Instruction d'utilisation JL Audio Stealthbox SB-GM-CLRDO/10W3v3/GA

Résumé du contenu de la page N° 1

➔
➔ ➔
➔ ➔
➔
➔
➔ ➔
®
Stealthbox
INSTALLATION GUIDE START
HERE
for the
SB-GM-CLRDO/10W3v3
(2004-Up Chevrolet Colorado & GMC
Canyon Crew Cab)
STEP 1: With an 18mm deep socket, STEP 2: There are two rear mounting nuts STEP 3: With the rear mounting nuts
remove the two front mounting nuts. that need to be removed.With a long exten- removed, tilt the rear seat forward, off the
sion and the 18mm deep socket. Remove the mounting studs.
Also remove the jack out of the metal holder.
rear mounting nuts.

Résumé du contenu de la page N° 2

➔ ➔ ➔ ➔ ➔ *CAUTION* Cont. Before drilling, make sure that you are not going to be From drilling into any gas lines, brake lines, transmission lines, Previous THREADED INSERT STEALTHBOX WALL Page electrical wiring, transfer case(4x4 vehicles) or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling. VEHICLE SHEET METAL With the use of a 1/2” drill bit and drill. Drill out the FENDER WASHER SOCKET CUP SET SCREW floor at the impression on the wax sq

Résumé du contenu de la page N° 3

➔ ➔ Ω ➔ Cont. From Previous Page CONGRATULATIONS! INSTALL COMPLETE. Included Hardware: STEP 11: With the shoulder belt through the bot- STEP 12: Flip the rear seat back into the up-right (1) Wax Square tom crease. Snap the belt back into the latch. position. (1) 2-14”Socket Cup Set Screw (1) Fender Washer (1) Flat Washer (1) Lock Washer (1) Hex Nut Difficulty Of Installation: Specifications: Mid/High Frequency Driver Information: Enclosure Type: Sealed Front Location Driver Size: Driver Type: