Résumé du contenu de la page N° 1
O
N
S
C
R
E
E
®
AUDIO/VIDEO CONTROL RECEIVER
AV&'
RX-80PGD
RM-SR80U REMOTE CONTROL
TV VCR DVD AUDIO
POWER POWER MULTI POWER
VIDEO1 VIDEO2 VCR1 TAPE/VCR
TVSOUND FM/AM CD PHONO
DELAY CNTR
DVD MENU
13 2
CD TEST ENTER REAR (L)
DISC
46 5
VCD EFFECT (REAR R) DESIGNED BY JVC JAPAN
DISC
MASTER VOLUME
RX-80P AUDIO/VIDEO CONTROL RECEIVER
7/P 8 9 VIDEO1 VIDEO2 VCR1 TAPE/VCR DVD TV SOUND FM AM CD PHONO
VCR SEA MODE DAP MODE SURR MODE
CONTROL
10 0 +10
ONE TOUCH
RETURN FM MODE/MUTING OPERATION
–+
Résumé du contenu de la page N° 2
& Warnings, Cautions and Others / Caution –– POWER switch! Disconnect the mains plug to shut the power off completely. The &' * POWER switch in any position does not disconnect the mains line. &' ** The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. &' * 2. Do not expose this appliance to rain or moisture. 1.&' * 2.
Résumé du contenu de la page N° 3
Caution: Proper Ventilation &' To avoide risk of electric shock and fire and to protect from damage. &' * Locate the apparatus as follows: &' Front: No obstructions open spacing. &' Sides: No obstructions in 10 cm from the sides. Top: No obstructions in 10 cm from the top. 10&' Back: No obstructions in 15 cm from the back 10&' Bottom: No obstructions, place on the level surface. 15&' In addition, maintain th
Résumé du contenu de la page N° 4
Table of Contents Getting Started........................................................................................................................... 2 Before Installation .................................................................................................................... 2 Checking the Supplied Accessories ......................................................................................... 2 Switches, Buttons and Controls .............................................
Résumé du contenu de la page N° 5
Getting Started This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply. Before Installation General • Be sure your hands are dry. • Turn the power off to all components. • Read the manuals supplied with the components you are going to connect. Locations • Install the receiver in a location that is level and protected from moisture. • The temperature around the receiver must be between –5˚ and 35˚ C . • Make sure there is good
Résumé du contenu de la page N° 6
Switches, Buttons and Controls Become familiar with the main switches and controls on your receiver before use. 12 34 5 6 7 8 DESIGNED BY JVC JAPAN MASTER VOLUME RX-80P AUDIO/VIDEO CONTROL RECEIVER VIDEO1 VIDEO2 VCR1 TAPE/VCR DVD TV SOUND FM AM CD PHONO ONE TOUCH OPERATION –+ SOURCE DAP/SURROUND MODE SEA MODE DVD MULTI DAP/SURROUND/DVD MULTI SEA MEMORY ADJUST ADJUST SETTING TUNER MEMORY STANDBY VIDEO 2 SPEAKERS PHONES VIDEO LR AUDIO 12 POWER _ON ÑOFF 9 qw e r tyu i o p Refer to the pages in p
Résumé du contenu de la page N° 7
O N S C R E E Remote Control Remote Control Unit ; TV POWER and VCR POWER buttons (46, 47) RM-SR80U REMOTE CONTROL TV VCR DVD AUDIO POWER POWER MULTI POWER a Source selecting buttons (13) ; k s CD DISC button (45) VIDEO1 VIDEO2 VCR1 TAPE/VCR d VCD DISC button (47) TVSOUND FM/AM CD PHONO f VCD CONTROL button (47) g Remote control mode selector (TV / VCR / TUNER / CD / a DELAY CNTR DVD MENU 13 2 DVD / VCD, SOUND CONTROL) (12, 24) CD TEST ENTER REAR (L) DISC h MUTING button (14) 46 5 s VCD EFFECT
Résumé du contenu de la page N° 8
Connecting the FM and AM Antennas FM Antenna Connections 3 1 2 Extend the FM wire antenna horizontally. FM Antenna ANTENNA If reception is poor, connect the outside antenna. 4 Outside FM Antenna Wire FM Before attaching a 75Ω coaxial cable (the kind (75 ) with a round wire going to an outside antenna), FM GND disconnect the supplied FM antenna. 2 1 3 10 mm GND AM LOOP AM EXT 20 mm How to strip the 75Ω coaxial cable and connect it to the FM terminals 1. Strip back the outside covering of the 7
Résumé du contenu de la page N° 9
RIGHT 1 RIGHT 1 RIGHT 1 Connecting the Speakers You can connect the following speakers: • Two pairs of front speakers to produce normal stereo sound. • One pair of rear speakers to enjoy the surround effect. • One center speaker to produce more effective surround effect (to emphasize human voices). • One subwoofer to enhance the bass. For each speaker (except for subwoofer), connect the black (–) and red (+) terminals on the rear panel to the black (–) and red (+) terminals marked on the speaker
Résumé du contenu de la page N° 10
Connecting the rear and center speakers Cut, twist and remove the insulation at the end of each speaker signal cable first, and then, connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals by using the cables. 1 Open the terminal and then insert the speaker signal cable. CENTER REAR SPEAKER SPEAKERS RIGHT LEFT Center speaker 2 Close the terminal. Left rear speaker Right rear speaker Note: You can register the center speaker size after you finish
Résumé du contenu de la page N° 11
Connecting Audio/Video Components You can connect the following audio/video components to this receiver using cables with RCA pin plugs (not supplied). Refer also to the manuals supplied with your components. If you want to connect a component not listed in the table below, refer to the manual supplied with it. Audio Components Video Components • Turntable • DVD (Digital Video Disc) player • CD player • VCD (Video CD) player • Cassette deck • TV • VCR(s) • Video camera Notes: • If you connect a
Résumé du contenu de la page N° 12
Video component connections If your video components have S-video (Y/C-separation) terminals, connect them using S-video cables (not supplied). Connecting these video components through the S-video input/output terminals will give you can get better picture playback quality. IMPORTANT This receiver is equipped with both the composite video and S-video input/output terminals for connecting video components. You do not have to connect both the composite video and S-video terminals. However, remem
Résumé du contenu de la page N° 13
VCR and Video CD player connection Video CD player To composite video output GND AUDIO VIDEO To audio output RIGHT LEFT RIGHT LEFT PHONO VIDEO1 To S-Video input (for better playback picture quality) TV MONITOR CD SOUND OUT To composite video input VCR OUT OUT (REC) (REC) To audio input TAPE VCR1 VHS VCR IN IN (PLAY) (PLAY) To audio output FRONT DVD To composite video output DVD OUT To S-Video output (for better playback picture quality) CENTER Note: When connecting an audio/video component (ex.:
Résumé du contenu de la page N° 14
Connecting the Power Cord Before plugging the receiver into an AC outlet, make sure that all connections have been made. When the power cord is connected, the STANDBY lamp above the POWER button lights up. Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may cause noise or screen interference. We recommend that you use a coaxial cable to connect the antenna, since it is well-shielded against interference. Notes: • A small amount of power is always
Résumé du contenu de la page N° 15
Basic Operations The following operations are commonly used when you play any sound source. TV / VCR / TUNER / CD / DVD / VCD IMPORTANT When using the Remote Control, check to see if its remote control mode selector is set to the “TV SOUND / VCR / TUNER / CD / DVD / VCD” position. CONTROL Turning the Power On and Off On the front panel: STANDBY To turn on the power, press POWER. POWER The STANDBY lamp goes off. The name of the current source appears on the display. Current source name appears Vo
Résumé du contenu de la page N° 16
From the remote control: DVD MULTI Press one of the Source selecting buttons you want. DVD Play back a stereo digital video disc. VIDEO1 VIDEO2 VCR1 TAPE/VCR DVD MULTI Play back a digital video disc using the analog discrete output mode (5.1 CH reproduction) TVSOUND FM/AM CD PHONO on the DVD player. Each time you press the button, the DVD MULTI playback mode turns on and off. DVD VIDEO1 Play back a video source on the video component connected to the VIDEO1 jacks. VIDEO2 Play back a video sou
Résumé du contenu de la page N° 17
Listening with Headphones A standard pair of headphones can be connected to the PHONES jack on the front panel. To listen with only headphones, press both SPEAKERS 1 and 2 to set them in the ÑOFF position. No sound comes out of the front speakers. CAUTION: Be sure to turn down the volume before connecting or putting on headphones, as high volume can damage both the headphones and your hearing. Muting the Sound From the remote control only: To mute the sound through all the speakers and headphone
Résumé du contenu de la page N° 18
Basic Settings Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier. See also page 37. MENU Adjusting the Front Speaker Output Balance If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance. On the front panel only: SETTING 1. Press SETTING so that the Control % / Þ / @ / # buttons work for adjusting the balance. The lamp next to the
Résumé du contenu de la page N° 19
See also page 38. MENU Using the Sleep Timer Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night. On the front panel only: 1. Press SETTING so that the Control % / Þ / @ / # buttons work for setting the Sleep Timer SETTING The lamp next to the button lights up. 2. Press Control % / Þ until “” appears on the display. 3. Press Control @ / # to set the shut-off time. Each time you press the button, the shut-off time on
Résumé du contenu de la page N° 20
See also page 38. MENU Selecting the Center Speaker Size You can register the information on the center speaker after all connections are completed. If you do this registration first, you do not have to adjust the center speaker mode when you want to activate the surround sound. However, to register the information, first you have to turn on the surround mode. (You cannot select the center speaker size when the surround mode is off.) On the front panel only: DAP/SURROUND MODE 1. Press DAP/SURROU
