Résumé du contenu de la page N° 1
ED200
INSTRUCTION
MANUAL
Résumé du contenu de la page N° 2
Important Safeguards ?Read all of these instructions. ?Save these instructions for later use. ?All warnings on the products and in the operating instructions should be adhered to. ?Unplug this appliance system from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners, use a damp cloth for cleaning. ?Do not use attachments not recommended by the appliance manufacturer as they may cause hazards. ?Do not use this appliance near water, for example, near a bathtub, was
Résumé du contenu de la page N° 3
?Follow all warnings and instructions marked on the appliance. ?Do not overload wall outlets and extension cords as this can result in fire or electric shock. ?Never push objects of any kind into his appliance through cabinet slots as they mat touch dangerous voltage points or short out parts that could result in fire or electric shock. ?Do not place this appliance on an unstable cart, stand,or table. ?The appliance may fall, causing serious injury to a child or adult, and serious damage to
Résumé du contenu de la page N° 4
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER ( OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERRSONNEL. The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of non-insulated ”dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol
Résumé du contenu de la page N° 5
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If t
Résumé du contenu de la page N° 6
I. General The ED200 Series Camera is a compact, full functioned CCD Camera. Their stylish appearance can be applied as per installer's ideal locations. These dome cameras can be mounted either on the ceiling or on the wall easily. ED200 uses high sensitive 1/3" color interline transfer CCD sensor with DSP. The sensor is featured with Auto Electronic Shutter, Automatic Gain Control, and Auto White Balance function. II. Precautions • Do not expose the camera to humidity and dust. Out
Résumé du contenu de la page N° 7
III. Lens Available * Standard board lens f=3.6 mm, F=2.0 mm. * Other available lens : -2 Lens f=2.5 mm, F=2.0 mm -4 Lens f=4.3 mm, F=2.0 mm -6 Lens f=6.0 mm, F=2.0 mm -8 Lens f=8.0 mm, F=2.0 mm -3P Pinhole lens f=3.7 mm, F=3.0 mm IV. Installation Instructions 1. Remove the plastic dome cover. 2. Loosen the two screws of the supporting bracket to remove the camera body. 3. Using four screws to fix the camera base on the ceiling. 4. Put the camera body back to the supporting
Résumé du contenu de la page N° 8
a. Floor Mount b. Ceiling Mount d. Wall mount, c. Wall mount, aim to the left aim to the right 5. Connect the BNC connector of the camera to a color monitor, or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension. 7
Résumé du contenu de la page N° 9
6. Connect the DC +12V regulated power source of the camera (DC Jack) to the DC 12V Power- in jack with 2 mm, center+, outer- plug. 7. Once the image appears on the monitor, loosen the fixing screw located at the lens mount then adjust the focus and diaphragm of the lens to obtain the best picture. When the ideal picture is obtained, secure the lens mount by fixing screw firmly again. 8. Put the plastic cover back on the Dome Camera. 8
Résumé du contenu de la page N° 10
V. Specifications Pickup device: 1/3“ interline transfer CCD Picture element: 510 x 492 (NTSC) 500 x 582 (PAL) Horizontal resolution: 380 TV Lines Sensitivity: 0.3 Lux/F=1.2 S/N ratio: Over 48 dB Electronic shutter: Up to 1/100,000 Auto white balance: Yes Gamma correction: 0.45 Video output: 1.0Vp -p, 75 ohm Power source: 12V DC ? 10% Sync. Mode: Internal Sync. Lens mount: M12 x P0.5 Dimension: 106 mm (D) x 85 mm (H) Operating temperature:-10 C to +50 C Power consumption: 3W
Résumé du contenu de la page N° 11
VI. Package Contents • ED200 Camera unit • User’s manual 10
Résumé du contenu de la page N° 12
EverFocus Electronics Corp. Head Office: China Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Room 609, Technology Trade Building, Hsi-Chih, Taipei, Taiwan Shandgdi Information Industry Base, TEL: +886-2-26982334 FAX: +886-2-26982380 Haidian District, Beijing,China www.everfocus.com.tw TEL: +86-10-62971096 FAX: +86- 10-62971432 USA Office: www.everfocus.com.cn 1801 Highland Ave. Unit A Duarte, CA 91010, U.S.A. Japan Office: TEL: +1-626-844- 8888 FAX: +1-626-844-8838 1809 WBG MARIBU East 18F, www.ev
