Instruction d'utilisation Altec Lansing 2100

Résumé du contenu de la page N° 1

User's guide
Mode d’emploi
Guía del usuario
Guia do Usuário


Résumé du contenu de la page N° 2

Rear View Volume Down Volume Up Power On Indicator Power On/Off 1

Résumé du contenu de la page N° 3

The lightning flash with arrowhead, within an Caution: To prevent the risk of electric shock, do The exclamation point within an equilateral equilateral triangle, is intended to alert the user to not remove cover (or back). No user- serviceable triangle is intended to alert the user to the presence the presence of uninsulated “dangerous voltage” parts inside. Refer servicing to qualified service of important operating and maintenance within the product’s enclosure that may be of personnel. (serv

Résumé du contenu de la page N° 4

4. Turn off the audio source device (computer, portable music system, INTRODUCTION etc.). Shut computer systems down using the manufacturer's recommended procedures. Welcome to the extraordinary world of Altec Lansing high fidelity sound. 5. Connect the 6.5 ft. (5m) cable with lime green 3.5 mm stereo plugs on each end into the jack labeled FRONT on the Subwoofer and the other to the 3.5 mm output jack on your audio source. The 2100 is an amplified multimedia speaker system delivering cutting

Résumé du contenu de la page N° 5

SPECIFICATIONS TOTAL AUDIO POWER: 50 Watts (26 Watts RMS) POWER REQUIREMENTS Frequency Response: 40 Hz - 20 kHz USA/Canada/and applicable 120v 60Hz AC Inputs: Front Latin American countries: Signal to Noise Ratio @ 1 kHz input: >65 dB System THD (distortion): < 0.5 % THD @ -10dB full Europe/United Kingdom; 230v 50Hz AC scaleinput voltage applicable Asian countries; SATELLITE AMPLIFIED SPEAKERS Argentina, Chile and Uruguay: Speaker Drivers (per Satellite): Two 1" (28 mm) micro drivers ETL / cETL

Résumé du contenu de la page N° 6

TROUBLESHOOTING TIPS SYMPTOM POSSIBLE PROBLEM SOLUTION All LEDs Power is not turned on Press Power On button on the System Controller. are unlit AC cord is not connected to wall outlet Verify the AC line cord from the back of the Subwoofer is plugged into the wall outlet. Surge suppressor (if used) is not powered on If the AC line cord is plugged into a surge suppressor, make sure the surge suppressor is switched on. System Controller is not connected to the Subwoofer Connect System Controller

Résumé du contenu de la page N° 7

ONE YEAR LIMITED WARRANTY Altec Lansing Technologies, Inc. warrants to the end user that all of its computer speaker systems are free from defects in material and workmanship in the course of normal and reasonable use for a term of one year from the date of purchase. This warranty is the exclusive and only warranty in effect relative to Altec Lansing computer speaker systems and any other warranties, either expressed or implied, are invalid. Neither Altec Lansing Technologies, Inc. nor any autho