Instruction d'utilisation Premier Mounts INW-42

Résumé du contenu de la page N° 1

I N S T A L L A T I O N M A N U A L




Inwall mount










































3130 E. Miraloma Ave. Anaheim, CA 92806 Phone: 800 368-9700 Fax: 800 832-4888

www.mounts.com


PREMIER MOUNTS ©2004/ REV 00

Résumé du contenu de la page N° 2

The wall structure should be capable of supporting a weight of at least five (5) times the display’s weight. If it cannot the wall must be reinforced. Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to. Failure to do so could result in serious personal injury. WARNING: Safety precaution measures must be practiced at all times during the installation of this product. Use proper

Résumé du contenu de la page N° 3

Assembly drawing Display Fan brackets In-wall plenum (not supplied) (1 supplied with inwall) box Mounting Bracket Decorative bezel (Sold separately) provided by Wood stud Air flow customer frame Wall structure - 3 -

Résumé du contenu de la page N° 4

Parts list All of these parts are used to install the mounting bracket. Make sure that none of these parts are missing before beginning installation. If there are parts missing stop the installation and contact Premier Mounts. INW42 Plenum INW50 Plenum INW60 Plenum (4) 6/32” Hex nuts (1) Muffin fan (3) 10/32” Kep nuts (1) Muffin fan bracket (4) 6/32” Phillips screws - 4 -

Résumé du contenu de la page N° 5

Opening the wall structure NOTE: It is assumed that the room ambient air temperature and conditions where the INW-series is to be incorporated is suitable to maintain an acceptable operating temperature for the display. It should also be noted that due to the shear size and weight of the large screen display when attached to the base pan it will have a natural slight down tilt characteristic to about 3 °. Raising the initial installation height of the pan or setting the base pan

Résumé du contenu de la page N° 6

Step 2 Partial “knock outs” are incorporated in the top and upper back on both sides of the base pan for bringing power and signal cables into the pan in accordance with code. Insert the pan fully (in the case of a standard 2 x 4-stud wall) or to the desired depth in a deeper wall structure. Secure the pan to the wood stud frame using nails or wood screws (commercially available). See figure 2. NOTE: A standard “handy box” extension ring can mount directly to the inside of the

Résumé du contenu de la page N° 7

Step 4 Install the ventilation assist fan (if used) on one of the three 10/32” thread mounting points in the top of the base pan with the three 10/32” nuts supplied. The fan supplied uses 110-volts A/C current and comes with “pig tail” ends. It is recommended the fan be wired to the same 110-volt A/C switch leg as the feeding power to the display. This will insure the operation during all times when the display is on. Install all power and signal interface cables. See figure 4.