Résumé du contenu de la page N° 1
COMPACT COMPONENT SYSTEM
KOMPAKT-KOMPONENTEN-SYSTEM
SYSTEME DE COMPOSANTS COMPACT
KOMPACTO KOMPONENTEN-SYSTEEM
SISTEMAS DE COMPONENTES COMPACTOS
IMPIANTO A COMPONENTI COMPATTO
CA-MXJ950R
COMPACT
DIGITAL AUDIO
CD
TAPE
FM/AM
AUX
INSTRUCTIONS
For Customer Use:
BEDIENUNGSANLEITUNG
Enter below the Model No. and Serial
No. which are located either on the rear,
MANUEL D'INSTRUCTIONS
bottom or side of the cabinet. Retain this
GEBRUIKSAANWIJZING
information for future reference.
MANUAL DE INSTRUCCION
Résumé du contenu de la page N° 2
Warnings, Cautions and Others / Warnung, Achtung und sonstige Hinweise / Mises en garde, précautions et indications diverses / Waarschuwingen, voorzorgen en andere mededelingen / Avisos, precauciones y otras notas / Avvertenze e precauzioni da osservare IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extensio
Résumé du contenu de la page N° 3
CAUTION VOORZICHTIG To reduce the risk of electrical shocks, fire, etc.: Ter vermindering van gevaar voor brand, elektrische schokken, enz.: 1. Do not remove screws, covers or cabinet. 1. Verwijder geen schroeven, panelen of de behuizing. 2. Do not expose this appliance to rain or moisture. 2. Stel het toestel niet bloot aan regen of vocht. ACHTUNG PRECAUCIÓN Zur Verhinderung von elektrischen Schlägen, Brandgefahr, usw: Para reducir riesgos de choques eléctricos, incendio, etc.: 1. Keine Schraub
Résumé du contenu de la page N° 4
Caution: Proper Ventilation Voorzichtig: Goede ventilatie vereist To avoid risk of electric shock and fire, and to prevent damage, locate Om brand, elektrische schokken en beschadiging te voorkomen, moet the apparatus as follows: u het toestel als volgt opstellen: 1 Front: 1 Voorkant: No obstructions and open spacing. Geen belemmeringen en voldoende ruimte. 2 Sides/ Top/ Back: 2 Zijkanten/boven-/onderkant: No obstructions should be placed in the areas shown by the Geen belemmeringen plaatsen in
Résumé du contenu de la page N° 5
IMPORTANT FOR LASER PRODUCTS / WICHTIGER HINWEIS FÜR LASER-PRODUKTE / IMPORTANT POUR LES PRODUITS LASER / BELANGRIJKE INFORMATIE VOOR LASERPRODUKTEN / IMPORTANTE PARA LOS PRODUCTOS LÁSER / IMPORTANTE PER I PRODOTTI LASER REPRODUCTION OF LABELS/ANBRINGUNGSORTE FÜR LASER-PRODUKTE/REPRODUCTION DES ETIQUETTES/VERKLARING VAN DE LABELS/REPRODUCCIÓN DE ETIQUETAS/RIPRODUZIONE DELLE ETICHETTE 1 CLASSIFICATION LABEL, PLACED ON REAR ENCLOSURE 2 WARNING LABEL, PLACED INSIDE THE UNIT 1 KLASSIFIKATIONSETIKETT
Résumé du contenu de la page N° 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet hand
Résumé du contenu de la page N° 7
Contents Location of the Buttons and Controls ....................... 3 Playing Back Tapes ................................................... 18 Front Panel ................................................................. 3 Playing Back a Tape ................................................. 18 Remote Control .......................................................... 5 Locating the Beginning of a Song — Music Scan ... 18 Getting Started.........................................................
Résumé du contenu de la page N° 8
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel j Powered Rolling Panel o k ; l a / s z Press PANEL OPEN/ d x CLOSE to open the panel. f c To close the panel, press g v the button again. b h n Front Panel 1 p 2 q 3 w e 5 6 r 7 t y 8 u i 9 – 3 – EN01-14.CA-MXJ950R[E]/f 3 00.2.1, 10:08 AM English
Résumé du contenu de la page N° 9
Continued Display Window 1 2 34 56 1 2 3 7 8 9 p q See pages in the parentheses for details. l SEA CONTROL button (11) / PROGRAM/RANDOM button (16, 17, 20) Front Panel z EDIT button (21) x REPEAT button (17) 1 Disc trays c DISPLAY button (9) 2 (Standby/On) button and STANDBY lamp (9) v SOUND MODE button (10) 3 Display window b CANCEL button (9, 17, 22) 4 SUBWOOFER VOLUME control (10) DEMO button (8) 5 Remote sensor n RDS operation buttons (13) 6 TAPE 2 3 button and lamp (9, 18) • DISPLAY MODE, P
Résumé du contenu de la page N° 10
Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (15) Pressing one of these buttons also turns on the unit. 2 SOUND MODE button (10) 3 Number buttons (12, 16) 4 RDS operation buttons (13) w 1 • DISPLAY MODE, PTY/EON, and SELECT – / + buttons 2 e 5 PROGRAM/RANDOM button (16, 17, 20) 6 REC START/STOP button (19, 21) 7 TAPE A/B button (18) 3 81 / 4 (fast left/reverse search) button (16 – 18) 9 SUBWOOFER + / – buttons (10) p CD £´8 button (9, 15) r Pressing this button also tu
Résumé du contenu de la page N° 11
Getting Started Continued Unpacking Connecting Antennas After unpacking, check to be sure that you have all the FM antenna following items. The number in the parentheses indicates the quantity of the pieces supplied. FM antenna (supplied) • AM (LW/MW) loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If any is missing, consult your dealer immediately. Putting the Batteries into the Remote Control 1 Attach the FM antenna to the FM 75 W Insert the batteries — R6(SUM-3)/AA(15F)
Résumé du contenu de la page N° 12
AM (LW/MW) antenna Connecting Speakers 1 2 3 2, 3 1 Vinyl-covered wire ANTENNA (not supplied) AM EXT Blue AM LOOP Speaker Speaker cord cord FM 75 COAXIAL (blue/black) (blue/black) Red Black AM (LW/MW) loop antenna (supplied) Black 1 Connect the AM (LW/MW) loop antenna to Speaker cord the AM LOOP terminals as illustrated. (red/black) 2 Turn the AM (LW/MW) loop antenna until you have the best reception. To connect an outdoor AM (LW/MW) antenna When reception is poor, connect a single vinyl-covered
Résumé du contenu de la page N° 13
1 Press and hold the clamp of the speaker To connect audio equipment with an optical digital terminal on the rear of the unit. input terminal You can record CD sound onto the connected digital equipment. 2 Insert the end of the speaker cord into the terminal. Match the polarity (color) of the speaker terminals: » to » and á to á. Protective plug 3 Release the finger from the clamp. IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of t
Résumé du contenu de la page N° 14
Common Operations Turning On or Off the Power 4 Press 4 or ¢ to adjust the minute, then press SET. To turn on the unit, press so that the STANDBY lamp goes off. The Powered Rolling Panel opens automatically. To check the clock time To turn off the unit (on standby), press Press DISPLAY while playing any source. again so that the STANDBY lamp lights up. • Each time you press the button, the source indication and the clock time alternate on the display. The Powered Rolling Panel also closes. To
Résumé du contenu de la page N° 15
Continued Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned The SUBWOOFER VOLUME control provided for this unit on. can enhance the subwoofer sound if subwoofers are connected to the rear of this unit (see page 7). Turn the VOLUME control clockwise to This function only affects the playback sound, but does not increase the volume or counterclockwise affect your recording. to decrease it. • The volume level can be adjusted in 32 steps (M
Résumé du contenu de la page N° 16
Surround modes *: 2 Adjust the SEA pattern. D.CLUB: Increases resonance and bass. HALL: Adds depth and brilliance to the sound. 1) Press 4 or ¢ to select the STADIUM: Adds clarity and spreads the sound, like in an frequency range to adjust outdoor stadium. (LOW, MID, HIGH). SEA (Sound Effect Amplifier) modes: 2) Press 1 or Á to adjust the ROCK: Boosts low and high frequency. Good for level (–3 to +3) of the selected acoustic music. frequency range. POP: Good for vocal music. CLASSIC: Good for cl
Résumé du contenu de la page N° 17
Listening to FM and AM (LW/MW) Broadcasts Tuning in a Station 2 Press SET. 1 Press FM/AM. The unit automatically turns on and tunes in the previously tuned station (either FM or AM — LW/MW). The Powered Rolling 3 Press PRESET – / + to select a Panel automatically opens. preset number. • Each time you press the button, the band alternates between FM and AM (LW/MW). 2 Start searching for stations. On the unit: 4 Press SET again. Press and hold TUNING – / + for more than 1 second. On the remote con
Résumé du contenu de la page N° 18
Receiving FM Stations with RDS RDS allows FM stations to send an additional signal along Searching for Programs by PTY Codes (PTY with their regular program signals. For example, the stations Search) send their station names, as well as information about what type of program they broadcast, such as sports or music, etc. One of the advantages of RDS is that you can locate a particular kind of program by specifying the PTY codes. When tuned to an FM station which provides the RDS • For details on
Résumé du contenu de la page N° 19
Switching to a Program Type of Your Choice How the EON function actually works: Temporarily CASE 1 By receiving EON data sent by FM RDS stations, the EON If there is no station broadcasting the program you function allows the unit to switch temporarily to a broadcast have selected program of your choice (TA, NEWS, and INFO) from a The unit continues tuning in the current station. different station. Ç • The EON function only works when you are listening to a When a station starts broadcasting the
Résumé du contenu de la page N° 20
Playing Back CDs Loading CDs Playing Back the Entire Discs — Continuous Play On the unit ONLY: You can play CDs continuously. 1 Press 0 for the disc tray (CD1 to 3) you want to load a CD onto. 1 Load CDs. The unit automatically turns on and the disc tray comes out. The Powered Rolling Panel 3 2 Press one of the disc number also opens automatically. buttons (CD1, CD2, and CD3) for 2 the disc you want to play. 2 Place a disc correctly on the circle of the disc 1 CD play starts from the first track
