Instruction d'utilisation Lucent Technologies 6225

Résumé du contenu de la page N° 1

6220 and 6225 Telephones
Quick Reference
Document Ordering No. 555-230-713
Comcode 108179540
Issue 1, June 1998

Résumé du contenu de la page N° 2

IMPORTANT INFORMATION SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS When you see this warning symbol on the The most careful attention has been devoted to quality standards ! product, refer to these instructions packed with in the manufacture of your new telephone. Safety is a major the product for more information before factor in the design of every set, but, safety is YOUR proceeding further in the installation process. responsibility too. Please read carefully the helpful tips listed bel

Résumé du contenu de la page N° 3

THE 6220 and 6225 TELEPHONES DATA jack Personalized Ring Power jack (on 6225 only) Ringer volume control Handset 10 Programmable Dialing buttons 6220 Pause button Program button Program Pause Tel.# Mute button and Mute light Message light Handset cord jack Mute Spkr Speakerphone button and Speakerphone light Handset volume control ABC DEF 1 2 3 GHI JKL MNO Flash button Flash 5 6 Dial pad 4 PQRS TUV WXYZ Redial Redial button 8 9 7 Hold button and Hold light Hold 0 # * LINE jack (on bottom of te

Résumé du contenu de la page N° 4

WALL INSTALLATION —— INSTALLATION —— Use the following directions to mount the telephone on a standard wallphone jack with mounting studs. TABLE/DESK INSTALLATION NOTE: For wall installation, do NOT unbundle the line cord Use the 7-foot straight line cord that came with your packaged with the telephone; that is, leave it in its telephone to connect the telephone to a modular jack. coiled position. 1. You must reverse the handset tab (which holds the ! WARNING: handset when you hang up). Se

Résumé du contenu de la page N° 5

9. Place the telephone against the wall jack mount and PERSONALIZED RING and RINGER VOLUME push down so that the base locks into the slots on the To select a personalized ringing pattern for your telephone. telephone 10. Plug the free end of the coiled handset cord into the There are two possible ringing patterns you may select for handset and hang up the handset. your telephone. 11. Lift the handset and listen for dial tone. 1. Move the switch to either of the two settings, . 12. Set th

Résumé du contenu de la page N° 6

• You hear a rapid error tone if you try to enter more than 24 elements, and you will exit Program mode FOR THE SYSTEM without saving the new number. • You can use the Pause button to program a MANAGER ONLY 1.5-second pause between a dialing access number, such as 9, and the telephone number, and for certain banking and long-distance services. • For example, to put a pause between the dialing access number, 9, and the telephone number, press the The following procedures should be Pause

Résumé du contenu de la page N° 7

INTERFERENCE INFORMATION — FCC Information — ! WARNING: FCC REGISTRATION AND REPAIR Some telephone equipment generates and uses radio INFORMATION frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s Your new Lucent Technologies telephone has been registered instructions, may cause interference to radio and with the Federal Communications Commission (FCC). This television reception. These telephones have been type product complies

Résumé du contenu de la page N° 8

Prepared by BCS Product Publications Lucent Technologies Copyright © 1998 Middletown, NJ 07748-9972 Lucent Technologies