Instruction d'utilisation PYLE Audio PSW116MF1

Résumé du contenu de la page N° 1

2
1
Step Step 3: 3: Hanging Hanging display display
Firstly lift the bracket mounted display over the wall mount. And then hook the
brackets over the top of the wall mount. Rotate the display let the bottom of the
brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe
bolts into the bottom of the brackets and lock it, as shown in Fig.3b.
Fixed Flat Panel TV Bracket
W Wa arning: rning: Some TV require two people to lift, as we are not responsible for any
personal injury or

Résumé du contenu de la page N° 2

Har Hard dwar ware e List: List: Actual parts appearance and the quantity may different After determining the height of stand, follow the installation instructions in below with illustrated. to install wall mount to different kinds of wall -wooden, concrete. UP UP 2 W Wooden ooden wall: wall: UP UP Using a awl or nail to make where the nails are located, as shown as fig.2b. Distance 1 between two nails for fixing wall mount must not less than 12”. Pre-drill these holes 3 with a 5mm drill bit to

Résumé du contenu de la page N° 3

Step Step 2: 2: Attach Attach mount mount to to wall wall WARNING First, determine the height of stand The best height of stand is parallel to eyelevel of a person who sitting on a couch. We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product. Normally, the horizontal distance of eyelevel is about 4’ from ground level. The following two conditions are for determining the perfect height of stand:

Résumé du contenu de la page N° 4

Following examples shows how to use bolts, spacers and square washers. 2. Some displays have curved backs with recessed mounting lands(Fig.a). It will 1.Some displays have vertical backs. No spacer is required. Install the bracket directly require the use of spacer. For this display, to the back of display by using bolts and square washers provided. As shown in Fig.1a. install a spacer(M) between display and the Fig a bracket. As shown in Fig 1b. M4 Fig bit M5 Fig bit M5 Fig bit M6 Fig bit I M M