Instruction d'utilisation Home Automation 38A00-3

Résumé du contenu de la page N° 1

HAI UPB™ Lumina Mode Controller
Installation and Operating Instructions

For the following Model:

38A00-3 HAI UPB™ Lumina Mode Controller

READ THESE INSTRUCTIONS BEFORE INSTALLING DEVICE

This HAI UPB™ Lumina Mode Controller is intended for installation in accordance with the National Electrical Code and local
regulations. It is recommended that a qualified electrician perform this installation. Retain these instructions for reference.

This product is for indoor use

Résumé du contenu de la page N° 2

Changing Switch Color The color of the HAI UPB™ Lumina Mode Controller may be changed to complement the interior décor. The HAI UPB™ Lumina Mode Controller is supplied with a white bezel. Additional colors are available; contact your HAI distributor for more information. When changing the bezel, make sure that the HAI UPB™ Lumina Mode Controller is disconnected from all power, and proceed as follows: 1. The bezel attaches to the HAI UPB™ Lumina Mode Controller with two small Philips

Résumé du contenu de la page N° 3

HAI UPB™ LUMINA MODE CONTROLLER OPERATION Although the HAI UPB™ Lumina Mode Controller will perform differently once it is configured by the Lumina controller, the following describes the operation of the HAI UPB™ Lumina Mode Controller in its factory default configuration. The HAI UPB™ Lumina Mode Controller has six pushbuttons labeled AWAY, HOME, SLEEP, VAC, SPCL, and PARTY, which (by factory default) are used to control six lighting scenes. When the pushbutton labeled “AWAY” is pres

Résumé du contenu de la page N° 4

Setup Mode To configure the HAI UPB™ Lumina Mode Controller using a Lumina keypad, it must be put into Setup Mode as follows: Step Operation 1 Press and hold the “AWAY” and “HOME” pushbuttons simultaneously for at least 3 seconds. 2 All of the LED indicators will blink to indicate that the HAI UPB™ Lumina Mode Controller is in Setup Mode. Configuring the HAI UPB™ Lumina Mode Controller from a Lumina Keypad HAI UPB™ Lumina Mode Controllers reside on the 8th unit in any Room. Config