Résumé du contenu de la page N° 1
XD 5 1 25
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver
Résumé du contenu de la page N° 2
XD5125 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove 2 transit screws located on top of the unit. • Remove trim ring by pulling up gently in the center. • In
Résumé du contenu de la page N° 3
XD5125 INSTALLATION Installation TYPICAL MOUNTING METHOD 3
Résumé du contenu de la page N° 4
XD5125 INSTALLATION Wiring Diagram 5 AMP FUSES When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XD5125 uses one 5 amp AGC fuse (Battery) and one 0.5 amp AGC fuse (Ignition) located in-line. * Caution - Do not attach any speaker leads to ground as severe damage will occur. 4
Résumé du contenu de la page N° 5
XD5125 OPERATION Control Locations 1 2 3 4 5 6 7 19 18 17 16 15 14 13 12 11 10 9 8 1 Release 10 EQ 2 Tuning 11 Display 3 12 Volume Up Track Up 4 13 Mode Track Down 5 14 Mute Mono/Stereo/CD Intro 6 Audio 15 Local/Distance/CD Repeat 7 Eject Loudness/CD Random 16 8 Auxiliary Input 17 Play/Pause 18 9 Band Volume Down 19 Power 5
Résumé du contenu de la page N° 6
XD5125 OPERATION General Operation Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Power On/Off Press P O W E R to turn the unit on. Inserting a CD will turn the unit on automatically. Press P O W E R to turn the unit off. Mode Press MODE to select between AM/FM, CD player or auxiliary input. Modes of operation are indicated in the display. Note: CD only appears when a CD is
Résumé du contenu de la page N° 7
XD5125 OPERATION General Operation Set the Clock Press and hold DISP until the clock begins to flash, then release. Press TRACK to adjust the hours and TRACK to adjust the minutes. Press DISP momentarily to save the selected time. Preset EQ Curves Press EQ to select between POP, CLASSIC, ROCK and OFF (default) equalization curves. The Bass and Treble settings are not adjustable when an EQ curve is selected. Audio Press AUDIO to select between Volume (de
Résumé du contenu de la page N° 8
XD5125 OPERATION Tuner Operation Tuning Turn the rotary encoder to tune the unit up or down and select the desired station. FM Mono/Stereo Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Local/Distance Press LOC during FM tuner operation to activate local tuning for strong station reception only. Press LOC again to cancel and resume Distance tuning (default). Band Press BAND to select between FM and AM bands. 8
Résumé du contenu de la page N° 9
XD5125 OPERATION CD Player Operation Insert CD With the label facing up, insert a disc into the CD slot. The CD will automatically begin playback. Eject CD Press the EJECT button to stop and eject CD. The unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc. Track Select Press TRACK to skip to the beginning of the next track. Press TRACK to return to the beginning of the current track. Pressing TRACK again
Résumé du contenu de la page N° 10
XD5125 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. What to do? You may also have other rights which vary from 1. Before you call for service, check the state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any custom Dual Electronics Corp. warrants this product to controls may save you a service call. the original purchaser to be free from defects in material and workmanship for a period of one 2. If you require servic
Résumé du contenu de la page N° 11
XD5125 OPERATION Specifications CD Player Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >50dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 15dBf 50dB quieting sensitivity: 23dBf Stereo separation @ 1kHz: 25dB Frequency response: 80Hz-10kHz AM Tuner Tuning range: 530kHz-1720kHz AM sensitivity: 30uV Frequency response: 80Hz-1.8kHz General Operating voltage: 11-16 VDC, negative ground Speaker output impedance: 4~8 ohms Fuses: 0.
Résumé du contenu de la page N° 12
XD5125 OPERATION Troubleshooting Problem Cause Action Unit will not Yellow or red wire not connected or Check connections for proper turn on incorrect voltage voltage (11~16VDC) (no power) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power Speaker wires not connected Check connections at speakers (but no sound) One or more speaker wires touching Insulate all bare speaker wires each other or touching chassis from each other and chassis groun
