Résumé du contenu de la page N° 1
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
CDX6311 TABLE OF CONTENTS TABLE DES MATIÈRES Introduction ..............................................................................................1 Introduction ............................................................................................33 Preparation ..............................................................................................2 Préparation ............................................................................................34 Wiring ................
Résumé du contenu de la page N° 4
CDX6311 ii
Résumé du contenu de la page N° 5
CDX6311 • Rotary encoder audio control INTRODUCTION • Programmable turn-on volume Congratulations on your purchase of the Jensen CDX6311 Mobile Receiver. It’s a good idea to • Multi-button power on read all of the instructions before beginning the installation. We recommend having your • Keyless CD eject Jensen CDX6311 installed by a reputable installation shop. • 1-Pair Front / Rear pre-amp outputs • 5V Peak / 2V RMS RCA pre-amp output voltages Features • 200-ohm low impedance preamp output X
Résumé du contenu de la page N° 6
CDX6311 PREPARATION Tools and Supplies The following tools and supplies are needed to install the radio. • Torx type, flathead and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16-18 gauge speaker wire SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4 ohms. Speakers wi
Résumé du contenu de la page N° 7
CDX6311 WIRING Wiring with a Wiring Adapter (Purchased Separately) Connect Wires You can make all these connections without even being in the vehicle. 1. Splice or crimp wires. 2. Attach wiring adapter to the car wiring harness. Wiring Diagram / Color Codes 1. Power Antenna (dark blue wire) - Connect to the power antenna or a amplifier. If not used, tape the bare end of wire. 2. Ground (black wire) - Connect to the ground terminal or a clean, unpainted part of the chassis. 3. Memory
Résumé du contenu de la page N° 8
CDX6311 Fuses INSTALLATION When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an This unit is designed for installation in cars, trucks and vans with an existing radio opening. In incorrect fuse could damage the radio. The CDX6311 uses one 15 amp fuse located below the many cases, a special installation kit will be required to mount the radio to the dashboard. wiring connector (15 amp fast blow ATO). These kits are available at electronics supply stores and
Résumé du contenu de la page N° 9
CDX6311 5. Place the radio in front of the dashboard opening so the wiring can be brought through the 2. Install the radio/mounting plate assembly to the sub-dashboard according to the mounting sleeve. instructions in the installation kit. 3. Attach the support strap to the radio and dashboard as described in the Universal Installation instructions. 4. Replace the dashboard trim panel. ISO Installation This unit has threaded holes in the chassis side panels which may be used with the original
Résumé du contenu de la page N° 10
T T T T C C C C L L L L E E E E E E E E S S S S H H H H S S S S PU PU PU PU CDX6311 Balance OPERATION To adjust the balance from “L12” (full left) to ”R12” (full right), press the volume control until Power “BAL” appears in the display. Rotate the control clockwise or counter-clockwise to adjust the Press the power button (1) or any other button on the front of the radio (except Eject) to turn balance between the left and right speakers. “C00” represents a center balance. the unit on. Press
Résumé du contenu de la page N° 11
CDX6311 Display Options NOTE: The XM Scroll option only appears when an XM box is connected. Press DISPLAY/MENU (7) to navigate through the following options: • Tuner: FREQ > Spectrum > PTM Message Clock Format • CDP/MP-3/WMA: Elapsed Time > Spectrum > PTM Message This option allows selection of a 12 hour or 24 hour clock format. “CLK FORMAT 12H” is the • XM mode: Category Name > Artist Name > Song Title > Spectrum > PTM Message > default setting. Rotate the volume control to change to the 24
Résumé du contenu de la page N° 12
CDX6311 character, press in on the volume control to move to the next space and select the next Theft Deterrent LED character. To leave a blank space, press the volume control again. A light-emitting diode (LED) is located on the chassis behind the front panel and will flash when Greeting Note the panel is removed. The flashing light serves as a visual warning to the would-be thief that When the unit is powered on, one of three greetings is displayed based on the time of day: the unit has be
Résumé du contenu de la page N° 13
CDX6311 Automatically Store / Preset Scan TUNER OPERATION Automatically Store The CDX6311 comes equipped with a World Tuner, allowing you to receive channels in USA, Automatically select six strong stations and store them in the current band. Select a band (if EUROPE, LATIN, & OIRT (Russia). See “Frequency Spacing” on page 7 to learn how to needed). Press AS/PS (21) for more than three seconds. The new stations replace any change the World Tuner options. stations already stored in that band
Résumé du contenu de la page N° 14
CDX6311 Preset Scan ® XM RADIO OPERATION 1. Press AS/PS (21) for < 3 seconds. The unit pauses for 5 seconds at each preset station ® for all three bands (XM-1, XM-2, and XM-3). Listeners can subscribe to XM Radio on the Web by visiting www.xmradio.com, or by 2. Press AS/PS again to stop scanning when the desired station is reached. calling (800) 967-2346. Customers should have their Radio ID ready (see “Displaying the Identification (ID) Code”). Customers can receive a limited number of free-
Résumé du contenu de la page N° 15
CDX6311 Random (RDM) CD PLAYER OPERATION Press RDM (15) during disc play to play all tracks on a CD in random, shuffled order. Press Insert and Eject CD RDM again to stop random play. Press the eject button (22) and let the motorized front panel swing-down to display the CD slot. Display CD Text Insert a CD label side up. After inserting a CD, the front panel will close automatically. To stop CD play and eject the CD, press the eject button. After ejecting the CD, the unit will close Press A
Résumé du contenu de la page N° 16
CDX6311 CD Changer Error Codes CD CHANGER OPERATION If problems arise during CD changer operation, the following error codes may appear in the Please call Jensen technical support at 1-800-323-4815 for a complete list of CD changers display: compatible with this unit. The following Jensen CD Changers are compatible with this unit: ER-1: No magazine loaded in the CD changer. ER-2: Problem in the disc loading function. JCH10RF and CH1001. ER-3: Error in the disc loading function. ER-4: Error i
Résumé du contenu de la page N° 17
CDX6311 REMOTE CONTROL CARE AND MAINTENANCE The remote control will allow you to control the basic functions of the CDX6311. CD Player The remote control sensor is at the top left of the IX-BASS (18) button. The following guidelines will help you extend the life of your CD player: 1. When cleaning the vehicle interior, do not get water or cleaning fluids on the unit. 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In case of such conditions, wait until
Résumé du contenu de la page N° 18
CDX6311 TROUBLESHOOTING SPECIFICATIONS Problem Cause Corrective Action Does not operate No power to yellow wire; Check connection with test light; (display does not no power to red wire check vehicle fuse with test light. light) Inline fuse blown Replace fuse. No power to unit Inline fuse blown Check/replace fuse. No speakers oper- Speaker harness not con- Connect speaker harness; check ate (display lights nected speaker wires. normally) Not all speakers Incorrect splices or con- Check all spl
Résumé du contenu de la page N° 19
CDX6311 12-MONTH LIMITED WARRANTY AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. To obtain repair or replacement within the
Résumé du contenu de la page N° 20
CDX6311 16
