Résumé du contenu de la page N° 1
UX-Q3S[A]-01.fm Page 1 Wednesday, September 8, 2004 8:39 AM
MICRO COMPONENT SYSTEM
UX-Q3S
Consists of CA-UXQ3S and SP-UXQ1S
For hiding the demonstration
display, refer to page 9.
INSTRUCTIONS
LVT1218-005A
[A]
Résumé du contenu de la page N° 2
UX-Q3S[A]-02.fm Page 1 Wednesday, September 8, 2004 8:36 AM Introduction Warnings, Cautions and Others CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION — F button! Disconnect the mains plug to shut the power off completely. The F button in any position does not disconnect the mains line. The power can be remote controlled. CAUTION • Do not block the ventilation openings o
Résumé du contenu de la page N° 3
UX-Q3S[A]-02.fm Page 2 Wednesday, September 8, 2004 8:36 AM CAUTION — Proper Ventilation To avoid risk of electric shock and fire and to protect from damage, locate the apparatus as follows: Top/Front/Back/Sides: No obstructions should be placed in the areas shown by the dimensions below. Bottom: Place on the level surface. Maintain adequate air path for ventilation by placing on a stand with a height of 10 cm more. In addition, maintain the best possible air circulation. Front view
Résumé du contenu de la page N° 4
UX-Q3[A].book 1 ページ ２００４年９月８日 水曜日 午前１１時１５分 Table of Contents Introduction Listening to Other Equipment Notes on Operation .............................. 2 Listening to Other Equipment..............20 Special Cautions................................... 3 Recording Sound Notes on Handling................................... 3 Recording Sound to Supplied Accessories.............................. 3 Cassette Tapes ................................21 Preparation Convenient Functions Part Description.
Résumé du contenu de la page N° 5
UX-Q3[A].book 2 ページ ２００４年９月８日 水曜日 午前１１時１５分 Introduction Notes on Operation Listener's Etiquette Suitable Locations for the Main Unit When using headphones, keep the volume at a moderate level so as not to over-stimulate your To minimize the need for servicing and maintain ears. the high quality of this product, do not place the main unit in the following locations: ■When enjoying sound from the speakers, • In a position subject to high humidity or consid- adjust the volume to a suitable
Résumé du contenu de la page N° 6
UX-Q3[A].book 3 ページ ２００４年９月８日 水曜日 午前１１時１５分 Special Cautions Avoid high temperatures Notes on Handling Do not expose the system to direct sunlight and do not place it near a heating device. ■Important cautions When you are away Installation of the system When away on travel or for other reasons for an • Select a place which is level, dry and neither too extended period of time, disconnect the power hot nor too cold; between 5°C and 35°C. cord plug from the wall outlet. • Leave sufficient dis
Résumé du contenu de la page N° 7
UX-Q3[A].book 4 ページ ２００４年９月８日 水曜日 午前１１時１５分 Introduction Preparation The numbers refer to the pages in which the parts are explained. Part Description 12 14 12 16 11 19, 22 23, 25 11 13 17, 18 16 14 19 20 Cassette holder: 19 PUSH-OPEN 21 11, 14 9, 12 12 16 Remote control sensor: 5 11 16, 19 16, 22 CD tray: 16 16, 22 14, 16, 19 14, 16, 19 * This terminal is for connecting a pair of headphones equipped with a stereo mini plug (commercially avail- able). While the headphones are connected,
Résumé du contenu de la page N° 8
UX-Q3[A].book 5 ページ ２００４年９月８日 水曜日 午前１１時１５分 The numbers refer to the pages in which the parts are explained. Remote Control Inserting Batteries into the Remote Control 11 10,15, 17 10 17, 18, 24 15, 23 25 16, 22 16, 19 R6P(SUM-3)/ AA(15F) type dry-cell 16, 22 batteries (2) 19 14 16 20 19 14 17, 18 13 10, 23 23 11 17 11 11 12 11 13 12 11 CAUTION • Do not use a used battery and a new battery together. • Do not use different types of batteries at the same time. • Take out the batteries if th
Résumé du contenu de la page N° 9
UX-Q3[A].book 6 ページ ２００４年９月８日 水曜日 午前１１時１５分 Introduction Connect all necessary parts before connecting the power plug. Connections Connecting the Antennas ■When radio reception with the supplied AM Connecting the AM antenna loop antenna is poor 1 Set up the AM loop antenna Electric wire: 3 - 5 m (commercially available) (supplied). Twist together electric Stretch out the electric Insert the tab into wire and the AM loop wire horizontally, the slot. antenna cord. preferably in a high pl
Résumé du contenu de la page N° 10
UX-Q3[A].book 7 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Connect all necessary parts before connecting the power plug. Connections ■When radio reception with the supplied FM Connecting the FM antenna antenna is poor, or when using a communal antenna Main unit (side view) Main unit (rear view) Main unit FM antenna (rear view) (supplied) Main unit (side view) Antenna cord (sold Communal separately) antenna terminal or Stretch out the FM antenna to the best position for Outdoor FM antenna
Résumé du contenu de la page N° 11
UX-Q3[A].book 8 ページ ２００４年９月８日 水曜日 午前１１時１５分 Introduction Connecting the Speakers After connecting the speakers, gently pull on the There is no difference between the left and right speaker cords to make sure the cords are firmly speakers. connected and do not pull out. Main unit (rear view) Speaker cord Speaker cord Speaker cord Red Black Red Black Left speaker (rear view) Right speaker (rear view) CAUTION • Do not short-circuit the and speaker termi- nals. Doing so may damage the speaker
Résumé du contenu de la page N° 12
UX-Q3[A].book 9 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Connect all necessary parts before connecting the power plug. Connections Connecting Other Equipment Connecting the Power Plug AC outlet Main unit (rear view) Read this section when connecting other audio equipment to this product. Other audio equipment • After making all other necessary connections, connect in the power plug. Demonstration display function When you connect the power plug into the AC out- let, "DEMO START!" appears
Résumé du contenu de la page N° 13
UX-Q3[A].book 10 ページ ２００４年９月８日 水曜日 午前１１時１５分 Basic Operations Basic Operations • You can use the number buttons to specify About this manual the hour. • This manual explains the operations Refer to "Using the number buttons" shown assuming that you will use the remote con- below. trol. Some buttons on the main unit are the same as those on the remote control. You can use either button in this case. • Some diagrams in this manual are simpli- fied or exaggerated for the purpose of ex
Résumé du contenu de la page N° 14
UX-Q3[A].book 11 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Basic Operations Turning On/Off the Main Unit Sound Mode Press . Press (or on the main unit). • Each time you press , the display tog- • With the power off, pressing either button gles as follows. turns on the main unit. : For sharp sound. Remote control: Main unit: : For soft sound. Pressing one of these buttons other than changes the sound source. When a : For background music. CD or cassette tape has been loaded, play-
Résumé du contenu de la page N° 15
UX-Q3[A]-05.fm 12 ページ ２００４年９月２１日 火曜日 午後４時３７分 NOTE Changing the Color Patterns • While the sound mode is activated, "NO OPER- for the Display Window and ATE" is displayed and you cannot adjust the sound quality ( page 11). CD Tray Canceling the sound mode returns both the bass and treble sounds to "0". Press (or on the main unit). α Sound • Each time you press , the display tog- gles as follows. Press . : For a rainbow-like • Each time you press , the display tog- pattern. gles as
Résumé du contenu de la page N° 16
UX-Q3[A].book 13 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Basic Operations Auto Standby 3 Press to adjust the intensity of If no sound is produced for 3 or more minutes when the CD or cassette tape is selected as a the component color. sound source, the main unit automatically turns off. • You can adjust the color intensity within the range "0" to "3". ■When the CD or cassette tape is selected You cannot set all three component colors as a sound source (red, green, and blue) to "0" at t
Résumé du contenu de la page N° 17
UX-Q3[A].book 14 ページ ２００４年９月８日 水曜日 午前１１時１５分 Listening to Radio Broadcasts Listening to Radio Broadcasts This product can receive FM and AM radio broad- casts. Selecting a Radio Station Number buttons 1 Press to select "FM" or "AM". Example: Display while an FM radio broadcast is received. Stereo indicator Preset number ( page 15) Frequency 2 Press or repeatedly to select a radio station (frequency). • You can also select a radio station using the automatic tuning. Automatic tuning: Hold
Résumé du contenu de la page N° 18
UX-Q3[A].book 15 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Listening to Radio Broadcasts Storing Radio Stations (Preset) You can store up to 30 FM radio stations and up to 15 AM radio stations. ■While the broadcast from the radio station you want to preset is being received 1Press . • The preset number flashes for approxi- mately 5 seconds. 2 While the preset number is flash- ing, press the number buttons ( - or ) to select the preset number you want to use. • Refer to "Using the number but
Résumé du contenu de la page N° 19
UX-Q3[A].book 16 ページ ２００４年９月８日 水曜日 午前１１時１５分 Listening to CDs Listening to CDs This product can play back CDs and finalized CD- 2 Place a CD on the CD tray. Rs/CD-RWs (recorded in audio CDs or MP3 for- mat). Number buttons • When you want to listen to an 8 cm CD, place it on the inner hollow of the CD tray. 3Press . ■Display during CD playback CD indicator (The CD indicator lights up while the CD is stopped. The CD indicator flashes while the CD is being played back or paused.) Elapsed playi
Résumé du contenu de la page N° 20
UX-Q3[A].book 17 ページ ２００４年９月８日 水曜日 午前１１時１５分 (Continued) Listening to CDs Specifying the Track (Direct Program Playback Track Selection) This function allows you program up to 50 tracks. Press the number buttons to select 1 Press , and then press . the track you want to listen to. • Refer to "Using the number buttons" ( page 2 Press to select "PROGRAM". 10). CD or MP3 Repeat Playback This function allows you to repeatedly listen to the same track. During CD playback, press repeat- edly to
