Résumé du contenu de la page N° 1
MICRO COMPONENT SYSTEM
SISTEMAS DE MICROCOMPONENTES
SISTEMA DE MICRO COMPONENTES
—Consists of CA-UXG1 and SP-UXG1
UX-G1
TIMER
TIMER SET ON/OFF STANDBY/ON
REPEAT RANDOM SLEEP
STANDBY/ON
REMAIN PROGRAM FM MODE
VOLUME
TAPE TUNER/ CD
BAND
CD
BEAT CUT
MICRO COMPONENT SYSTEM
DISPLAY/
CLOCK SET
SOUND/
VOLUME
MUTING BASS
REMOTE CONTROL
CD SYNCHRO RECORDING
OPEN
¡ATENCION!
Antes de operar su equipo, lea cuidadosamente este instructivo.
INSTRUCTIONS
MANUAL DE INSTRUCCIONES
INSTRUÇÕES
LVT1356-009A
[UW]
UX-
Résumé du contenu de la page N° 2
Warnings, Cautions and Others Avisos, precauciones y otras notas Advertências, precauções e outras notas CAUTION— STANDBY/ON button ! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The STANDBY/ON button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY lamp lights red. • When the unit is turned on, the STANDBY lamp goes off. The power can be remote controlled. PRECAUCIÓN—Botón STANDBY/ON ! Desconecte
Résumé du contenu de la page N° 3
CAUTION To reduce the risk of electrical shocks, fire, etc.: CAUTION 1. Do not remove screws, covers or cabinet. • Do not block the ventilation openings or holes. 2. Do not expose this appliance to rain or moisture. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) PRECAUCIÓN • Do not place any naked flame sources, such as lighted Para reducir riesgos de choques eléctricos, incendio, etc.: candles, on the apparatus. 1. No extra
Résumé du contenu de la page N° 4
CAUTION: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1Front: No obstructions and open spacing. 2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. 3 Bottom: Place on a level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. PRECAUCIÓN: Ventilación correcta Para evitar el riesgo de descargas eléctricas e incendio y preveni
Résumé du contenu de la page N° 5
IMPORTANT FOR LASER PRODUCTS IMPORTANTE PARA PRODUCTOS LÁSER 1. CLASS 1 LASER PRODUCT 1. PRODUCTO LÁSER CLASE 1 2. CAUTION: Do not open the top cover. There are no user 2. PRECAUCIÓN: No abra la tapa superior. En el interior de la serviceable parts inside the unit; leave all servicing to qualified unidad no hay piezas que pueda reparar el usuario; encargue el service personnel. servicio a personal técnico cualificado. 3. CAUTION: Visible and invisible laser radiation when open and 3. PRECAUCIÓN:
Résumé du contenu de la page N° 6
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual •When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord w
Résumé du contenu de la page N° 7
Contents Location of the Buttons and Controls ............................. 3 Main unit ................................................................................... 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 Unpacking ................................................................................. 6 Putting the Batteries into the Remote Control ..........
Résumé du contenu de la page N° 8
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view 1 OPEN 5 6 TIMER ON/OFF BAND MULTI SOUND 2 CONTROL /BASS TAPE TUNER CD 7 PHONES CD CONTROL 3 4 8 Front view 9 STANDBY/ON VOLUME p e STANDBY MICRO COMPONENT SYSTEM q r UX-G1 w CD SYNCHRO RECORDING OPEN t Inside the front cover y 3 UX-G1[UW]_03name_1.p65 3 05.4.11, 4:37 PM English
Résumé du contenu de la page N° 9
Continued Display window on the front panel 12 3 4 56 7 ON OFF SLEEP ST MONO SOUND BASS SYNC MHz kHz MP3 1ALL PRGM RAND TOTAL REMAIN 89q p w e r t See pages in parentheses for details. Main unit Display window 1 Disc cover (12) 1 (timer) indicator 2 PHONES jack (9) 2 ON/OFF (timer on-time/off-time) indicators 3 TIMER ON/OFF button (19) 3 SLEEP indicator 4 SOUND/BASS button (9) 4 FM mode indicators 5 0 OPEN (disc cover open) (12, 13) • ST (stereo), MONO 6 Source buttons 5 SOUND indicator • TAPE,
Résumé du contenu de la page N° 10
Remote Control See pages in parentheses for details. 1 TIMER SET button (18, 19) 2 REPEAT button (14) 3 RANDOM button (14) 4 REMAIN button (14) 5 BEAT CUT button (10, 16) 6 DISPLAY/CLOCK SET button (8) TIMER TIMER SET ON/OFF STANDBY/ON 7 MUTING button (9) 9 1 8 SOUND/BASS button (9) p 9 STANDBY/ON button (8, 19) REPEAT RANDOM SLEEP 2 q p TIMER ON/OFF button (19) 3 w q SLEEP button (19) REMAIN PROGRAM FM MODE w PROGRAM button (8, 11, 13, 18) 4 e TUNER/ e FM MODE button (10) TAPE CD BAND r Source
Résumé du contenu de la page N° 11
Getting Started Continued Connections Unpacking After unpacking, check to be sure that you have all the To connect speakers following items. You can connect the speakers using the speaker cords. The number in parentheses indicates the quantity of each piece supplied. • AM loop antenna (1) 1 2,3 • Remote control (1) • Batteries (2) •AC plug adaptor (1) If any item is missing, consult your dealer immediately. SPEAKER Putting the Batteries into the Remote Control IMPEDANCE 4-16Ω Red Insert the b
Résumé du contenu de la page N° 12
FM ANTENNA AM LOOP To connect AM and FM antennas Adjusting the Voltage Selector Before plugging in the unit, set the correct voltage for your area with the voltage selector on the bottom of the unit. FM antenna VOLTAGE 2 SELECTOR AC 220 - 240V 1 AC 110 - 127V Use a screwdriver to move the voltage selector so the voltage number is the same as the voltage where you are plugging in the unit. (See the back cover page.) • DO NOT plug in before setting the voltage selector on the bottom of the unit a
Résumé du contenu de la page N° 13
Basic and Common Operations Continued To show the clock when the unit is turned on Setting the Clock On the remote control ONLY: Before operating the unit any further, first set the unit’s clock. DISPLAY/ When you plug in the power cord, “0:00” starts flashing on Press DISPLAY/CLOCK SET. CLOCK SET the display. • Each time you press the button, the display You can set the clock when the unit is either turned on or in changes the clock indication and the normal standby mode. indication alternatel
Résumé du contenu de la page N° 14
Adjusting the Volume Selecting the Sound Modes You can adjust the volume level only while the unit is turned You can select one of the 4 sound modes. on. The volume level can be adjusted between “VOL MIN,” •This function also affects the sound from headphones. “VOL 1” – “VOL 39,” and “VOL MAX.” •This function only affects the playback sound, and does not •The volume level has no effect on recording. affect your recording. SOUND/ To increase the volume, press VOLUME +. To select the sound modes,
Résumé du contenu de la page N° 15
Listening to FM and AM Broadcasts Continued 2 Press and hold ¢ or 4 Setting the Tuner Interval Spacing (or ¡/¢ or 4/1 on You can select 10 kHz or 9 kHz apart for the AM tuner the unit) for more than 1 interval spacing and 100 kHz or 50 kHz apart for the FM second. tuner interval spacing. • ¢ (¡/¢): Increases the frequencies. •You need to do this setting separately for each band. • 4 (4/1): Decreases the frequencies. On the unit ONLY: The unit starts searching for stations and stops when a stati
Résumé du contenu de la page N° 16
Presetting Stations Tuning in to a Preset Station You can preset 30 FM and 10 AM stations manually. On the remote control ONLY: In some cases, test frequencies have been already stored TUNER/ 1 Press TUNER/BAND to select either BAND for the tuner since the factory examined the tuner preset “FM” or “AM.” function before shipment. This is not a malfunction. You The unit automatically turns on and tunes in to can preset the stations you want into memory by following the previously received station—
Résumé du contenu de la page N° 17
Playing Back Discs Continued This unit has been designed to play back the following Playing Back the Entire Disc—Normal Play discs—CD, CD-R, and CD-RW. When playing a CD-R or CD-RW 1 Press 0 OPEN on the unit. User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- The disc cover opens. ReWritable) can be played only if they are already •You can insert a disc while listening to another source. “finalized.” • Usually you can play back your original CD-Rs or CD- 2 Place a disc correctly with its label s
Résumé du contenu de la page N° 18
To stop playing, press 7. Programming the Track Playing Order—Program Play You can arrange the order in which tracks play before you start playing. You can program up to 60 tracks. To remove the disc, press 0 OPEN on the unit. On the remote control ONLY: 1 Place a disc. • If the current source is not the CD player, press CD. • If the disc cannot be read correctly (because it is scratched, for example) or an unreadable CD-R or CD-RW is inserted 2 Press PROGRAM. Playback will not start. PROGRAM Th
Résumé du contenu de la page N° 19
When playing back MP3 disc: Playing at Random—Random Play ALL GR. You can play the tracks at random. 1 Canceled On the remote control ONLY: ALL: In Normal Play, repeats all the tracks. RANDOM Press RANDOM before or during playing. In Program Play, repeats all the tracks in the The RAND and indicators light up on the display. program. GR.: In Normal Play, repeats all the tracks in a group. In Program Play and Random Play, this function is not available. To stop playing, press 7. 1: Repeats one
Résumé du contenu de la page N° 20
Playing Back Tapes For Tape operations, use buttons inside the front cover on the 4 Close the cassette holder gently. unit. Playing Back a Tape You can play back type I tapes only. On the unit ONLY: 1 Open the front cover. 5 Press TAPE. TAPE The unit automatically turns on and the source changes to the tape deck. •You can select to the tape by pressing TAPE on the remote control. 6 Press # (play). The tape starts playing. • When the end of the tape is reached, playing 2 Press &/) (stop/cassette
