Résumé du contenu de la page N° 1
MICRO COMPONENT SYSTEM
UX-P6R — Consists of CA-UXP6R and SP-UXP6.
UX-P5R — Consists of CA-UXP5R and SP-UXP5.
UX-P4R — Consists of CA-UXP4R and SP-UXP4.
UX-P3R — Consists of CA-UXP3R and SP-UXP3.
COMPACT
COMPACT
DIGITAL AUDIO DIGITAL AUDIO
CD-R/R W PLA YBACK CD-R/R W PLA Y BACK
STANDBY/ON
STANDBY/ON
MICRO COMPONENT SYSTEM UX·P6R MICRO COMPONENT SYSTEM UX·P5R CLOCK
CLOCK
STANDBY / ON
STANDBY / ON
AHB PRO
AHB PRO
CD TAPE FM/AM MD/AUX CD TAPE FM/AM MD/AUX
/ /
STANDBY/ON STANDBY/ON
DIRECT OPERATING
D
Résumé du contenu de la page N° 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. CLAS
Résumé du contenu de la page N° 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Résumé du contenu de la page N° 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Résumé du contenu de la page N° 5
Contents Location of the Buttons and Controls ....................... 3 Playing Back CDs (CD/CD-R/CD-RW) .................. 14 Front Panel ................................................................. 3 Playing Back the Entire CD — Normal Play ........... 14 Remote Control .......................................................... 5 Basic CD Operations ................................................ 14 Programming the Playing Order of the Tracks Getting Started..............................
Résumé du contenu de la page N° 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel 1 q COMPACT w DIGITAL AUDIO 2 UX-P6R CD-R/R W PLA YBACK UX-P5R STANDBY/ON e UX-P4R UX-P3R r STANDBY MICRO COMPONENT SYSTEM CLOCK 3 t STANDBY / ON 4 5 AHB PRO y CD TAPE FM/AM 6 / DIRECT OPERATING FUNCTION VOLUME SOUND TIMER u 7 8 i UX-P6R UX-P5R o MD/AUX ; REV.MODE UX-P4R a UX-P3R s AUX REC REC d AUTO REVERSE PHONES 9 f p (ONLY FOR UX-P6R and UX-P5R) – 3 – EN01-13.UX-P5
Résumé du contenu de la page N° 7
Continued Display Window 2 1 3 4 [ ] DAILY REC SLEEP REC RDSEON TA NEWS INFO CLOCK PRGM RANDOM ALL BASS SOUND MONOST 5 6 7 8 9p See pages in the parentheses for details. Front Panel Display Window 1 Remote sensor 1 Tape operation indicators 2 For UX-P6R and UX-P5R: STANDBY/ON lamp (9) •2 3 (tape direction) and (reverse mode) For UX-P4R and UX-P3R: STANDBY lamp (9) indicators 3 (STANDBY/ON) button (9, 16, 21) 2 Timer indicators 4 TAPE 2 3 button (9, 17, 18) • (timer), DAILY, REC and SLEEP in
Résumé du contenu de la page N° 8
Remote Control UX-P6R UX-P4R and and STANDBY/ON STANDBY/ON UX-P5R UX-P3R 1 1 t r DIMMER DISPLAY SLEEP DISPLAY SLEEP 2 y 2 t 3 MD/AUX AUX PROG RANDOM REPEAT PROG RANDOM REPEAT 3 4
u y 5 SOUND AUTO AUTO FM/AM 4 SOUND FM/AM MODE PRESET FM MODE PRESET FM MODE MODE 6 5 i u TAPE TAPE 7 6 CD CD 8 o 7 i CD CD 9 8 ; o p a 9 ; q p CANCEL MULTI KEY SET CANCEL MULTI KEY SET w q s a DISPLAY PTY DISPLAY PTY MODE /EON MODE /EON d s e w AHB AHB VOLUME VOLUME PRO PRO f d r e UX-P6R and UX-P5R UX-P4R and UX-P3R
Résumé du contenu de la page N° 9
Continued Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) FM antenna (supplied) • Remote control (1) • Batteries (2) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control Insert the batteries — R6(SUM-3)/AA(15F) — into the 1 Attach the FM antenna to the FM 75 W remo
Résumé du contenu de la page N° 10
AM (MW/LW) antenna Connecting Speakers 2 ] ] 1 3 ANTENNA Vinyl-covered wire (not supplied) For UX-P6R and UX-P5R 1 Red AM EXT AM LOOP RIGHT LEFT MAIN SPEAKERS Speaker Speaker cord cord FM 75 SPEAKER IMPEDANCE COAXIAL MIN 6 Black For UX-P4R and UX-P3R Red RIGHT LEFT MAIN SPEAKERS Speaker Speaker cord cord 2 SPEAKER IMPEDANCE MIN 4 Black AM loop antenna (supplied) 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. • If the AM loop antenna wire is covered with Right Left vinyl,
Résumé du contenu de la page N° 11
To remove the speaker grilles For UX-P4R and UX-P3R AUX (ONLY FOR UX-P6R and UX-P5R) RL The speaker grilles are removed as the illustrations below. Holes Projections To audio output Audio equipment For playing the other equipment through this unit, connect between the audio output jacks on the other Speaker grille equipment and AUX jacks by using audio cords (not supplied). To connect audio equipment with an optical digital input terminal (ONLY FOR UX-P6R and UX-P5R) To remove the speaker grille
Résumé du contenu de la page N° 12
Common Operations Turning On the Power 2 Press ¢ or 4 to adjust the hour, then press CLOCK. When you press the play button — CD 3/8, TAPE 2 3, or The minute digits start flashing on the the source selecting button — FM/AM, and MD/AUX (UX- display. P6R and UX-P5R) or AUX (UX-P4R and UX-P3R), the unit CLOCK automatically turns on and starts playback if the source is ready. CLOCK To turn on the unit, press (STANDBY/ON). For UX-P6R and UX-P5R: The STANDBY/ON lamp on the unit lights green. 3 Press ¢
Résumé du contenu de la page N° 13
Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned You can reinforce the bass sound to maintain rich (“AHB 1” on. The volume level can be adjusted between “VOLUME 0” and “AHB 2”), full bass at low volume. This function only and “VOLUME40.” affects the playback sound, but does not affect your recording. VOLUME When using the remote control, press VOLUME + to increase the volume or To get the effect, press AHB (Active Hyper AHB PRO press V
Résumé du contenu de la page N° 14
Listening to FM and AM (MW/LW) Broadcasts Tuning in a Station 3 Repeat steps 1 and 2 to store stations for the other band. 1 Press FM/AM. FM/AM The unit automatically turns on and tunes in the previously tuned station (either FM or AM When you cannot automatically store stations you want — MW/LW). Stations with weak signals cannot be detected with this automatic • Each time you press the button, the band presetting. To store such a station, use the manual presetting. alternates between FM and AM
Résumé du contenu de la page N° 15
Continued Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned to an FM station which prov
Résumé du contenu de la page N° 16
Switching to a Program Type of Your Choice How the EON function actually works: Temporarily CASE 1 By receiving EON (Enhanced Other Networks) data sent by If there is no station broadcasting the program you FM RDS stations, the EON function allows the unit to switch have selected temporarily to a broadcast program of your choice (TA, The unit continues tuning in the current station. NEWS, and INFO) from a different station. Ç • The EON function only works when you are listening to a When a stati
Résumé du contenu de la page N° 17
Continued Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: 3 Press CD 3/8. CD •CD The disc tray automatically closes and the first • CD-R track of the CD starts playing. • CD-RW Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the Track number Elapsed playing time unit. • The CD automatically stops when the last track of the CD has finished playing. General Notes To stop playing, press 7. In general, you will have the best
Résumé du contenu de la page N° 18
To check the program contents Programming the Playing Order of the Tracks PROG You can check the program contents by — Program Play pressing PROG on the remote control. The programed tracks are shown in the You can arrange the order in which tracks play before you programed order. start playing. You can program up to 20 tracks. To modify the program On the remote control ONLY: CANCEL Before or after playing, you can erase the last 1 Load a CD. programed track by pressing CANCEL on the • If the c
Résumé du contenu de la page N° 19
Playing at Random — Random Play Prohibiting Disc Ejection — Tray Lock The tracks will play in no particular order when you use this You can lock the disc tray and prohibit to eject the CD. mode. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: RANDOM To use Random play mode, press RANDOM To prohibit disc ejection, press before or during playing. (STANDBY/ON) while holding 7. (If the The RANDOM indicator lights up on the display. disc tray is open
Résumé du contenu de la page N° 20
Playing Back Tapes You can play back type I, type II, and type IV tapes without To stop playing, press 7. changing any settings. To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running. The tape direction indicator (2 or 3) starts flashing quickly Playing Back a Tape on the display. To remove the cassette, press 0 for cassette deck. 1 Press 0 for cassette deck. To play both sides — Reverse Mode You can set the deck to play just one side of a tape, both sides once, or
