Instruction d'utilisation Warwick AMPs

Résumé du contenu de la page N° 1

OFFICIAL WARWICK
AMP OWNER MANUAL
ENGLISH

Résumé du contenu de la page N° 2

Congratulations on the purchase of the this new Warwick amplifier. Please keep this new Warwick amplifier head/combo. instruction booklet handy in case you need to Please read these instructions through before consult it again. connecting and operating the device. If you keep to the guidelines set out in this manual, Please send the PASSPORT to the address you will soon be able to appreciate the quality of indicated therein. RECOMMENDATIONS The following recommendations are designed to objects p

Résumé du contenu de la page N° 3

FRONT PANEL CONTROLS INPUT socket to plug in a bass guitar. levels. Should the OL LED light up, reduce GAIN control + 3 LEDs to adjust the input level: OUTPUT of the respective channel. The standard CLIP too high, setting, i.e. with neither attenuation nor OK optimum, amplification, is position 8 (when tone controls are LOW too low. set linearly). LIMITER switch + 2-colored LED to compress CH. SELECT + two LEDs to switch from channel the signal (channel 2 only): 1 (red) to channel 2 (green). gre

Résumé du contenu de la page N° 4

CHANNEL 1 - TUBE This channel is equipped with two tubes. One MID boost and HIGH cut by shifting the preamp tube is always included within the signal resonance frequency with the TONE control flow. (12 o'clock until full clockwise position). This 2ND STAGE switch adds one output stage tube requires that the resonance frequency of your bass into the circuit. This feature offers the choice pickups lies beyond that of the desired simulation. between a so called hybrid amplifier (tube preamp Furthe

Résumé du contenu de la page N° 5

EXAMPLES Clean Funk Hard Funk Straight Rock Fat and ugly 2ND STAGE OFF 2ND STAGE ON 2ND STAGE ON 2ND STAGE ON TONE SEE PICTURE TONE SEE PICTURE TONE SEE PICTURE TONE SEE PICTURE CRUNCH SEE PICTURE CRUNCH SEE PICTURE CRUNCH SEE PICTURE CRUNCH SEE PICTURE CONTOUR ON CONTOUR ON CONTOUR OFF CONTOUR ON LOW FLAT LOW BOOST LOW BOOST LOW BOOST MID BOOST MID CUT MID FLAT MID BOOST HIGH FLAT HIGH BOOST HIGH FLAT HIGH CUT 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 C

Résumé du contenu de la page N° 6

CHANNEL 2 - SOLID STATE Two switches LOW BOOST and HIGH positive area (1) the OL LED of the master BOOST to pre-adjust the basic sound section might illuminate, which means you enter characteristics. the overload range before the master control. In Eight faders this case reduce OUTPUT from channel 2. If the 70/140/210/420/730/1.2k/2.5k/5kHz LIMITER is activated and threshold appears too to amplify/soften the respective frequency high, readjust the EQ curve to lower levels (2). band by +/-12 dB.

Résumé du contenu de la page N° 7

NOTES 22 Pro Tube IV

Résumé du contenu de la page N° 8

Sonic II / III Pro Fet IV Pro Tube IV Pro Tube IX Quad IV / VI Pro Fet III 25 mV 25 mV 25 mV 25 mV 25 mV 25 mV transistor, active transistor, active transistor, active transistor, active transistor, active all tube controlled controlled controlled controlled controlled none none none dual tube dual tube none fan cooled (non fan cooled fan cooled (non fan cooled (non fan cooled (non fan cooled (non permanent) permanent) permanent) permanent) permanent) (temperature controlled) bass, mid low, midb

Résumé du contenu de la page N° 9

CIRCUIT DIAGRAM 41 Pro Tube IV

Résumé du contenu de la page N° 10

Headquarters: Warwick GmbH&Co.Music Equipment KG•Gewerbegebiet Wohlhausen•08258 Markneukirchen/Germany•Tel 0049-(0)37422-555-0 Fax 0049-(0)37422-555-99 • Send us an E-Mail to: info@warwick.de • Visit us on the World Wide Web: http://www.warwick.de Branch China: Warwick Music Equipment (Shanghai) Ltd., Co.Shanghai Waigaoqiao Free Trade Zone • Shanghai 200131 / P.R.China