Résumé du contenu de la page N° 1
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 1
Installation and
Operations Manual
EJECT
POWER
VOLUME
MUTE
MON SCAN
LOC
ST
LOUD
BAND DSP EQ
LOU AF TA TP PTY
1 2 3 4 5 6
AMS MODE
INTRO REPEAT SHUFFLE CD- CD +
AUX
M3200CD
AM / FM and CD Stereo Receiver
with CD Changer Control
A Registered Trademark of Magnadyne Corporation
®
Résumé du contenu de la page N° 2
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 2 Introduction Your new M3200CD indash entertainment system has been designed to give you many years of listening pleasure. Take a moment to read through this manual and become familiar with the operations and features of this outstanding product. It is advisable to keep this manual in your vehicle so it is readily available for reference. Be sure to fill out and send in your warranty card to ensure that you receive the full benefits of warranty repair
Résumé du contenu de la page N° 3
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 3 Location and Function of Controls at a Glance 1. Power On/Off: Turns the unit on and off. 2. Infrared Sensor: Receives the signals from the remote control allowing you to adjust the basic functions of this unit. 3. Auxiliary Input Jack: Allows you to listen to an auxiliary input audio source, such as a portable MP3 player or cassette player. 4. Audio Control Knob: Adjusts the Volume, Bass, Treble, Balance and Fader. 5. AMS Button: Automatic memory st
Résumé du contenu de la page N° 4
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 4 Location and Function of Controls at a Glance 15. Play / Pause Button: Starts / pauses disc play. Mute Button: Mutes audio level. 16. Tack Up / Track Down Buttons: Adjusts the radio frequency, changes CD tracks and sets the clock. 17. Equalizer: Selects preprogrammed equalizer settings in the following order: FLAT, CLASSICS, POP M (Pop), and ROCK M (Rock). 18. Display Button: Displays the frequency momentarily, then will revert to displaying the tim
Résumé du contenu de la page N° 5
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 5 Radio Operation Select a Band Preset Scan: Scan stations stored in the current band. In Tuner Mode, press the “BAND” button (13) to Select a band (if needed). Press the AMS button (5) select the desired band in the following order: F1, momentarily. The radio pauses for five seconds at F2, F3 and AM. Each band can store up to six pre- each preset station. When desired station is reached, set stations. press the AMS button again to stop scanning. Tuning
Résumé du contenu de la page N° 6
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 6 General Operations Power Auxiliary Input Jack (Front Panel) Press the “POWER” button (1) to turn the unit Plug an audio device into this jack (3). This On/Off. allows you to listen to an auxiliary audio source (MP3 player, portable cassette player, etc). Audio Beep Connect the proper cable (not supplied with this Press and hold the Audio Control knob (4) for 3 unit). Press the “MODE” button (14) to access seconds. Either BEEP OFF or BEEP ON will appe
Résumé du contenu de la page N° 7
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 7 Specialty Features Reset Button POWER The radio panel or LCD display may fail to func- tion normally due to the vehicle’s battery condi- VOLUME tion, and may require resetting the radio micro- processor if: • The vehicle has been “jump started” from a dead LOU battery condition • The vehicle battery becomes very low and is 1 2 3 AMS quick-charged INTRO REPEAT • The vehicle battery is removed and replaced Should this condition occur, simply press a
Résumé du contenu de la page N° 8
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 8 Installation Procedures Gray Cable with Red/White RCA Connectors: Step 1: The radio chassis is designed to be “Sleeve Provides Left and Right Channel audio signal output Mounted” through a opening in the dashboard panel. for input to an additional amplifier. The required opening size is 182mm (7-3/16") x 84mm (3-5/16"). Cut or enlarged an opening in the Note 1: This unit is designed to connect to (4) four dashboard to accommodate the mounting sleeve.
Résumé du contenu de la page N° 9
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 9 Wiring Diagram M3200CD 8-Pin Din Antenna Socket Connector External CD Changer Red Wire Ignition Switch (+12v in ) Yellow Wire Battery (+12v in) Red Black Wire Ground (B-) Right Channel Audio Line Output Blue Wire Power Antenna (Switched 12v out) White Left Channel Left Right White Wire Gray Wire Front Front Speaker Speaker Gray Wire with Black Stripe White Wire with Black Stripe Left Right Green Wire Violet Wire Rear Rear Speaker Speaker Green Wire
Résumé du contenu de la page N° 10
POWER VOLUME CAR COMPACT DISC PUSH SEL MUT MON LOC LOUD BAND EQ AUX IN AMS PAUSE 1 SCAN 2 3 RANDOM 4 5 6 MODE POWER VOLUME CAR COMPACT DISC PLAYER PUSH SEL MUT MON LOC LOUD BAND EQ AMS PAUSE 1 SCAN 2 3 RANDOM 4 5 6 MODE AUX IN M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 10 Audio Line Out Connection Cable Not Supplied M3200CD Red (Right) Optional Amplifier White (Left) CD Changer Connection M3200CD Male/Male CD Changer Black (Supplied with CD Changer) Final Installation - Method A Sheet Metal Scre
Résumé du contenu de la page N° 11
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 11 Final Installation - Method B DIN Rear-Mount If your vehicle is a Nissan or Toyota, fol- Side View Showing low these mounting instructions: Screw Holes Marked Use the screw holes marked T (Toyota), T, N N (Nissan) located on both sides of the unit to fasten the unit to the factory radio Factory Radio mounting brackets supplied with your Screw Mounting Bracket vehicle. To fasten the unit to the factory radio mounting brackets. 1. Use a screwdriver to
Résumé du contenu de la page N° 12
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 12 Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the cor- rect power requirements designated for t
