Résumé du contenu de la page N° 1
RX-N600
RX-N600_U_cv.fm Page 1 Wednesday, May 24, 2006 4:36 PM
U
AUDIOTRONIC MITSUBISHI 81393 THORENS 81189
81189 MYRYAD 81189, 81918
TOSHIBA 80135
TAPE DECK
AUDIOVOX 81627 NAD 80320
VICTOR 80074
AIWA 70029, 70197 B & K 80701, 80820, NAKAMICHI 80347, 81313,
WARDS 80014, 80054,
CARVER 70029 80840 81555, 81919
80158, 80189
DENON 70076 BEL CANTO DESIGN NIRO 81908
XM 81406, 81414
HARMAN/KARDON 81584 ONKYO 80135, 81320
YAMAHA 80176, 81176,
70029, 70182 BK 80702 OPTIMUS 80177, 80219,
JVC 70244,
Résumé du contenu de la page N° 2
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS 10 Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the CAUTION product and to protect it from overheating, and these RISK OF ELECTRIC SHOCK openings must not be blocked or covered. The openings DO NOT OPEN should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS d) If the product does not operate normally by following 24 Outdoor Antenna Grounding – If an outside antenna or the operating instructions. Adjust only those controls cable system is connected to the product, be sure the antenna that are covered by the operating instructions as an or cable system is grounded so as to provide some improper adjustment of other controls may result in protection against voltage surges and built-up static charges. damage and will of
Résumé du contenu de la page N° 4
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual 16 Install this unit near the AC wall outlet where the power carefully. Keep it in a safe place for future reference. cable plug can be reached easily. 2 Install this sound system in a well ventilated, cool, dry, clean 17 Be sure to read the “TROUBLESHOOTING” section on place – away from direct sunlight, heat sources, vibration, common operat
Résumé du contenu de la page N° 5
BASIC SOUND FIELD ADDITIONAL ADVANCED OPERATION PROGRAMS INFORMATION INTRODUCTION PREPARATION OPERATION CONTENTS FM/AM TUNING..................................................46 INTRODUCTION Automatic tuning ..................................................... 46 Manual tuning.......................................................... 47 FEATURES............................................................. 2 Automatic preset tuning........................................... 48 GETTING STARTED.
Résumé du contenu de la page N° 6
FEATURES FEATURES Built-in 6-channel power amplifier iPod controlling capability ◆ Minimum RMS output power ◆ DOCK terminal to connect a YAMAHA iPod universal dock (20 Hz to 20 kHz, 0.06% THD, 8 Ω ) (such as YDS-10 sold separately), which supports iPod (Click Front: 95 W + 95 W and Wheel), iPod nano, and iPod mini Center: 95 W Network features Surround: 95 W + 95 W ◆ LAN port to connect a PC and YAMAHA MCX-2000 or Surround back: 95 W access the Internet radio via a LAN Sound field programs ◆
Résumé du contenu de la page N° 7
INTRODUCTION GETTING STARTED GETTING STARTED Supplied accessories Installing batteries in the remote control Check that you received all of the following parts. Remote control AM loop antenna 1 3 CODE SET TRANSMIT POWER POWER STANDBY POWER TV AV MD SLEEP CD CD-R XM CBL MULTI CH IN DVD DTV TUNER DOCK USB V-AUX DVR NET AMP 2 SOURCE TV VOL TV CH VOLUME TV TV MUTE TV INPUT MUTE STEREO MUSIC ENTERTAIN MOVIE 1 2 3 4 STANDARD SELECT EXTD SUR. DIRECT ST. 5 6 7 8 SPEAKERS ENHANCER NIGHT STRAIGHT Indoor
Résumé du contenu de la page N° 8
CONTROLS AND FUNCTIONS CONTROLS AND FUNCTIONS Front panel Note The XM Satellite Radio controlling functions in the following buttons (SEARCH MODE, CATEGORY, PRESET/TUNING/CH l / h, MEMORY, and DISPLAY) are only applicable to the U.S.A. and Canada models and are operational only when “XM” is selected as the input source. For details, see “XM Satellite Radio controls and functions” on page 55. 14 2 356 78 90 A VOLUME ZONE 2 ZONE ON/OFF CONTROL MASTER PRESET/TUNING FM/AM A/B/C/D/E l PRESET/TUNIN
Résumé du contenu de la page N° 9
INTRODUCTION CONTROLS AND FUNCTIONS 8 TUNING MODE (AUTO/MAN’L) E STRAIGHT (EFFECT) Switches between automatic tuning (the AUTO indicator Turns the sound field programs off or on. When the is turned on) and manual tuning (the AUTO indicator is “STRAIGHT” mode is selected, 2-channel or multi- turned off) (see page 46). channel input signals are output directly from their respective speakers without effect processing (see 9 ZONE 2 ON/OFF page 39). Turns on Zone 2 or sets it to the standby mode
Résumé du contenu de la page N° 10
CONTROLS AND FUNCTIONS Remote control This section describes the function of each control on the remote control used to control this unit. To operate other components, see “REMOTE CONTROL FEATURES” on page 93. Notes The operation mode of the remote control buttons in the shaded area below depends on the component selector switch position. Set the component selector switch to AMP to control this unit. To control the TUNER functions, set the component selector switch to SOURCE and then press
Résumé du contenu de la page N° 11
INTRODUCTION CONTROLS AND FUNCTIONS 6 ENHANCER Notes Turns on or off the Compressed Music Enhancer mode (see page 37). To set the remote control codes for other components, see page 95. 7 LEVEL When you set the remote control codes for both DTV/CBL and Selects the speaker channel to be adjusted and sets the (see page 95), priority is given to the one set for DTV/ output level (see page 36). CBL. 8 Cursor buttons u / d / j / i, ENTER G MUTE Select and adjust the sound field program param
Résumé du contenu de la page N° 12
CONTROLS AND FUNCTIONS ■ Controlling the TUNER functions ■ Using the remote control Set the component selector switch to SOURCE and then The remote control transmits a directional infrared ray. press TUNER to select “TUNER” as the input source. Be sure to aim the remote control directly at the remote control sensor on this unit during operation. 4 Numeric buttons Use numbers 1 through 8 to select preset stations. (U.S.A. model) 7 BAND Switches the reception band between FM and AM. VOLUME ZONE 2
Résumé du contenu de la page N° 13
INTRODUCTION CONTROLS AND FUNCTIONS Front panel display Note The XM indicator is only applicable to the U.S.A. and Canada models and the cursor on the left of the XM indicator lights up only when “XM” is selected as the input source. For details, see “Basic XM Satellite Radio operations” on page 57. 13 2 4 568 79C 0AB 96 pNET pDVR pV-AUX pDTV/CBL pDVD pMD/CD-R pTUNER pCD pXM t 24 VOLUME USB DOCK AUTO TUNED STEREO MEMORY MATRIX DISCRETE VIRTUAL SILENT CINEMA SP dB ENHANCER STANDARD A B ZONE2 NIG
Résumé du contenu de la page N° 14
CONTROLS AND FUNCTIONS C VOLUME level indicator Indicates the current volume level. D PCM indicator Lights up when this unit is reproducing PCM (Pulse Code Modulation) digital audio signals. E STANDARD indicator Lights up when the “SUR. STANDARD” or “SUR. ENHANCED” program is selected. F SP A B indicators Light up according to the set of front speakers selected. G Headphones indicator Lights up when headphones are connected. H ZONE2 indicator Lights up when Zone 2 is turned on (see page 99). I
Résumé du contenu de la page N° 15
INTRODUCTION CONTROLS AND FUNCTIONS Rear panel 1 2 3 45 6 7 8 9 0 A AUDIO AUDIO MULTI CH INPUT OUTPUT DIGITAL DIGITAL INPUT XM DOCK LAN OUTPUT CENTER MD/CD-R MD/CD-R DVD DTV/CBL DVD Y PB PR Y PB PR IN MD/ OUT SUB SUB SURROUND WOOFER WOOFER OPTICAL OPTICAL COAXIAL CD (PLAY) CD-R (REC) FRONT ZONE 2 DVD DVR DTV/ CBL IN OUT IN OUT DVD DTV/CBL DVR MONITOR DVD DTV/CBL DVR MONITOR MONITOR OUT OUT OUT COMPONENT VIDEO VIDEO S VIDEO TUNER SPEAKERS FM ANT FRONT SURROUND AM 75Ω ANT GND UNBAL. A REMOTE CONTR
Résumé du contenu de la page N° 16
CONNECTIONS CONNECTIONS Placing speakers * The speaker layout below shows the standard ITU-R Front left and right speakers (FL and FR) speaker setting. You can use it to enjoy CINEMA DSP and The front speakers are used for the main source sound plus multi-channel audio sources. effect sounds. Place these speakers at an equal distance from the ideal listening position. The distance of each * ITU-R is the radio communication sector of the ITU speaker from each side of the video monitor should
Résumé du contenu de la page N° 17
PREPARATION CONNECTIONS Connecting speakers Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION Before connecting the speakers, make sure that this unit is turned off (see page 28). Do not let the bare speaker wires touch each other or do not let them touch any met
Résumé du contenu de la page N° 18
CONNECTIONS FRONT terminals Connect one or two sets of front speakers (1, 2) to these terminals. If you use only one front speaker system, connect it to the FRONT A or B terminal. 1 CENTER terminals 7 Connect a center speaker (3) to these terminals. 4 2 3 SURROUND terminals Connect surround speakers (4, 5) to these terminals. 5 6 SURROUND BACK terminals Connect a surround back speaker (6) to these terminals. SUBWOOFER OUTPUT jack Connect a subwoofer with a built-in amplifier (7) (such as Spea
Résumé du contenu de la page N° 19
PREPARATION CONNECTIONS ■ Connecting the speaker cable ■ Connecting the banana plug (except Europe model) The banana plug is a single-pole electrical connector 1 Remove approximately 10 mm (0.4 in) of widely used to terminate speaker cables. insulation from the end of each speaker cable and then twist the exposed wires of the Banana plug cable together to prevent short circuits. 10 mm (0.4 in) 1 Tighten the knob. 2 Loosen the knob. Red: positive (+) Black: negative (–) Red: positive (+) Blac
Résumé du contenu de la page N° 20
CONNECTIONS Information on jacks and cable plugs Audio jacks and cable plugs Video jacks and cable plugs COMPONENT VIDEO AUDIO DIGITAL AUDIO DIGITAL AUDIO VIDEO S VIDEO Y PB PR L R COAXIAL OPTICAL (White) (Red) (Orange) (Yellow) (Green) (Blue) (Red) S O V PB PR Y L R C Left and right Coaxial Optical Composite S-video Component analog audio digital audio digital video cable cable plug video cable cable plugs cable plug audio cable plug plugs plug ■ Audio jacks ■ Video jacks This unit has three
