next preset number and finished at the • STATION SELECTION same
Résumé du contenu de la page N° 8
OPERATION CDP OPERATION REMOTE CONTROL HANDSET 1 7 4 3 • SELECT TRACKS Press TUNE/TRACK/SKIP button (16) or TUNE/TRACK/SKIP button (17) to move to the previous track or the 8 9 following track. Track number shows on 6 display. 5 Hold TUNE/TRACK/SKIP button 13 2 (16) or TUNE/TRACK/SKIP button 12 10 (17) to fast reverse or fast forward. CD 11 14 play starts from when you release the 15 button. •PAUSE PLAYING Press PAU button (19) to pause CD player. Press it again to resume pl
Résumé du contenu de la page N° 9
SPECIFICATIONS GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 200 mm (W) x 138 mm (D) x 75 mm (H) Loading Impedance : 4 - 8 Ω per channel Maximum Output Power : 4 x 50 Watts Current Drain : 10 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB Frequency Response : 20 Hz - 20 KHz CASSETTE PLAYER Tape Speed : 4.76 cm/sec Fast Forward Time : 180 seconds (C-60 type) Frequency Response : 50 to 8,000 Hz Channel Se
Résumé du contenu de la page N° 10
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot Presence of CD disc inside Remove the disc in the player, then be
Résumé du contenu de la page N° 11
MAINTENANCE 3. Clean the tape head with the cotton For System swab. The following suggestions help you care for the product so that you can enjoy it for years. 1. Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. 4. Clean the capstans and the pinch 2. Keep the product away from dust and rollers with the cotton swab. dirt, which can cause premature wear 5. Allow the tape head, capstans and of parts. pi
Résumé du contenu de la page N° 12
CAUTION 1. This unit is designed to operate on 3. Your unit has built-in filtering to 12-volts DC, negative ground eliminate most of the noise that might electrical system only. Do not attempt come through the power source. to install this unit in a vehicle having a However, with some vehicles, positive ground system. particularly older models, some clicking or other unwanted noise 2. You should not touch the might be present. high-polished playback head with any metallic or magnetic tools
