Instruction d'utilisation PYLE Audio PSWLE82

Résumé du contenu de la page N° 1

Pa Parrt t 5-Adjusting 5-Adjusting display display a and nd using using cor cord d management management
Route cords along articulating arms using cord management clips.
Articulating arms can be adjusted to position display into desired location.
Use wrench(8) to tighten and loosen the tension screw. Do not overtighten
or overloosen to make the screws come out.
INSTALLATION GUIDE
Item Item No.: No.:PSWLE82 PSWLE82
±180°
±180°
±180°
-5°~15°
Wrench
4x4
Wrench5x5
±5°
Thank Thank y you ou for for ch

Résumé du contenu de la page N° 2

Har Hard dwar ware e Kit: Kit: P Pa art rt 4-Mounting 4-Mounting the the flat flat panel panel scr screen een Hook the top of brackets(2) onto the center of wall plate(1). Then swing the 5 screen down. Fixed slide block(7) into wall plate by screw(6). 6 1 NOTE: NOTE: Always use an assistant or mechanical lifting equipment to safely lift 7 and position heavy equipment. 8 4 7 6 2 Magnetic removable 3 bubble level A-D E F G H Use the box wrench to loose the screw if there's too tight to tilt ID Qty

Résumé du contenu de la page N° 3

Pa Parrt t 3-Attaching 3-Attaching brack brackets ets t to o s scr creen een Pa Part rt 1a- 1a-W Wood ood Stud Stud Mounting Mounting Center brackets vertically on back of screen. Select the small(A),medium Usewall plate(1)asatemplate,makesureitislevel,andmarkfourmounting (B or C) or large(D) screws. Attach brackets to screen using four selected holes along the center lines of the wood studs. Drill four 3/16”(5mm)dia. screws and four square washers(E) at the top and bottom of each bracket. holes

Résumé du contenu de la page N° 4

Pa Parrt t 1b- 1b-C Concr oncrete ete Wa Wall ll Mounting Mounting P Pa art rt 2-Attaching 2-Attaching plastic plastic covers covers t to o wall wall plate plate Level wall plate(1) and use wall as a template to mark four holes. Drill four Secure plastic covers over wall plate by pushing them toward each other 3/8”” (10mm) dia. holes 2 (50mm) deep. Insert four anchors(H) into holes until they lock in place. and secure wall plate with four long bolts(G) and four washers(F).Tighten screws firmly.