Instruction d'utilisation Knoll Systems GS12

Résumé du contenu de la page N° 1

GS8 GS12
GS8 and GS12 Eco-System™ Amplifier specifications:

Eco-System Power
Inputs: 8 or 12 gold RCA jacks with adjustable gain
Amplifiers
Input impedance: 50k ohms
Outputs: 5 way gold binding posts
Installation Instructions v1.2
Output power: 50 watts RMS per channel (8 ohms)

Peak output power: 100 watts per channel (8 ohms)
Warning: To be installed and/or used in accordance with
Ideal impedance: 4 – 8 ohms
appropriate electrical codes and regulations.
Frequency

Résumé du contenu de la page N° 2

Sound cuts out 1. Verify speaker impedance is 4-16 ohms. The eco-friendly choice Changing speakers may be required. 2. Check if the amp feels hot. If it's The Knoll GS8 and GS12 are class A/B amplifiers that produce hot, increase cooling - see 50 watts per channel at 8 ohms and 70 watts per channel at 4 Installation. ohms. While offering unparalleled reliability, power and sound quality the GS8 and GS12 offers a Knoll exclus

Résumé du contenu de la page N° 3

8. Make sure the speakers in each room are connected in phase Installation with the amplifier + going to the speaker +. Out of phase speakers give unstable imaging and poor bass response. Installing the amplifier should be relatively easy. With a bit of 9. Connect the AC power into an outlet than can supply at least planning, this amplifier will give trouble free service for years. six amps (750 watts) dedicated to each GS8 or GS12. 10. After the

Résumé du contenu de la page N° 4

Caution: NEVER connect the GS8 or GS12 to impedances GS12 Rear Panel less than 4 ohms or amplifier damage not covered by the warranty may occur. The Link button is normally set to the in position to give all six stereo inputs individual sources. When a channel Link button is set to the out position, that channel is The “SENS” pot controls the level threshold setting of the (Left/Right) linked or cascaded to input #1 (w