Instruction d'utilisation Legacy Car Audio LCD87DFX

Résumé du contenu de la page N° 1

TROUBLE SHOOTING
Before going through the check list, check wiring connection.If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom Cause Solution
No power.
If the power supply is properly
The car ignition switch is
connected to the car accessory
not on.
terminal,switch the ignition key
to "ACC"
OWNER's MANUAL
The fuse is blown. Replace the fuse.
Mobile Video System
Presence of disc inside the Remove the disc in the player,
Disc cannot be
The

Résumé du contenu de la page N° 2

CUSTOMER NOTICE SPECIFICATIONS GENERAL Power requirement.............................................................................................................DC 12V Current consumption...........................................................................................................5A POWER OUTPUT............................................................................................................. 4X7W FM SECTION For 3 Bands For 2 Bands For 2 Bands (Europe) (Europe) (U.S.A.

Résumé du contenu de la page N° 3

NOTES BASIC OPERATION DISC PLAY: Cleaning discs Before playing, clean the disc with a clean, lint-free. Flip the disc in the direction of the arrow. NOTE: .Do not use so solvents such as benzine, thinners. Commercially available cleaners or anti static spray damage the unit. Inserta disc with the label surface down. Doing so may damage the unit. NOTE: . Do not try to insert another disc when one has been already inserted. Doing so may damage the unit. Handle the disc by its edge. And to keep the

Résumé du contenu de la page N° 4

BASIC OPERATION INSTALLATION 1. OPEN BUTTON Press it to flip down the front panel then you can insert the cd disc into the cd compartment CAUTION: Do not install the detachable panel before connecting the wire. EJ button on the back of the front panel,press it to eject the disc. 2.8.9 SEL( AUDIO MODE SELECT)/ +/- BUTTONS 1. The unit is designed for negative terminal of the battery which is connected Press SEL button to change the mode in the sequence of VOL BAS TRE BAL FAD to the vehicle metal.

Résumé du contenu de la page N° 5

INSTALLATION BASIC OPERATION display fora few seconds. Regional mode OFF The regional code in the format of PI code is ignored when AF switching or PI SEEK is implemented. DASH BOARD REG of individual seg. is turned off together with displaying REG OFF on numeric display fora few seconds. METAL MOUNTING STRAP 11-12-13-14-15-16. PRESET MEMORY BUTTONS HEX NUT A). To memorize the current frequency, press any one of the six preset Buttons hold for more SPRING WASHER than 2 seconds. CONSOLE PLAIN WAS

Résumé du contenu de la page N° 6

BASIC OPERATION ELECTRIC CONNECTION When PTY is selected, the radio starts to search corresponding PTY information, and stops if the FOR 4X40W corresponding PTY information is detected. If corresponding PTY information is not existed any more, PTY type is automatically exit to normal mode. AUX cable(optional) 20.TA BUTTON(for RDS model only) ANTENNA CONNECTOR TAfunction [TRAFFIC ANNOUNCEMENT] BUTTON(For RDS only) RCH RED LCH WHITE When pressed short, it is activated as TA mode on or off. OR When