Résumé du contenu de la page N° 1
AT-S63 Version 3.1.0 Patch 1 Software Release Notes
AT-S63 Version 3.1.0 Patch 1
Management Software for the
AT-9400 Basic Layer 3 Gigabit Ethernet Switches
Software Release Notes
Please read this document before you begin to use the management software.
Supported Platforms
AT-S63 Version 3.1.0 Management Software is supported on the following AT-9400 Gigabit
Ethernet Switches:
Basic Layer 3 Models AT-9424T (AC)
AT-9424Ts (AC)
AT-9424Ts/XP (AC)
AT-9448T/SP (AC)
AT-9448Ts/XP (AC)
Note:
AT-9400 B
Résumé du contenu de la page N° 2
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Caution: The software described in the documentation contains certain cryptographic functionality and its export is restricted by U.S. law. As of this writing, it has been submitted for review as a “retail encryption item” in accordance with the Export Administration Regulations, 15 C.F.R. Part 730- 772, promulgated by the U.S. Department of Commerce, and conditionally may be exported in accordance with the pertinent terms of License Excepti
Résumé du contenu de la page N° 3
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Stacking Features supported in Version 3.1.0 Patch 1 The following features are supported across a stack Port statistics Port configurations Remote Telnet management Event log Spanning tree protocol (STP) Port-based and tagged VLANs All other features in the AT-S63 Management Software are automatically deactivated when a stack is powered on. Stacking Configuration Tips When stacking more than two switches, use the AT-9424Ts or AT-9424Ts
Résumé du contenu de la page N° 4
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Known Issues MAC address-based port security and the limited security mode. The limited security mode in MAC address-based port security is nonfunctional. (5327) Enhanced stacking. The AT-9400 Switch must have an IP address to be a slave switch in an enhanced stack. A routing interface that specifies the switch’s IP address has to be assigned to the common VLAN of the stack and the interface has to be designated as the switch’s local inte
Résumé du contenu de la page N° 5
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Stack Configuration limit with AT-9448Ts/XP as a “Master”. The AT-9448Ts/XP can act as the master in a stack of two switches only. The AT9424Ts or AT9424Ts/XP must be used as the master with three or more switches in a stack. IP Addressing and Routing. Although software will allow you to configure IP interfaces on any VLAN within the switch, only one IP address per stack is supported. Layer 3 switching is not supported. (6074) Forwarding
Résumé du contenu de la page N° 6
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Maximum bandwidth parameter in QoS policies. A QoS policy that has multiple traffic classes with different values for the maximum bandwidth parameter uses the lowest specified maximum bandwidth value for traffic flows that match more than one traffic class. (4137) VLAN ingress filtering. Untagged packets on the AT-9424Ts and AT-9424Ts/XP Switches may periodically cross VLAN boundaries and be retransmitted as tagged packets when the VLAN i
Résumé du contenu de la page N° 7
AT-S63 Version 3.1.0 Patch 1 Software Release Notes the Fault LED on the front panel of the switch to go off after saving a configuration change and before saving another configuration change. If you are in a different location from the switch and cannot view the Fault LED, wait 30 to 45 seconds between your save commands. (2683) Multiple VLAN modes and IPv4 packet routing. The 802.1Q-compliant and non-802.1Q- compliant multiple VLAN modes do not support IPv4 packet routing. You cannot confi
Résumé du contenu de la page N° 8
AT-S63 Version 3.1.0 Patch 1 Software Release Notes File upload or download. The switch’s response to management instructions may be slow while it uploads or downloads a file to the file system. Flow control and back pressure. Flow control and back pressure are operational among devices connected to ports 1 through 12 or ports 13 through 24 on the AT-9424T/GB and AT-9424T/SP switches, but not between devices connected to ports 1 through 12 and 13 through 24. (1321, 1322) Reserved multicas
Résumé du contenu de la page N° 9
AT-S63 Version 3.1.0 Patch 1 Software Release Notes other text editor that will not add formatting codes to the file. When saving the file, do not change the “.cfg” extension in the filename or save the file with formatting codes. Enhanced stacking. The IP address 172.16.16.16 is reserved for the enhanced stacking feature. Do not assign this address to any device in the same subnet as an enhanced stack. Login password. The maximum length of a login password is 16 alphanumeric characters for
Résumé du contenu de la page N° 10
AT-S63 Version 3.1.0 Patch 1 Software Release Notes 802.1x port-based network access control. Added the following authentication methods: — EAP-TLS (Extensible Authentication Protocol - Transport Layer Security) — EAP-TTLS (Extensible Authentication Protocol - Tunneled Transport Layer Security) — PEAP (Protected Extensible Authentication Protocol) Version 2.2.0: No new features. Version 2.1.1: The number of cooling fans in the AT-9424Ts switch was reduced from four to three. The AT-S63 Manage
Résumé du contenu de la page N° 11
AT-S63 Version 3.1.0 Patch 1 Software Release Notes activated if the ambient temperature exceeds 60° Celsius for five minutes, sends another SNMP trap, logs an error event message, and activates the Fault LED on the front panel. Version 1.3.0: Added the following new features to 802.1x port-based network access control: — Guest VLANs — VLAN Assignment and Secure VLAN features for supporting dynamic VLAN assignments with supplicant accounts. — MAC address-based authentication as an alternative
Résumé du contenu de la page N° 12
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Port trunking (IEEE 802.3ad) (static link aggregation, non LACP) Port security Port statistics (RMON) 1000 static MAC addresses, 16K dynamic MAC addresses, 256 static multicast addresses, 255 dynamic MAC addresses (snooping) Spanning Tree Protocol (IEEE 802.1D) Rapid Spanning Tree Protocol (IEEE 802.1w) Multiple Spanning Tree Protocol (IEEE 802.1s) Virtual LANs (IEEE 802.1Q) Protected ports VLANs Ingress filtering GARP VLAN Registra
Résumé du contenu de la page N° 13
AT-S63 Version 3.1.0 Patch 1 Software Release Notes BOOTP and DHCP Fan and temperature information CPU, Flash, and RAM information Power supply, redundant power supply, and transceiver information PN 613-000915 Rev A 13 Allied Telesis, Inc.
Résumé du contenu de la page N° 14
AT-S63 Version 3.1.0 Patch 1 Software Release Notes Contacting Allied Telesis This section provides Allied Telesis contact information for technical support as well as sales or corporate information. Online Support You can request technical support online by accessing the Allied Telesis Knowledge Base: www.alliedtelesis.com/support/kb.aspx. You can use the Knowledge Base to submit questions to our technical support staff and review answers to previously asked questions. Email and Telephone S
