Instruction d'utilisation Tripp Lite SmartRack SR

Résumé du contenu de la page N° 1

Owner’s Manual
™
SmartRack Accessories
Model: SRSWITCH
1 – Introduction 0 2
2
1-1 Parts List
2
1-2 Tools Required
2
2 – Important Safety Instructions
3 – SRSWITCH Installation 3
3
3-1 Mounting the Switch and Magnet to the Rack Enclosure
3
3-2 Wiring the Switch
4
4 – Connection to SNMPWEBCARD and ENVIROSENSE
4
5 – Warranty and Warranty Registration
1111 W. 35th Street, Chicago, IL 60609 USA
(773) 869-1234 • www.tripplite.com
Copyright © 2008 Tripp Lite. All rights reserved.
WARRANTY
REGISTRATION

Résumé du contenu de la page N° 2

1 – Introduction The SRSWITCH is designed to monitor rackmount enclosure door access and notify users when a door has been opened. The SRSWITCH must be used together with the following Tripp Lite accessories: SNMPWEBCARD and ENVIROSENSE (both available separately). 1-1 Parts List A1 A1 A4 Switch (1) A2 Magnet (1) A3 #22 AWG cable - 6 ft. (1.8 m) (1) A2 A4 Cable ties (6) A5 A3 A5 Adhesive cable tie holders (3) 1-2 Tools Required Screwdriver Wire Strippers Wire Cutters 2 – Important Safety

Résumé du contenu de la page N° 3

3 – SRSWITCH Installation The switch and magnet are designed to be mounted at the top of a SmartRack Premium Rack Enclosure. Magnet should be mounted flush against the inside edge of the Rack Enclosure door. Attach the switch to the outside of the Rack Enclosure cabinet and make sure both switch and magnet are in alignment. The switch and magnet should be mounted on the side of the enclosure opposite the hinges. Note: the switch and magnet do not need to make physical contact but should be no

Résumé du contenu de la page N° 4

4 – Connection to SNMPWEBCARD and ENVIROSENSE Security/Environmental Monitoring The SRSWITCH is for use only with Tripp Lite’s SNMPWEBCARD and ENVIROSENSE. The SNMPWEBCARD connects your UPS system or PDU to your Ethernet network as a manageable device that supports remote monitoring, remote control and remote condition reporting via Tripp Lite’s FREE PowerAlert software. The ENVIROSENSE environmental sensor relays ambient temperature and humidity readings to the SNMPWEBCARD installed in a comp