Résumé du contenu de la page N° 1
V O L U M E
S E L
OWNER’S MANUAL
VBD2600MP
RX
AS/PS
PAU 1 INT 2 RPT 3 4 RDM 5 6
FULL LOGIC MOTORIZED SLIDE
DOWN & FULL DETACHABLE PANEL
CAR CD / MP3 /WMA PLAYER / RECEIVER
MODE
Résumé du contenu de la page N° 2
V O L U M E S E L VOLUME SEL BUTTONS LOCATION SUBWOOFER DISPLAY BUTTON BUTTON 7 15 14 6 5 3 PANEL PRESET PANEL RELEASE MENU MUTE EQUALIZER IXBASS OPEN BUTTON BUTTON BUTTON BUTTON BUTTON BUTTON R X AS/PS PAU 1 INT 2 RPT 3 4 RDM 5 6 PRESET STATIONS BUTTONS SCAN MODE SELECT LO/DX BUTTON BUTTON BUTTON BUTTON 12 17 9 11 2 MP3 / WMA ENTER BUTTON 18 REMOTE CONTROL RECEIVER RX AS/P S PAU 1 INT 2 RPT 3 4 R D M 5 6 VOLUME AUTOMATICALLY TUNING UP/DOWN POWER MP3/WMA UP/DOWN STORE / PRESET TRACK
Résumé du contenu de la page N° 3
HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs NOTES ON DISCS If you use the discs explained below, the 1. A dirty or defective disc may cause sound sticky residue can cause the CD to stop dropouts while playing. To enjoy optimum spinning and
Résumé du contenu de la page N° 4
1. INSTALLATION Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the pa
Résumé du contenu de la page N° 5
Removing the unit a a. Frame b. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove b down wards and attach it.) c. Insert the levers supplied with the c unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. Trim Plate Installation: Push the trim plate against the chassis until it is fi
Résumé du contenu de la page N° 6
RESET 2. DETACHABLE CONTROL PANEL (D.C.P.) Removing The Detachable Control Panel (D.C.P.). 1. Turn the power off 2. Press the D.C.P. release button 3. Remove the D.C.P. PANEL RELEASE BUTTON Attaching the DCP 1. Attach the panel at the right side first, with 2 point B on the main unit touching point A on the A D.C.P . (As shown on the diagram). 2. Then press the left side of D.C.P . onto the main B unit until a “click” sound is heard. CAUTION DO NOT insert the D.C.P from the left side. Doi
Résumé du contenu de la page N° 7
3. WIRING DIAGRAM (20 PIN HARNESS PLUG) ANTENNA FUSE ANTENNA EXTENDER JACK CABLE 20-PIN AUDIO/POWER HARNESS (See Figure 1) RCA-TO-RCA CABLES (NOT SUPPLIED) WHITE BLUE SUB WOOFER SUB-WOOFER L-CH R-CH RCA-TO-RCA CABLES WHITE (not supplied) GREY AUX IN REAR LINE OUT RED AMP WHITE BLACK FRONT LINE OUT RED BLUE Power Antenna Connect to power antenna or amplifier,If not used,Tape bare end of wire. BLACK Ground Connect to ground terminal or Clean unpainted metal part of chassis Memory/Battery Co
Résumé du contenu de la page N° 8
4.PANEL OPEN/CLOSE OPERATION (MOTORIZED SLIDE DOWN VERSION) This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the “OPEN” button Please read carefully the following operation instruction before operating the unit. OPEN / CLOSE THE PANEL: Press the Open button to slide down (open) a closed panel or to slide up (close) an opened panel. LOADING A CD When the panel is in the slide down position
Résumé du contenu de la page N° 9
5. BASIC OPERATIONS 14) PANEL RELEASE BUTTON ( ) Press this button to remove the control panel. 1) POWER ON/OFF BUTTON ( ) Press POWER button or any other button on the front of the radio (except Open/Eject)to turn the unit on. Press POWER button again to turn the unit off. 2) MODE BUTTON (MODE) Press MODE button to select a different mode of operation as indicated on the display panel. Available modes include Tuner, CD, MP3,WMA and Aux in . AUX INPUT Connect the external signal
Résumé du contenu de la page N° 10
Balance Press the sel button five times, then use the volume up/ down button to adjust the balance between the right and left speakers from R12 (full right) to L12 (full left). “C00” Represents a center balance level between the right and left speakers. Fader Press the sel button six times, then use the volume up/ down button to adjust the fader between the front and rear speakers from R12 (full rear) to F12 (full front). "C00” Represents a center fader level between the front and rear s
Résumé du contenu de la page N° 11
7) MENU FUNCTION LIST (MENU) Press DISPLAY/MENU to access the menu. "Menu" will appear in the display momentarily. Navigate the menu by pressing DISPLAY/MENU momentarily to move forward to the next option. The menu can also be navigated by using the Tuning Up or Tuning Down Button to move to the next or previous option. Once the desired option appears in the display, adjust that option by using the volume control up or down within 5 seconds. The following options are adjusted through this
Résumé du contenu de la page N° 12
Illumination Color (COLOR) This option allows selection between two colors for the backlight illumination of the unit. "COLOR 1" is the default color and will illuminate the unit with blue backlight. Use volume up/down button to select "COLOR 2”,, which will illuminate the unit with red backlight. Selectable Clock Display (CLK ON LCD) When the selectable clock display feature is activated, the clock and default greeting note will appear on the display when the radio is turned off but the igni
Résumé du contenu de la page N° 13
GREETING NOTE There are three different greeting note displayed on LCD base on different condition. 1.When the unit is powered on, one of three greeting will display based on the time of day: Good Morning, Good Afternoon or Good Evening. 2. When the unit is powered off but the ignition remains on, the LCD will scroll through the following messages if the selectable clock display feature is activated: “Enjoy Driving! Have a Safe Trip!” 3. When the ignition is turned off, the message "See
Résumé du contenu de la page N° 14
6. TUNER OPERATION 8) BAND BUTTON (BAND/SERACH) Press BAND to change between FM bands and AM(MW) bands. Each band stores up to 6 preset stations. 10) TUNING UP/DOWN BUTTON ( ) Manual Tuning Press the Up Tuning or Down Tuning button for more than 3 seconds to move the radio frequency number up or down one step. Auto Seek Tuning Press the Up Tuning or Down Tuning button for less than 3 seconds to move to next station automatically. 11) SCAN BUTTON(SCAN) Press SCAN button to scan t
Résumé du contenu de la page N° 15
7. CD PLAYER OPERATION INSERT AND EJECT CD Insert a CD label-side up with the unit turned on, and the disc will begin to play. Press the Eject button to stop CD play and eject the CD. The unit does not have to be turned on to eject the CD. PAUSE BUTTON (PAU) Press the pause button to suspend disc play. Press the pause button again to resume disc Play. TRACK SELECT Press the Up Tuning or Down Tuning button ( ) for less than one second to advance to the next track on the CD, The selec
Résumé du contenu de la page N° 16
8. MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on a CD-R/RW using the buttons on the receiver (or optional remote).Depending on the media type and recording method, some CD-R/RW's may be incompatible with this unit. The unit supports playback of MP3/WMA and CDDA (CDA), Mixed-Mode CDs and CD-Extra (including multisession discs), but discs o
Résumé du contenu de la page N° 17
Writing Files into a Medium When a medium containing MP3/WMA data is loaded, the unit checks all data. If the medium contains many folders or non-MP3/WMA files, MP3/WMA play will be delayed, it may take time for the unit to move to the next file, and searches may not be performed smoothly. Loading such a medium may produce loud noise and cause damage to the speakers. Do not attempt to play a medium containing a non-MP3/WMA file with the MP3/WMA extension or a medium containing non MP3/WMA f
Résumé du contenu de la page N° 18
FILE/FOLDER PLAY There are three different play methods as following: File/Folder Intro play: Press M2 button more than 3 seconds during playing MP3/WMA disc for “intro play” all files of the current folder. Intro play should restart from the first song of the current folder, after all files in the current files have been intro-played. To disable current folder “intro play”, long press M2 button more than 3 seconds Press M2 button less than 3 seconds is “intro play” all files on the disc.
Résumé du contenu de la page N° 19
9.MP3/WMA FILE OR FOLDER SEARCHING The unit allows end user have three different method for the file / folder searching. 1)Direct file number searching. “014 MP3 file” Press MP3 search button (Band button) once LCD will display “number search”, Press “Audio Select” key or press volume down/up button to enter the “Number search”. Press volume down up button until “014” Long Press MP3 enter button (Audio Select button) to confirm & play file “014” 2) Folder /files Navigate searching. Folder “0
Résumé du contenu de la page N° 20
ID3 INFORMATION DISPLAY If any MP3/WMA file recording with ID3 Tag information. The ID3 information such like Album title, Track title, Artist Title will be displayed and automatic scrolling through the LCD while the file is playing. User also allows pressing the AS/PS button repeatedly to view the ID3 tag information manually. NOTE OF ID3 ICONS ON DISPLAY ICON DESCRIPTION FOLDER ICON FILE ICON TRACK ICON ARTIST ICON ALBUM ICON E - 19
