Résumé du contenu de la page N° 1
INSTRUCTION MANUAL
FM760
VACUUM CLEANER
Contents
IMPORTANT SAFETY INSTRUCTIONS
1
NAME OF EACH PART
3
PREPARATION BEFORE USE
4
USING THE VACUUM CLEANER
6
USING THE ATTACHMENTS 8
EMPTYING THE DUST COMPARTMENT
9
10
CLEANING THE FILTERS
CLEARING BLOCKAGES IN THE
11
SUCTIONHOSEANDCLEANINGTHE
AGITATORASSEMBLY
REPLACEMENTINSTRUCTIONS 12
TROUBLESHOOTING
16
REPLACEMENTPARTS 16
LIMITEDWARRANTY 17
HOUSEHOLD USE ONLY
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - To reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not allow
Résumé du contenu de la page N° 4
16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth which look as though they may cause the hose to become blocked. 20. Do not clean or store the vacuum cleaner in places where there are high temperatures. 21. Store the vacuum cleaner away from excessive humidity. 22. When carrying the vacuum cleaner, hold it b
Résumé du contenu de la page N° 5
NAME OF EACH PART FRONT REAR Handle Release Button C Suction Hose Release Button A Cord Storage Hooks Release Button B ON/OFF Switch Carrying Handle Crevice Tool Release Button D Upholstery Tool Dust Filter Cove r Compartment Wand Dusting Brush Power Cord Power Cord Plug Height Adjustment Rug/Floor (Tools) SELECTOR Headlight Lever Handle Release Lever Set the ON/OFF switch to " ON " to light the headlight. Cleaning Utensil Operate vacuum cleaner only at the voltage specified on name
Résumé du contenu de la page N° 6
PREPARATION BEFORE USE Caution: Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle Set the vacuum cleaner lnsert the handle 1 2 to the upright position. as shown in the illustration. Attaching the suction hose & attachments Wand Suction Hose Crevice Tool Hose Hook Upholstery Tool Dusting Brush 4
Résumé du contenu de la page N° 7
PREPARATION BEFORE USE WINDING THE POWER CORD Wind the power cord around the cord Hook the power cord over 1 2 storage hooks. the clip which is located on the upper cord storage hook as shown. Secure the power Plug side cord plug on the power cord. Cord Storage Hooks Clip RELEASING THE POWER CORD Return the hook to the Rotate the upper cord storage hook 2 1 downward. upright position before attempting to rewind the power cord. Upper Cord Storage Hook INSERTING T HE POWER CORD PLUG W
Résumé du contenu de la page N° 8
USING THE VACUUM CLEANER ON/OFF SWITCH Start or stop vacuum cleaner by pushing on the switch. ADJUSTING THE HANDLE The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal or Parallel. Place your foot on handle release lever as shown and pull back on the handle until it releases from its upright position. Handle Release Lever Normal position Upright position This position is used for normal cleaning. The handle is normally locked in this position for storage or w
Résumé du contenu de la page N° 9
USING THE VACUUM CLEANER HEIGHT ADJU STMENT LEVER Cautio n: Before using the height adj- ustment lever,please make Height Adjustment Lever sure the nozzle head is tilted backward from the floor. The nozzle head can be adjusted to four different Nozzle Head height settings. Set the height adjustment to the appropriate carpet length. rd Use the 3 ( )height setting. th Use the 4 ( )heigh t setting. RUG/FLOOR (TOOLS)SELECTOR The RUG/FLOOR(TOOLS)selector should only be adjusted
Résumé du contenu de la page N° 10
USING THE ATTACHMENTS Caution: When using one of the attachments during cleaning,set the vacuum cleaner to the upright position. Remove the attachments from the 1 vacuum cleaner. Press the release button C to Wand 2 disconnect the handle from the Release Crevice Tool Button C vacuum cleaner. Caution: When removing the attachments,pull Upholstery Tool them in the directions shown in the illustration.Pulling them in the wrong
Résumé du contenu de la page N° 11
EMPTYING THE DUST COMPARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning. Empty the dust compartment when Press the release button A meanwhile 2 2 1 1 press the release button B to remove contents reach the MAX mark. the dust compartment. Release Button A MAX mark Release Button B 3 Turn the spinner handle several times in the Press the release lever to open the 3 3 4 4 direction sho
Résumé du contenu de la page N° 12
CLEANING THE FILTERS Remove the dust compartment.(refer to page 9) 1 Set the dust compartment to the parallel 2 position.Open the trapdoor,then push the release button E and pull out the main filter. Release Button E The main filter and prefilter will be removed at the same time. Caution: Do not push the release button E at the upright position. As this may drop or damage the main filter and prefilter. Clean the main filter and prefilter wi
Résumé du contenu de la page N° 13
CLEARING BLOCKAGES IN THE SUCTION HOSE AND CLEANING THE AGITATOR ASSEMBLY Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before clearing any blockages in the suction hose and cleaning the agitator assembly. Clearing blockages in the suction hose Set the vacuum cleaner to the upright position. Hose Cuff 1 Remove the hose cuff from the suction inlet and thenremoveanyblockages
Résumé du contenu de la page N° 14
REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below. REPLACING THE HEADLIGHT LAMP Set the vacuum cleaner to the parallel position. 1 Loosen the screws to remove the lens. 2 Headlight Lamp Lens When removing the headlight lamp, be careful 3 not to pull on the headlight lamp wiring. Screw
Résumé du contenu de la page N° 15
REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below. REPLACING THE FLAT BELT Remove the bottom plate. 1 (refer to page 14) Lift out the agitator assembly,and then remove the flat belt from the motor shaft and 2 theagitatorpulley. Motor Shaft Flat Belt Agitator Assembly Place a new flat belt onto the motor shaft and pull
Résumé du contenu de la page N° 16
REPLACEMENT INSTRUCTIONS REMOVING THE BOTTOM PLATE Pull here Set the vacuum cleaner to the 1 parallel position and turn it over. Latch Slidethelatchinthedirection 2 ofthearrow. Removethebottomplatebypulling 3 thetabsasillustrated. Bottom Plate REATTACHING THE BOTTOM PLATE Insert the projection on the bottom plate Push the bottom plate as shown. 1 2 into the groove on the nozzle head Press and set the bottom plate in place. Press Bottom Plate Projection Groove Sl
Résumé du contenu de la page N° 17
REPLACEMENT INSTRUCTIONS REPLACING THE HEPA FILTER Under normal usage, the HEPA Filter will not require replacement; however, vacuuming large amounts of extremely fine dust, powder or similar material over a long period of time may decrease airflow performance through the filter. If this occurs, it may become necessary to replace the HEPA Filter. Only use genuine FANTOM replacement filters. Release button D 1 Press the release button D at points 1 1 and pull the
Résumé du contenu de la page N° 18
TROUBLESHOOTING If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord from the wall outlet, and contact FANTOM Customer Service at 1-800-275-9251. Or visit our website at www.fantom.com Problem Cause
Résumé du contenu de la page N° 19
ONE (1) YEAR LIMITED WARRANTY FANTOM warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid to In US: FANTOM, 94 Main Mill Str
