Instruction d'utilisation Jensen VM9414

Résumé du contenu de la page N° 1

Installation Guide
VM9414
What’s in the Box
VM9414 Head Unit Cosmetic Trim Ring
Single DIN Sleeve Remote Control with Battery
Wiring Harness 3.5mm to 3.5mm Media Adaptor Cable
Parking Brake Sensor Extension Wire Owners Manual
Mounting Hardware Installation Guide
Tools and Supplies
You will need these tools and supplies to install your VM9414:
• Torx type, fl at-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket wrench set or other tool

Résumé du contenu de la page N° 2

Optional Equipment • BTM10: Allows you to connect to a Bluetooth enabled cell phone or other device. • Rear Camera Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to in- stallation. NOTE: If the VM9414 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, u

Résumé du contenu de la page N° 3

Enter SEL ST VM9414 AV IN AV IN LOC REP LOUD Press Audio Enter MUTE NAV VOL SEL Press Audio Enter VM9414 AV IN MUTE NAV VOL SEL Wiring WARNING! Only connect the unit to a 12-volt power supply with proper grounding. Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the bat- tery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch. NOTE: When replacing a fuse, be sure to use correct type and am

Résumé du contenu de la page N° 4

Wiring Diagram IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. For basic iPod connectivity, you can use the white 30-pin to USB iPod cable that came with your Apple device. For iPod video playback, you must purchase the jLink-USB cable. Connect the iPod cable to the MediaLink USB and route the MediaLink USB to an accessible part of the dash area for easy connectivity. For occa