Instruction d'utilisation JL Audio Stealthbox SB-GM-ESC/10W1v2/TN

Résumé du contenu de la page N° 1

SB-GM-ESC(ESV)/10W1v2 INSTR_SKU# 011303
INSTALLATION

D I F F I C U L T Y :

If you choose to perform the installation yourself, it is absolutely vital that
®
OUT
the Stealthbox be properly mounted to the vehicle according to these
OF
instructions. Failure to mount the enclosure properly presents two problems:
I N S T A L L A T I O N G U I D E
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
25
caused by the force exerted by the woofer(s).
SB-GM-E

Résumé du contenu de la page N° 2

SB-GM-ESC(ESV)/10W1v2 INSTR_SKU# 011303 S T E P 4 S T E P 8 The upper mount for the lift arm for the tailgate must be This is a side view of the Bracket shown in STEP 3 with the disconnected as shown in order to remove the trim panel. included hardware shown for illustration purposes. Install the 3/8-16 x 1-3/4” Hex Head Bolt through the Triangular The wiring harness that runs along the rear pillar has a white Plate as shown, tighten the Hex Nut that the arrow points towards. The hardwa

Résumé du contenu de la page N° 3

SB-GM-ESC(ESV)/10W1v2 INSTR_SKU# 011303 I N C L U D E D H A r D W A r E S T E P 1 2 1) Triangular Plate 1) Custom Bracket With the bottom of the Custom Bracket bolted in and 4) 1/4” Flat Washer 3) 3/8” Split Lock Washer aligned as described in Step 11 drill a hole through the 2) 1/4-20 x 1” Hex Head Bolt 2) 1/4” Split Lock Washer pillar corresponding with the upper hole in the Custom 2) 3/8-16 x 1 3/4” Hex Head Bolt 2) 3/8-16 Hex Nut Bracket as shown. 2) 1/4-20 Speed Nut 2) 1/4-20