Instruction d'utilisation Chamberlain TCR2

Résumé du contenu de la page N° 1

®
®
TRICODE TCR2 DUAL
CHANNEL RECEIVER
USED FOR TCR1 AND TCR2
WARNING WARNING
SPECIFICATIONS
CAUTION WARNING
Output Rating: 5 Amps 28Vac/Vdc Max.
To prevent possible SERIOUS INJURY or DEATH from electrocution:
Power: 12Vdc or 18 to 34Vac/Vdc, @ 30ma
• Be sure power is NOT connected BEFORE installing the receiver.
RF Frequency: 300 or 310 MHz
To prevent possible SERIOUS INJURY or DEATH from a moving
Accessory Transmitters: TC1, TC2 and TC4
gate or garage door:
• ALWAYS keep transmitters

Résumé du contenu de la page N° 2

POWER SWITCH SETTINGS NOTE: To avoid the possibility of duplicating codes in adjacent Power Supply Selection Setting ® systems, all transmitters and receivers should be re-coded prior The TriCode receiver is factory set for 24 volt power input if to operation. Unless using maximum number of codes the 12 volt is required. following four codes should not be used: · All DIP Switches ON Remove back cover of receiver by removing screws. Set jumper · All DIP Switches OFF to the 12 volt setting (Figure

Résumé du contenu de la page N° 3

OUTPUT RELAYS & CONFIGURATION SWITCH SETTINGS Setting Output Relay Mode Setting the Configuration Switch ® ® TM The TriCode receiver is factory set for momentary relay output The TriCode receiver is factory set for Linear/Delta-3 . “MNT”. Locate the configuration switch and set it to the desired RF mode • Momentary mode: The output relay will be on for .5 seconds of operation (Figures 2 and 3). Modes are as follows: TM TM before turning off. Linear/Delta-3 : works with all “Linear/Delta-3 ” tr

Résumé du contenu de la page N° 4

DIP SWITCH SETTINGS & POWER CONNECTIONS Setting DIP Switch Power Supply and Relay out Connections ® The TriCode Receiver DIP switch CH1 is factory set OFF (1-10) There are six wires exiting the housing (Figure 6): and CH2 is factory set ON (1-10). RED & BLACK - POWER INPUT Locate the 10 position DIP switch. If this is a new installation BROWN & BLUE - CHANNEL 1 RELAY OUTPUT ® using TriCode transmitters, randomly set switches matching WHITE & GREEN - CHANNEL 2 RELAY OUTPUT those of the transmitte