Résumé du contenu de la page N° 1
COMPACT COMPONENT SYSEM
FS-H35— Consists of CA-FSH35 and SP-UXH35
FS-H30— Consists of CA-FSH30 and SP-UXH30
COMPACT COMPONENT SYSTEM
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT0101-001B
[J]
COVER_FS-H30[J]ff.pm6 1 0
Résumé du contenu de la page N° 2
Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION— (standby/on) button! CAUTION Disconnect the mains plug to shut the power off completely RISK OF ELECTRIC SHOCK (all lamps and indications go off). The (standby/on) DO NOT OPEN button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY lamp lights CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, red. DO NOT REMOVE COVER (OR BACK).
Résumé du contenu de la page N° 3
Note to CATV system installer: For Canada/pour le Canada This reminder is provided to call the CATV system CAUTION: TO PREVENT ELECTRIC SHOCK, installer’s attention to Section 820-40 of the NEC MATCH WIDE BLADE OF PLUG TO WIDE SLOT, which provides guidelines for proper grounding and, FULLY INSERT. in particular, specifies that the cable ground shall be ATTENTION: POUR EVITER LES CHOCS connected to the grounding system of the building, as ELECTRIQUES, INTRODUIRE LA LAME LA PLUS close to the point
Résumé du contenu de la page N° 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord. This manual is organized as follows: • The manual mainly explains operations using the DO NOT handle the AC power cord w
Résumé du contenu de la page N° 5
Contents Location of the Buttons ............................................... 3 Main Unit .......................................................................... 3 Remote Control ................................................................. 5 Getting Started............................................................. 6 Supplied Accessories ......................................................... 6 Connecting Antennas ........................................................ 6 Connecti
Résumé du contenu de la page N° 6
Location of the Buttons Become familiar with the buttons on your unit. Main Unit Top view PHONES 1 2 COMPACT 7 DIGITAL AUDIO 3 8 TIMER/SNOOZE 4 OPEN 9 MULTI CONTROL ONE TOUCH AHB PRO REC 4 7 ¢ VOLUME BAND p 5 AUX TAPE TUNER CD 6 Front view q STANDBY r COMPACT COMPONENT SYSTEM w e t 3 EN01-13_FS-H30[J]f.pm6 3 03.2.5, 4:31 PM
Résumé du contenu de la page N° 7
Continued Display window 12 3 4 567 8 BASS SLEEP SNOOZE REC ON STEREO 9 OFF CLOCK MONO REC p q 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 PROGRAM RANDOM ALL OVER we r t See the pages in parentheses for details. Main unit Display window 1 PHONES jack (11) 1 Tape operation indicators REC 2 Disc cover • 2 3 (tape direction), (recording), and 3 TIMER/SNOOZE button (10, 20 – 22) (reverse mode) 4 ONE TOUCH REC (recording) button (18, 19) 2 (timer) indicator 5 (standby/on) button (11, 21) 3 REC (recordin
Résumé du contenu de la page N° 8
Remote Control See the pages in parentheses for details. 1 Number buttons 2 BASS button (11) 3 Multi control buttons STANDBY/ON • UP, 4 (reverse skip), 7 (stop), ¢ 1 2 3 (forward skip), and DOWN 8 4 SET button (13) 4 5 6 DISPLAY 5 Source buttons 9 • 3/8 CD, 2 3 TAPE, TUNER, and AUX 1 CLOCK 7 8 9 /TIMER Pressing one of these buttons also turns on the p unit. 10 10 SLEEP 6 REV.MODE (reverse mode) button (17 – 19) q 7 PRGM (program) button (15) UP BASS TREBLE 8 STANDBY/ON button (11, 21) w 2 9 DI
Résumé du contenu de la page N° 9
Getting Started Continued To connect an outdoor FM antenna Supplied Accessories Before connecting the antenna, disconnect the supplied FM antenna. Make sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. Outdoor FM antenna • AM loop antenna (1) (not supplied) • FM antenna (1) • AC power cord (1) • Remote control (1) Coaxial cable (not supplied) • Batteries (2) If anything is missing, consult your dealer immediately. Connecting A
Résumé du contenu de la page N° 10
AM antenna Connecting Speakers 1 12 Vinyl-covered wire (not supplied) Speaker cord Speaker cord 2 AM loop antenna (supplied) Right speaker Left speaker 1 Connect the AM loop antenna to the 1 Press and hold the clamp of the AM LOOP terminals as illustrated. speaker terminal on the rear of the unit. 2 Turn the AM loop antenna until you have the best reception. 2 Insert the end of the speaker cord into the terminal. Match the polarity between the unit and the To connect an outdoor AM antenna speake
Résumé du contenu de la page N° 11
Continued To remove the speaker grilles NOW you are ready to plug in the unit The speaker grilles are removable. and any other connected equipment. Projections IMPORTANT: Be sure to check all connections to be done before plugging the power cord. Holes This unit can be supplied with power through the AC IN connector (at home) or the DC IN connector (in a car). • Do not connect the unit using the AC IN connector and the DC IN connector at the same time for safe and correct use. Speaker grille
Résumé du contenu de la page N° 12
When using the unit in your car Putting the Batteries into the Remote Control To car’s cigarette lighter socket (12 V) Insert the batteries—R6(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and –) on the batteries with the + and – markings on the battery compartment. When the remote control can no longer operate the unit, replace both batteries at the same time. 1 12V 4A Car adapter DC IN (JVC model: CA-R120) R6(SUM-3)/AA(15F) 2 Connect a car adapter to the DC IN (12 V, 4 A)
Résumé du contenu de la page N° 13
Common Operations Continued Setting the Clock 3 Press ¢ or 4 to adjust the minute, then press TIMER/SNOOZE. Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, the CLOCK indicator and “AM 12:00” start flashing on the display. To check the clock time during play You can set the clock whether the unit is on or off. On the remote control ONLY: • There is a time limit in doing the following steps. If DISPLAY Press DISPLAY (grey-colored). the setting
Résumé du contenu de la page N° 14
Turning On the Power Adjusting the Tone (Bass/Treble) STANDBY/ON To turn on the unit, press You can adjust the bass level (low frequency range) STANDBY/ON (or on the unit). and the treble level (high frequency range) within a The STANDBY lamp on the unit goes off. range of –5 to +5. • When you press the source button When shipped, the bass level set to “BASS 0” and the —3/8 CD, 2 3 TAPE, TUNER (or treble level set to “TREBLE +1.” BAND TUNER on the unit) and AUX, the unit • This function only a
Résumé du contenu de la page N° 15
Listening to FM and AM Broadcasts Continued Tuning in to a Station Presetting Stations You can preset 30 FM and 15 AM stations—using TUNER either automatic presetting or manual presetting. 1 Press TUNER (or BAND In some cases, test frequencies have been already TUNER on the unit) to select memorized for the tuner since the factory examined the the band. tuner preset function before shipment. This is not a The unit automatically turns on and BAND malfunction. tunes in to the previously receive
Résumé du contenu de la page N° 16
To preset stations manually—Manual presetting To tune in to a preset station directly using the You need to preset stations separately for the FM and number buttons AM bands. On the remote control ONLY: • There is a time limit in doing the following steps. If 1 3 Pressing the number button(s) 2 the setting is canceled before you finish, start over allows you to select the preset from step 2. 4 5 6 number you want. Ex.: For preset number 5, press 5. 7 8 9 On the remote control ONLY: For preset nu
Résumé du contenu de la page N° 17
Playing Back Discs Continued This unit has been designed to play back the following 3 Close the disc cover gently. discs—CD, CD-R, and CD-RW. CD 4 Press 3/8 CD. When playing a CD-R or CD-RW The unit automatically turns on and the User-edited CD-Rs (CD-Recordable) and CD-RWs first track of the disc starts playing. (CD-ReWritable) can be played only if they are Track number Elapsed playing time already “finalized.” REC • Usually you can play back your original CD-Rs or CD-RWs recorded in music
Résumé du contenu de la page N° 18
Basic Disc Operations Programming the Playing Order of the Tracks—Program Play While playing a disc, you can do the following operations. You can arrange the order in which tracks play before you start playing. You can program up to 20 tracks. To stop playing for a moment During play, press 3/8 CD. CD On the remote control ONLY: While pausing, the elapsed playing time 1 Load a disc. flashes on the display. • If the current playing source is not the CD To resume playing, press 3/8 CD again. playe
Résumé du contenu de la page N° 19
To skip the current track, press ¢. To check the program contents • You cannot go back to the previous You can check the program track by pressing 4. contents by pressing ¢ or 4 before or after playback. To stop playing, press 7. • ¢ : To check the contents in the programmed order. • 4 : To check the contents in the reverse order. To exit from Random Play, press RANDOM RANDOM before or after playing. Random Play is canceled and Normal Play To modify the program resumes. On the remote control ONL
Résumé du contenu de la page N° 20
Playing Back Tapes You can play back type I tapes. If no cassette is inserted when you press 2 3 TAPE “NO TAPE” appears on the display. Playing Back a Tape To stop playing, press 7. 1 Press ) for cassette deck on the unit. The cassette holder opens. To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running. The tape direction indicator (3 or 2) starts flashing rapidly on the display. To remove the cassette, press ) on the unit. 2 Put a cassette in with the exposed part
