Instruction d'utilisation Mini R52

Résumé du contenu de la page N° 1

Page 1 of 5
Installation Instructions
November 2004

Audio, iPod Interface Ver 1.0 Accessory
Development


SUBJECT

®
iPod Interface Kit – P/N 65 11 0 392 139

MODEL

MINI Cooper (R50): Select Vehicle Production 03/02 – On*
MINI Cooper-S (R53): Select Vehicle Production 03/02 – On*
MINI Convertible (R52): Select Vehicle Production 09/04 – On*

* Not compatible with 6-Disc CD Changer (SA672), Sirius Satellite Radio, or Hands-Free Phone System.


SUGGESTED INSTALLATION

Résumé du contenu de la page N° 2

2 Procedure: 1. Disconnect negative battery terminal. 2. Remove the following components using information available in TIS: • Drivers knee bolster (1) • Center dash face (3) (Refer to RA62 21 001) • Radio side pillars (4) (Refer to RA51 16 198) • Radio (5) (Refer to RA 65 11 030) • Glove box (6) 3. Remove the blue lock (1) from radio harness by releasing tab and sliding upwards, then remove following terminals (2) using AMP terminal removal tool p/n 61 1 134: Pin # Col

Résumé du contenu de la page N° 3

3 8. Insert 4 rectangular pins from iPod harness (1) into radio harness (2) as follows: Color Location Description White/gray 9 I-Bus Brown 12 Ground Violet/white 16 KL-R Red/green 15 KL-30 9. Remove white 12-pin connector (3) from lower section of radio connector. 10. Insert white 12-pin connector (1) from iPod harness (2) into lower left section of radio connector (3). 11. The white 12-pin connector (4) removed from the factory radio connector in Step 9

Résumé du contenu de la page N° 4

4 14. Insert iPod cable (1) through hole in glovebox as indicated. Note: Split grommet as shown before placing around iPod cable in order to prevent damage to cable. 15. Split grommet (1) as indicated (2) and insert grommet through hole in glovebox wall. 16. The flat iPod connector (1) should be located in the glovebox and the 8-pin DIN connector (2) for the adapter box should be routed through the center console to a location behind the radio. 17. Re-connect glo

Résumé du contenu de la page N° 5

5 21. Mount iPod interface as indicated below radio and secure with cable ties(not included). 22. Re-install all components removed for installation procedure. VEHICLE CODING There is no vehicle coding required for this installation. TROUBLESHOOTING • iPod mode is not selectable from the radio until an iPod is connected. (refer to MINI iPod Interface Owner’s Manual) • This iPod Interface is compatible with the following software versions: o Gen3 iPod –