Instruction d'utilisation NEC Express 320Fc Systems

Résumé du contenu de la page N° 1

Read Me First: Unpacking
Express5800/320Fc Systems
NEC Corporation of America
456-01722-000

Résumé du contenu de la page N° 2

Notice The information contained in this document is subject to change without notice. UNLESS EXPRESSLY SET FORTH IN A WRITTEN AGREEMENT SIGNED BY AN AUTHORIZED REPRESENTATIVE OF NEC, NEC MAKES NO WARRANTY OR REPRESENTATION OF ANY KIND WITH RESPECT TO THE INFORMATION CONTAINED HEREIN, INCLUDING WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PURPOSE. NEC assumes no responsibility or obligation of any kind for any errors contained herein or in connection with the furnishing, performance, or u

Résumé du contenu de la page N° 3

Contents Introduction 1 Before Unpacking the System 4 Unpacking the System 4 Disposing of Packing Materials 6 What to Do Next 6 -iii-

Résumé du contenu de la page N° 4

-iv-

Résumé du contenu de la page N° 5

Introduction Read Me First: Unpacking Express5800/320Fc Systems explains how to unpack a system from its shipping box. WARNING ! To avoid eye and skin injuries, be careful when cutting the shipping straps from the shipping box. The straps can snap with considerable force when cut. WARNING ! To avoid back injury, do not attempt to remove an enclosure before you remove the shipping box from the shipping pallet. When the shipping box is removed, lift and remove each enclosure with the a

Résumé du contenu de la page N° 6

Figure 1 shows the packaged components, and the order in which to remove them, for a rack-mounted system. Figure 2 shows the packaged components, and the order in which to remove them, for a pedestal system. Figure 1. Unpacking a Rack-Mounted System 1 2 3 4 5 asys072 1 Accessories box 2 Shipping box 3 Shelf unit 4 and 5 CPU-I/O enclosures -2-

Résumé du contenu de la page N° 7

Figure 2. Unpacking a Pedestal System 1 2 3 4 5 asys073 1 Pedestal case 2 Accessories box 3 Shipping box 4 and 5 CPU-I/O enclosures -3-

Résumé du contenu de la page N° 8

Before Unpacking the System • Check the label or the packing slip on the outside of the shipping box to verify that you received the correct shipment. Depending on your order, you have received either a rack-mountable system or a pedestal system. • Verify that the Tip-N-Tell and Shockwatch indicators on the outer sides of the shipping box are not activated. CAUTION ! Do not unpack the system if you did not receive the correct shipment, or if an indicator on the shipping box is activated. Co

Résumé du contenu de la page N° 9

3. Open the top cardboard flaps of the shipping box by cutting through the taped portion of the flaps to release them. 4. If you have received a pedestal system, remove the pedestal case, place it on a table or other sturdy surface, and remove its foam packaging material. WARNING ! To avoid back injury, lift and remove the pedestal case with the assistance of another person. 5. Remove the accessories box. Open the accessories box and make sure that it contains (along with other items) the

Résumé du contenu de la page N° 10

8. Remove each CPU-I/O enclosure, one at a time, from the shipping pallet. Pull the foam blocks away from the first enclosure and remove it. Then, do the same for the second enclosure. WARNING ! To avoid back injury, lift and remove each enclosure with the assistance of another person. 9. Remove the enclosures from their plastic bags, then place the enclosures flat on a table or other sturdy work surface near the installation area. Disposing of Packing Materials The packing materials do n