Instruction d'utilisation RBH Sound WM-30

Résumé du contenu de la page N° 1

M SERIES ON-WALL SPEAKERS
WM-24 and WM-30
O w n e r s M a n u a l

Résumé du contenu de la page N° 2

Résumé du contenu de la page N° 3

Introduction Congratulations on your purchase of an RBH Sound M Series WM-24 or WM-30 on- wall speaker! Your speaker is the result of many years of research and development dedicated to producing high quality products for home audio and audio systems. This manual contains features, setup recommendations and specifications for the M Series WM-24 and WM-30 wall-mount speaker. It is recommend you thoroughly read through the material contained in this manual before connecting your speakers. This

Résumé du contenu de la page N° 4

Care and Cleaning To maintain speaker appearance, we recommend wiping them down with a clean damp soft cloth. To clean dust from the grille cloth, use a vacuum with a brush attachment. Features At the heart of the M Series speakers are proprietary aluminum woofers and midrange drivers. This special aluminum cone material combines stiffness, low mass and self- damping properties to allow uncolored presentation of the program material. A powerful magnet, extended voice coil and bumped back plate

Résumé du contenu de la page N° 5

System Setup In order to extract the best possible sound from your speaker system, it is important to determine where the speakers will sound best in your listening room. Room reflections from the floor, ceiling and side walls influence the balance, imaging and overall sonic quality at the listening position. Experiment with speaker placement to determine which location offers the best overall sound. As a general guide, use the room layout diagram on the next page and the following descrip

Résumé du contenu de la page N° 6

System Setup (continued) 4

Résumé du contenu de la page N° 7

Mounting Bracket Using the enclosed template, mark your desired speaker location. NOTE: the bracket is offset to allow for the slide mount of the speaker onto the bracket. The offset allows the speaker to be centered when mounting is complete. If mounting in a stud-less drywall location, use the enclosed self-tapping drywall augers and screws. Start the auger in the drywall location with a few slight taps from a hammer, then screw down snugly with a screwdriver. To mount the bracket, h

Résumé du contenu de la page N° 8

Speaker Mounting To mount the speaker to the bracket, screw the supplied mounting knobs into the holes shown below (screw mounts), then tighten with a flat blade screwdriver. Attach the speaker wire observing polarity, and then fit the mounting knobs into the speaker mount opening of the bracket (shown in the illustration on the previous page. The speaker will mount centered when the mounting knobs are slid into place on the bracket in the direction shown by the arrows in the illustration b

Résumé du contenu de la page N° 9

S p e ci fi c a t i o n s Model WM-24 WM-30 Frequency 50Hz-20kHz ±3dB 45Hz-20kHz ±3dB Response: 90dB 90dB Sensitivity: Recommended/ 75-120 Watts 75-120 Watts Rated Power: Woofer(s): (2) 4” Active Aluminum Cone (2) 4” Active Aluminum Cone (2) 4” Passive Aluminum Cone (2) 4” Passive Aluminum Cone Tweeter: (1) 1” Fabric Dome (1) 1” Fabric Dome 6 Ohms 6 Ohms Impedance: Crossover 3000 Hz 3000 Hz Frequencies: Finish: Black Brushed Aluminum Black Brushed Aluminum Grille: Black or Silver Cloth Black or

Résumé du contenu de la page N° 10

Troubleshooting Situation: Probable Cause: Solution: No sound from speakers Speaker wire not Make sure wire is connected connected at both the speaker and the amplifier observing proper polarity Speaker selector on Activate proper selector amplifier is not on on amplifier No sound from speaker Balance control on Place balance control in receiver or pre-amp is the center not centered Speaker wire not securely Check all connections at connected amplifier and speakers Very little bass a

Résumé du contenu de la page N° 11

Résumé du contenu de la page N° 12

TM Redefining The Way You Experience Sound. 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (800) 543-2205 • Fax: (801) 543-3300 www.rbhsound.com It is RBH Sound policy to continuously incorporate improvements into our products; all specifications are subject to change without notice. Copyright © 2007 RBH Sound. All Rights Reserved.