Instruction d'utilisation Stiga PARK 121 M

Résumé du contenu de la page N° 1

STIGA PARK
121 M
8211-3011-09

Résumé du contenu de la page N° 2

D 5b. 1. Park -1993 5a. 6b. Park 2000- 2. Park -1993 6a. Park -1999 F G H 3. Park -1993 7. I I 4. Park -1993 8. 2

Résumé du contenu de la page N° 3

J 9. 13. 10. 14. Z X Y V W 11. 15. Denna produkt, eller delar därav, omfattas av följande mönsterskydd: This product, or part of it, is covered by the following design registration: Sverige/Sweden 62 435 Tyskland/Germany M97 07 997.9 (pending) 12. 3

Résumé du contenu de la page N° 4

4

Résumé du contenu de la page N° 5

GB ENGLISH 4. Install the spring in the new hole (fig. 4). SYMBOLS The following symbols can be found on the INSTALLATION machine to remind you of the care and attention that are required during use. CUTTING DECK The symbols mean: 1. Screw the cutting deck into the deck mounts D Warning! (fig. 5a). Read the instruction manual and the safety manual before using the machine. 2. Attach the lift spring to the implement lifter (fig. 5b). Warning! 3. Install the lifting cylinder in the front lifting a

Résumé du contenu de la page N° 6

GB ENGLISH 6. Fold up the deck until it is upright on the rear USE support plates (fig. 11). CLEANING CUTTING HEIGHT After each use, the underside of the cutting deck The cutting height can be varied from 30 to 80 mm. should be rinsed off. - item no. 13-2915 has seventeen fixed positions If the grass has dried solid, scrape clean the for cutting height. - item no. 13-2921 has continuously variable underside. adjustment of cutting height. If necessary, paint the underside to prevent Note: Stated

Résumé du contenu de la page N° 7

GB ENGLISH Always check the blades after a collision. If the blade system has been damaged, defective parts should be replaced. Always use original spare parts. Non- original spare parts can entail a risk of injury, even if they fit the machine. The cutting system comprises three blade bars with two replaceable blades Y (fig. 15). When replacing blades, both should be replaced to avoid imbalance. Install the new blades. Tighten screws V and W properly. Tightening torque: V - 9.8 Nm, W - 24 Nm. I

Résumé du contenu de la page N° 8

MO WI NG A H E A D BOX 1006 · SE-573 28 TRANÅS www.stiga.com