Résumé du contenu de la page N° 1
ZRX500.2 / ZRX1200.2
ZRX600.4 / ZRX1000.4 / ZRX2000.4
ZRX1000.1D / ZRX1500.1D / ZRX2000.1D / ZRX3000.1D
Résumé du contenu de la page N° 2
ZEUS HIGH PERFORMANCE AMPLIFIERS The Zeus ZRX Series products have been designed to a very high level of performance, with features unavailable in any other product. All of the amplifiers have variable crossovers built in, with added touches such as subsonic filter, bass equalization and a remote Level control module(some models) that allows subwoofer Level control from the drivers seat. To ensure years of listening pleasure, all amplifiers have a built in diagnostic mode that will detect sho
Résumé du contenu de la page N° 3
WIRE GAUGE GENERAL INSTALLATION PROCEDURE System Design The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher power systems are not necessarily useful purely for high sound pressure levels, but also to establish a headroom capability, to reproduce musical peaks cleanly without distortion. Lower power amplifiers w
Résumé du contenu de la page N° 4
AMPLIFIER FEATURE DESCRIPTIONS ZEUS ZRX AMPLIFIERS: Each model is capable of 4 & 2-Ohms stereo per channel, or 4-Ohms mono bridged operation except CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU the mono amps which are capable of 4, 2 and 1-Ohm loads. WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE WARRANTY PRINTED IN THE BACK OF THE MANUAL. 2 & 4 Channel amps are capable of 4 The input sensitivities for rated output powers are variable from 0
Résumé du contenu de la page N° 5
OUTPUT INPUT LEVEL BASS EQ X-OVER HPF LPF MODE OUTPUT INPUT LEVEL BASS EQ X-OVER HPF LPF MODE POWER POWER PROTECT PROTECT FULL HPF MONO FULL HPF MONO L L STEREO L L STEREO LPF LPF 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ R R R R ZRX500.2 / ZRX1200.2 2-CHANNEL AMPLIFIER APPLICATIONS FULL RANGE STEREO
Résumé du contenu de la page N° 6
CH 3 / 4 CH 1 / 2 CH 3 / 4 LINE OUT CH 3 / 4 CH 1 / 2 CH 3 / 4 LINE OUT LEVEL BASS EQ X-OVER HPF LPF LEVEL BASS EQ X-OVER HPF LPF POWER POWER PROTECT PROTECT FULL HPF FULL HPF R R LPF R R LPF 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ LEVEL BASS EQ X-OVER HPF LPF MODE LEVEL
Résumé du contenu de la page N° 7
CH 3 / 4 CH 3 / 4 CH 1 / 2 LINE OUT LEVEL BASS EQ X-OVER HPF LPF POWER PROTECT FULL HPF R R LPF 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ LEVEL BASS EQ X-OVER HPF LPF MODE OUTPUT INPUT LEVEL BASS EQ X-OVER HPF LPF MODE POWER FULL HPF 2 3 4 LPF L 6V 0.2V 0dB 12dB 60HZ 13KHZ 30HZ 250HZ L CH 1
Résumé du contenu de la page N° 8
OUTPUT INPUT LEVEL BASS EQ REMOTE SUBSONIC LOW PASS OUTPUT INPUT LEVEL BASS EQ REMOTE SUBSONIC LOW PASS POWER POWER PROTECT PROTECT L L L L 6V 0.2V 0dB 10dB 15HZ 35HZ 30HZ 250HZ 6V 0.2V 0dB 10dB 15HZ 35HZ 30HZ 250HZ R R R R ZRX1000.1D / ZRX2000.1D / ZRX3000.1D 1-CHANNEL AMPLIFIER APPLICATIONS Basic application These sub bass amplifiers can be used in any of the bi-amplification systems descri
Résumé du contenu de la page N° 9
7
Résumé du contenu de la page N° 10
SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE ZRX500.2 / ZRX1200.2 / ZRX600.4 / ZRX1000.4 / ZRX2000.4 General: At this point you are ready to get more specific on the settings for your amplifier. High Pass: -When in Hi Pass operation, this setting acts as a low frequency cut off for your system reproduction. The point that you set it at cuts off any frequencies from reproduction beyond this point. The 12 o’clock position is a great starting point. EXAMPLE: If you adjust the High Pa
Résumé du contenu de la page N° 11
TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the PROTECT system built into all Hifonics amplifiers The diagnostic system will shut down the amplifier, until reset by turning the head unit off, and back on. This state of affairs will be indicated by the front panel PROTECT LED lighting up under the following conditions: 1 - A sort circuit on the loudspeaker lea
Résumé du contenu de la page N° 12
Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase. Maxxsonics will repair or replace at it’s option and f
Résumé du contenu de la page N° 13
OEM Integration Accessories MX-1 Premium High To Low Level Converter MX-3 Bass Controller * Converts High Level OEM speaker wires to Ultra Clean RCA Low Level Outputs * High Level Inputs: Accepts all types of High level Inputs * Parametric Bass EQ: Provides a wide array of subwoofer output signal including floating ground and high voltages up to 30 volts. shaping controls to enhance bass response and sound quality including * Audio Signal Sense / Hardwire Turn-On: Audio sense detec
Résumé du contenu de la page N° 14
PART#: A811
