Résumé du contenu de la page N° 1
MICRO COMPONENT MD SYSTEM
UX-Z7MDR—Consists of CA-UXZ7MDR and SP-UXZ7MD
TA/News/Info
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
LVT0900-003A
[B]
UX-Z7MDR[B]Cover_f 1 02.6.28, 13:53
Résumé du contenu de la page N° 2
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
Résumé du contenu de la page N° 3
CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus. • When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly. • Do not expose this apparatus to rain, moisture, dripping or splashing and
Résumé du contenu de la page N° 4
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE 2 WARNING LABEL INSIDE THE UNIT CAUTION: Invisible laser ADVARSEL: Usynlig laser- VARNING: Osynlig laser- VARO: Avattaessa ja suo- stråling ved åbning, når jalukitus ohitettaessa olet radiation when open and strålning när denna del är interlock failed or defeated. sikkerhedsafbrydere er ude öppnad och spärren är alttiina näkymättömälle af funktion. Undgå udsæt- lasersäteilylle. Älä katso AVOID DIRE
Résumé du contenu de la page N° 5
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Résumé du contenu de la page N° 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. About This Manual Power sources This manual is organized as follows: • When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord. • This manual mainly explains playback and editing operations using the remote control
Résumé du contenu de la page N° 7
Contents Location of the Buttons .................................. 3 Listening to External Equipment ................ 34 Main Unit ............................................................... 3 Listening to External Equipment ......................... 35 Remote Control ...................................................... 5 Adjusting the Audio Input Level .......................... 35 Getting Started................................................ 6 Recording ...............................
Résumé du contenu de la page N° 8
Location of the Buttons Become familiar with the buttons on your unit. Main Unit 1 e 2 r 3 4 t 5 y 6 u 7 i 8 o 9 ; p a q s w d f g Main unit See pages in the parentheses for details. p TAPE @ # (play) button (11, 13, 33) • Pressing this button also turns on the unit. 1 Disc tray (23) q SOUND button (14) 2 Display window (4) w Cassette holder (33) 3 REV.MODE button (28, 33, 42, 43) e Electronic swing panel 4 MD 0 (eject) button (11, 27, 29, 60) r MD loading slot (27) • Pressing this button also t
Résumé du contenu de la page N° 9
Display window on the electronic swing panel 4 9 - 1 2 3 56 7 8 0 = ~ ! Display window See pages in the parentheses for details. 1 CD indicator (24) 2 MD indicator (28) 3 MD recording indicators • MD REC indicator (39, 40, 43, 47 – 53, 55 – 58) • Recording length mode indicators (39) SP, LP2 and LP4 • Recording speed indicators (39) x1, x2 and x4 • Group recording indicator (39) GROUP 4 Tape operation indicators (33, 42, 43) • (reverse mode) and 2 3 (tape direction) 5 TAPE indicator (33) REC ind
Résumé du contenu de la page N° 10
Remote Control 1 Number buttons • 1 – 10, 0 and +10 buttons (12, 17, 18, 24, 28, 29, 47 – 49, 55 – 58) • Character entry buttons (A – Z, 0 – 9) (31, 59) • MARK button (31, 59) • and buttons (15, 31, 55, 59, 60) t 2 TITLE/EDIT button (55 – 59) 3 GROUP SKIP button (30, 48 – 53) y 1 4 GROUP TITLE/EDIT button (47 – 53, 59) u 5 GROUP SKIP button (30, 48 – 53) 6 LP: button (39) i 7 PTY SEARCH* button (19, 20) 2 PLAY MODE button (24, 25, 28 – 30) o 3 8 TA/News/Info* button (20) ; REPEAT button (25,
Résumé du contenu de la page N° 11
Getting Started Continued To connect an outdoor FM antenna Unpacking Before connecting it, disconnect the supplied FM antenna. After unpacking, check to be sure that you have all the following items. The number in the parentheses indicates the quantity of the pieces supplied. Outdoor FM antenna (not supplied) • FM antenna (1) • AM (MW/LW) loop antenna (1) • Remote control (1) • Batteries (2) If any is missing, consult your dealer immediately. Connecting Antennas FM antenna FM antenna (supplied)
Résumé du contenu de la page N° 12
AM (MW/LW) antenna Connecting Speakers To connect speakers 1 You can connect the speakers using the speaker cords. 1 2 Speaker terminals 2 3,4 Vinyl-covered wire (not supplied) Black SPEAKERS 3 Red Red R L R L CAUTION: SPEAKER IMPEDANCE 4~16Ω Black Black AM (MW/LW) loop antenna (supplied) 1 If cords are covered with insulation, twist the core of Speaker cord the cord at the end of each cord, then remove the insulation. 2 Connect the AM (MW/LW) loop antenna to the AM LOOP terminals as illustrated
Résumé du contenu de la page N° 13
To remove the speaker grilles Connecting External Equipment The speaker grilles are removable as illustrated below: You can connect another equipment which can be used as a playback device. Holes Projections When you connect and use the equipment, refer also to its manual supplied. • DO NOT connect other equipment while the power is on. • DO NOT plug in any equipment until all connections are complete. To connect external equipment Speaker grille Be sure that the plugs of the audio cords and the
Résumé du contenu de la page N° 14
NOW, you can plug in the unit and other connected Putting the Batteries into the Remote equipment FINALLY! Control Insert the batteries—R6P(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and –) on the batteries with the + and – marking on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 SPEAKERS R L R L CAUTION: SPEAKER IMPEDANCE 4~16Ω To a wall outlet 2 AC power cord When you connect the AC power cor
Résumé du contenu de la page N° 15
Basic and Common Operations The buttons emphasized in the illustration below are used and explained in this section (pages 11 to 15). Remote control TA/News/Info Main unit – 10 – EN10-15UX-Z7MDR[B]f 10 02.6.28, 13:46
Résumé du contenu de la page N° 16
Turning On the Power Setting the Auto Power Off When you press one of the source selecting buttons, the Using Auto Power Off function, the unit automatically unit automatically turns on (and starts playback if the turns itself off if no sound comes in for more than 3 source is ready). minutes except when FM or AM (MW/LW) is selected as the source. On the remote control: If any operation is done during this 3-minute period, Auto Power Off is canceled temporarily even though no sound comes in. On
Résumé du contenu de la page N° 17
Setting the Clock When you unplug the AC power cord or if a power failure occurs You can set the clock whether the unit is turned on or in The clock loses the setting and is reset to “0:00.” If this happens, standby mode. set the clock again. On the remote control ONLY: To turn off the clock indication (power save mode) 1 Press CLOCK/TIMER. Press DISP/CHARA while the unit is in standby mode. “0:00” appears in the main display with the hour digit “DISPLAY OFF” appears in the main display. flashin
Résumé du contenu de la page N° 18
Selecting the Sources and Starting Play Adjusting the Volume To select the tuner or external equipment as the source You can adjust the volume level only while the unit is On the remote control: turned on. Press FM/AM/AUX. • The volume level has no effect on recording. The unit automatically turns on (when the unit is in On the remote control: standby), and the last selected source appears in the main To increase the volume, press VOLUME + . display. To decrease the volume, press VOLUME – . • Ea
Résumé du contenu de la page N° 19
Reinforcing the Bass Sound Selecting the Sound Modes The richness and fullness of the bass sound is clearly You can select one of the 4 preset sound modes. maintained regardless of how low you set the volume • This effect does not affect recording. You can use this —Active Hyper Bass Pro. effect only for playback. • This effect does not affect recording. You can use this • This function also effects the sound from headphones. effect only for playback. To select the sound modes, press SOUND repea
Résumé du contenu de la page N° 20
To create your favorite colors Setting the Display Illumination You can create two favorite colors and store them in You can change the illumination color and brightness of the memory as “MANUAL1” and “MANUAL2.” electronic swing panel and the display window. • There is a time limit in doing the following steps. If the unit exits from the color adjusting mode before you finish, start from step 1 again. To select the illumination color You can select the illumination color by your preference. On t
