Résumé du contenu de la page N° 1
MICRO COMPONENT SYSTEM
UX-A52R — Consists of CA-UXA52R and SP-UXA52
- RDS -
COLOR DIMMER CONTROL STANDBY/ON
CLOCK
/TIMER FM MODE SLEEP
1 2 3
DISPLAY 4 5 6
PTY TA/NEWS DISPLAY
7 8 /INFO 9
–+ SELECT
SET 10 0 +10
CANCEL REV.MODE REPEAT PLAY MODE MICRO COMPONENT SYSTEM UX-A52R
CD FM/AM TAPE AUX/MD
STANDBY/ON
BEEP COMPACT
DIGITAL AUDIO
SOUND AHB
MODE PRO VOLUME
RM-SUXA52R
PHONES
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom
Résumé du contenu de la page N° 2
Warnings, Cautions and Others IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
Résumé du contenu de la page N° 3
CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the apparatus. • When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly. • Do not expose this apparatus to rain, moisture, dripping or splashing and
Résumé du contenu de la page N° 4
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE CLASS 1 LASER PRODUCT 1. CLASS 1 LASER PRODUCT 2. DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 3. CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel. 2 WARNING LABEL, PLACED INSIDE THE UNIT – G-3 – UX-A52R[B]_SAFETY_f 3 01.12.4, 7:57
Résumé du contenu de la page N° 5
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Résumé du contenu de la page N° 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. About This Manual Power sources • When unplugging the unit from the wall outlet, always This manual is organized as follows: pull the plug, not the AC power cord. • This manual mainly explains playback using the DO NOT handle the AC power cord with
Résumé du contenu de la page N° 7
Contents Location of the Buttons .................................. 3 Playing Back a CD ........................................ 20 Main Unit ............................................................... 3 Precautions on CD Playback ................................ 21 Remote Control ...................................................... 5 Playing Back the Entire CD—Normal Play ........ 21 Basic CD Operations ........................................... 22 Getting Started........................
Résumé du contenu de la page N° 8
Location of the Buttons Become familiar with the buttons on your unit. Main Unit Top view 1 e w 2 F M / A M AUX/MD AHB PRO STANDBY/ON COLOR VOLUME MODE select REC SLEEP start q 3 open/close TAPE C D open/close 4 p 5 9 6 7 8 Front view Display—indicators g f d PBC REC DAILY SOUND AHB o GROUP PRO ST MONO ; r PBC REC DAIRY SOUND AHB GROUP ST MONO PRO a s t MICRO COMPONENT SYSTEM UX-A52R STANDBY/ON COMPACT DIGITAL AUDIO i y PHONES u – 3 – EN01-09UX-A52R[B]_f 3 01.12.4, 7:48 PM
Résumé du contenu de la page N° 9
Continued See pages in the parentheses for details. Main unit Display—indicators 1 FM/AM button (11, 15) o Timer mode indicators (34 – 37) • Pressing this button also turns on the unit. • (Timer), DAILY (Daily Timer), and REC 2 COLOR button (9, 13) (Recording Timer) 3 STANDBY/ON button (11) ; CD indicator 4 CD open/close 0 button (21 – 23) • Lights when CD is in the disc tray. • Pressing this button also turns on the unit. a Tuner indicator 5 CD # ¥ 8 (play/pause) button (11, 21, 31) • Lights wh
Résumé du contenu de la page N° 10
Remote Control Remote control 1 DIMMER button (13, 34) 2 COLOR button (9, 13) 3 CLOCK/TIMER button (34 – 36) 4 DISPLAY button (16, 22, 26, 31, 32) 5 SET button (13, 15, 34 – 37) 6 REV. (reverse) MODE button (26) 1 d 7 CANCEL button (23, 34, 35) - RDS - s 8 FM/AM button (11, 15, 16) COLOR DIMMER CONTROL STANDBY/ON 2 • Pressing this button also turns on the unit. CLOCK a FM MODE SLEEP /TIMER 9 CD 3 ¥ 8 (play/pause) button (11, 21 – 24) 3 ; • Pressing this button also turns on the unit. 1 2 3 p Mu
Résumé du contenu de la page N° 11
Getting Started Continued Unpacking Putting the Batteries into the Remote Control Make sure that you have all the following items. The number in parentheses indicates the quantity of the Insert the batteries—R6P(SUM-3)/AA(15F)—into the pieces supplied. remote control, by matching the polarity (+ and –) on the batteries with the + and – marking on the battery • FM antenna (1) compartment. • AM (MW/LW) loop antenna (1) When the remote control can no longer operate the unit, • AC power cord (1) rep
Résumé du contenu de la page N° 12
ANTENNA AM EXT AM LOOP ANTENNA AM EXT AM LOOP FM(75 ) COAXIAL FM(75 ) COAXIAL ANTENNA AM EXT AM LOOP FM(75 ) COAXIAL AM (MW/LW) antenna Connecting Antennas FM antenna 12 FM antenna (supplied) Ω Vinyl-covered wire (not supplied) 1 Attach the FM antenna to the FM (75 Ω ) COAXIAL terminal. Ω 2 Extend the FM antenna. 3 3 Fasten it up in the position which gives you the best reception. About the supplied FM antenna The FM antenna supplied with this unit can be used as temporary AM (MW/LW) loop measur
Résumé du contenu de la page N° 13
Continued Connecting Speakers To remove the speaker grilles The speaker grilles are removable. To connect speakers You can connect the speakers by following the procedure Holes Projections below: 1 Speaker terminals 2 3,4 Speaker grille To remove the speaker grille, insert your fingers at the top of the speaker grille, then pull towards you. Do the same at the bottom. To attach the speaker grille, put the projections of the speaker grille into the holes of the speaker. SPEAKER IMPEDANCE Red MIN
Résumé du contenu de la page N° 14
To connect audio equipment with an optical digital Connecting Other Equipment input terminal You can connect both of the analog and digital equipment. You can record CD sound onto the connected digital When you connect and use the equipment, refer also to its equipment. manual supplied. Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and • DO NOT connect other equipment while the the OPTICAL DIGITAL OUT terminal. power is on. OPTIC
Résumé du contenu de la page N° 15
Basic and Common Operations Continued The buttons emphasized in the illustration below are used and explained in this section (pages 11 to 13.) Remote control COLOR DIMMER STANDBY/ON - RDS - COLOR DIMMER CONTROL STANDBY/ON CLOCK FM MODE SLEEP /TIMER 1 2 3 DISPLAY 4 5 6 PTY TA/NEWS DISPLAY –SELECT+ /INFO 7 8 9 10 0 +10 –+ SELECT SET 10 0 +10 SET CANCEL REV.MODE REPEAT PLAY MODE CD FM/AM TAPE AUX/MD CD FM/AM TAPE AUX/MD BEEP SOUND AHB MODE PRO VOLUME BEEP RM-SUXA52R SOUND AHB VOLUME MODE PRO
Résumé du contenu de la page N° 16
Turning On the Power Selecting the Sources and Starting Play When you press the play buttons (CD 3 / 8, TAPE 2 3) To select the tuner, press FM/AM. for a particular source or FM/AM and AUX/MD, the unit The unit automatically turns on (when the unit is on automatically turns on (and starts playback if the source is standby) and the last selected station is tuned in. ready.) Each time you press FM/AM, the band alternates between FM and AM (MW/LW.) To turn on the unit without playing, press • For m
Résumé du contenu de la page N° 17
Continued Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level while the unit is turned on. The richness and fullness of the bass sound is clearly The volume level has no effect on recording. maintained regardless of how low you set the volume— Active Hyper Bass PRO. You can select the bass effect To increase the volume, press VOLUME +. levels while the unit is turned on. The AHB PRO can be To decrease the volume, press VOLUME –. applied only to playback sounds, and ca
Résumé du contenu de la page N° 18
To adjust and register the color Setting the Display Illumination You can adjust the color by changing the tone, whiteness, brightness, and register into COLOR 1 to 7. You can change the color and brightness of the display • There is a time limit in doing the following steps. If the illumination. setting is canceled before you finish, start from step 1 again. To select the color pattern You can select the color pattern by your preference. On the remote control ONLY: While the unit is turned on,
Résumé du contenu de la page N° 19
Listening to FM and AM (MW/LW) Broadcasts The buttons emphasized in the illustration below are used and explained in this section (pages 15 to 19.) Remote control - RDS - FM MODE CONTROL - RDS - COLOR DIMMER CONTROL STANDBY/ON CLOCK FM MODE SLEEP /TIMER DISPLAY 1 2 3 DISPLAY 4 5 6 PTY TA/NEWS DISPLAY 7 8 /INFO 9 1 2 3 SET –+ SELECT SET 10 0 +10 4 5 6 CANCEL REV.MODE REPEAT PLAY MODE CD FM/AM TAPE AUX/MD FM/AM DISPLAY PTY TA/NEWS /INFO 7 8 9 BEEP SOUND AHB –+ SELECT VOLUME MODE PRO 10 0 +10 R
Résumé du contenu de la page N° 20
Tuning in a Station Presetting Stations You can preset 30 FM and 15 AM (MW/LW) stations 1 Press FM/AM repeatedly to select “FM” or “AM manually. (MW/LW).” The unit automatically turns on with the last selected In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset station. function before shipment. This is not a malfunction. You can • Each time you press the button, the band alternates preset the stations you want into memory by foll
